References
1_Maruo H et al: 'Bridging transfer phenomena of conductive pendent drop'. Quart J JWS 1992 10-2 251–258.
2_Ushio M and Mao W: 'An analysis of the dynamic characteristics of the arc sensor for DC MIG/MAG welding in open arc mode'. Quart J JWS 1996 14-1 108–115.
3_Sugitani Y and Mao W: 'Automatic simultaneous control of bead height and back bead shape utilising arc sensor in one side welding with backing plate'. Quart J JWS 1994 12-4 468–476.
4_Halmoy E: 'Wire melting rate, droplet temperature and effective anode heating potential'. The Welding Institute Int. Conf. Arc Physics and Weld Pool Behaviour London 1979 49–59.
5_Technical Commission on Physics of Welding, JWS: 'Pulsed arc welding'. 1986.
6_Oshima K et al: 'Sampled-data control of arc length in MIG pulsed arc welding'. J JWS 1982 51-8 700–707.
7_Hasegawa: 'Fundamental control theory [1]'. Shoko-Do.
8_Nakamura T and Hiraoka K: 'Characteristics of bead formation phenomena in narrower gap welding and proposal of new welding process at ultra-narrow gap joint'. Quart J JWS 2001 19-1 44–53.
9_Rumelhart D E et al: 'Learning internal representations by error propagation'. Parallel Data Processing The M.I.T. Press 1986 1 318–362.
10_Oshima K et al: 'Effect of power source characteristic on stability and self-regulation of welding arc'. Trans. IEE of Japan 1981 101-A-1 7–14.
Rights and permissions
About this article
Cite this article
Yamamoto, H., Takano, Y., Eguchi, K. et al. 'Estimation of arc length and wire extension using neural network'. Welding International 17, 357–364 (2003). https://doi.org/10.1533/wint.2003.3116
Issue Date:
DOI: https://doi.org/10.1533/wint.2003.3116