Abstract
Photoacoustic spectroscopy (PAS) has proved to be an effective technique for the evaluation of the inherent defect population in a wide range of materials for various applications. This paper demonstrates the use of this technique in transmission mode, and hence, evaluates the optical properties of flash-evaporated CuIn0.75Ga0.25Se2 (CIGS) thin films. Both the photoacoustic and transmission spectra were recorded at room temperature using high-resolution near-IR of the gas-microphone-type PAS, which revealed a very broad transmission region (about 300 meV) near the fundamental band edge in the as-grown CIGS thin films due to the presence of several shallow defect levels. The postdeposition heat treatment of the samples under Se ambient, followed by annealing under inert and forming gas ambient, showed significant changes in the behavior of the PAS spectra, particularly near the fundamental band edge. The absorption coefficient has been derived from these spectra to determine the energy band gap values and the activation energies for several defect related energy levels. Using PAS, the energy band gap values were in the range of 1.197 to 1.202 eV. The optical transmission spectra were also recorded from the routinely used spectrophotometer. The transmission data was used to determine the energy band-gap values, which were calculated to be in the range from 1.159 to 1.194 eV. These values were found to be in good agreement with each other, as well as with values reported in the literature.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
K. Ramanathan, M.A. Contreras, C.L. Perkins, S. Asher, F.S. Hasoon, J. Keane, D. Young, M. Romero, W. Metzger, R. Noufi, et al., Properties of 19.2% Efficiency ZnO/CdS/CuInGaSe2 Thin-Film Solar Cells, Prog. Photovolt., 2003, 11, p 225–230
J. Manifacier, J. Gasiot, and J. Fillard, A Simple Method for the Determination of Optical Constants n, k, and the Thickness of Weakley Absorbing Thin Film, J. Phys E: Sci. Instr., 1976, 9, p 1002–1004
R. Swanepoel, Determination of Surface Roughness and Optical Constants of Inhomogeneous Amorphous Silicon Films, J. Phys. E: Sci. Instr., 1984, 17, p 896–903
A. Rosencwaig, Ed., Photoacoustic & Photoacoustic Spectroscopy, John Wiley & Sons, New York 1980
E. Ahmed A. Zegadi, A.E. Hill, R.D. Pilkington, and R.D. Tomlinson, Optical Properties of Flash Evaporated CuIn0.75Ga0.25Se2 Thin Films, Thin Solid Films, 1995, 268, p 144–151
E. Ahmed, A.E. Hill, R.D. Pilkington, and R.D. Tomlinson, Growth and Annealing of CuIn0.75Ga0.25Se2 Thin Films, J. Phys. D: Appl. Phys., 1993, 26, p 1787–1792
E. Ahmed, “Growth and Characterization of Cu(In,Ga)Se2 Thin Films for Solar Cell Applications,” Ph.D. thesis, University of Salford, U.K. 1995
I.E. Elfallal, “ITO Thins Films Using E-Beam Evaporation,” Ph.D. thesis, University of Salford, U.K. 1993
E. Ahmed, A. Zegadi, A.E. Hill, R.D. Pilkington, and R.D. Tomlinson, The Influence of Annealing Processes on the Structural, Compositional and Electro-Optical Properties of CuIn0.75Ga0.25Se2 Thin Films, J. Mater. Sci.: Mater. Electron., 1996, 7, p 213–219
E. Ahmed, A. Zegadi, A.E. Hill, R.D. Pilkington, R.D. Tomlinson, and W. Ahmed, “Thermal Annealing of Flash Evaporated Cu(In,Ga)Se2 Thin Films, J. Mater. Process. Technol., 1998, 77, p 260–265
A. Zegadi, M.A. Slifkin, M. Djamin, R.D. Tomlinson, and H. Neumann, Photoacoustic Spectroscopy of Defect States in CuInSe2 Single Crystals, Solid State Commun., 1992, 83, p 587–591
K.L. Chopra, Ed., Thin Film Phenomena, Krieger, New York, 1979
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Ahmed, E., Ahmed, W., Pilkington, R.D. et al. Transmission photoacoustic spectroscopy analysis of CuIn0.75Ga0.25Se2 thin films. J. of Materi Eng and Perform 15, 208–212 (2006). https://doi.org/10.1361/105994906X95896
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1361/105994906X95896