Structural effect of polyester SCY knitted fabric on fabric size, stretch properties, and clothing pressure
- 2k Downloads
This study facilitates an effective design and development of various high stretch compression products by analyzing fabric size, stretch properties, and clothing pressure for various knit structures. Four types of fabrics were knitted with polyester SCY (Single Covered Yarn). Then fabric size including weight and thickness, stretch properties (stretch, elastic recovery), and clothing pressure were then measured, to analyze their interrelation. A comparison of fabric size indicated that yarn floating caused reduction in both course and wale-wise specimens; in addition, yarn overlapping caused a release in course-wise and shrinkage in wale–wise due to tuck. The high density caused by shrinkage in the course-wise due to yarn floating rather than overlapping influenced the weight and thickness of knitted fabrics. Yarn floating reduced course-wise elasticity and increased wale-wise elasticity in the fabric stretch test; however, yarn overlapping reduced elasticity in both directions. The elastic recovery analysis indicated that the recovery value gap among four specimens decreased over time. In comparison clothing pressure, ‘plain-float’ fabric showed higher clothing pressure than ‘plain’, while the pressure value of ‘plain-tuck’ was similar to ‘plain’. Dimensional change in course-wise had a greater effect on clothing pressure than in wale-wise in the correlation among fabric size, stretch properties and clothing pressure. Weight and thickness change exerted a strong influence on clothing pressure which vertically presses down the body. The clothing pressure value of knitted specimen having a lower stretch ratio was higher in course-wise.
KeywordsClothing pressure Compression garment Stretch properties SCY (single covered yarn)
Garment pressure is an essential component of clothing comfort (Yamada and Matsuo 2009). An appropriate clothing pressure maximizes the efficiency of physical exercise and heals hypertrophic skin burn scars. The degree of clothing pressure depends on material, design, wearing type, and physical features; in addition, stretch properties represents a significant mechanical property of clothing material that influences clothing pressure. Stretch properties are measured as the percentage of fabric stretch and fabric growth, recovery.
Lyle (1977) indicated two types of stretch fabric: comfort stretch (25–30 %) and power stretch (30–50 %). Stretch fabrics are specifically used in the design of active sports clothing, swimsuits, and athletic clothing. In some current uses, power stretch fabrics are required to have higher extensibility and quicker recovery. Compression therapy utilizes medical compression garments and functional body shaping underwear design that are made with high stretch fabric.
Fabric elasticity depends on fiber extendibility as well as structure. An interlooped structure provides knitted fabric a better elasticity than woven fabric. A loop pulled horizontally in knitted fabrics extends by the whole length; however, a loop pulled vertically extends by half its length (Brackenbury 1992). Human skin can be extensible from 20 to 200 % due to physical movement. Therefore, it is possible to develop compression products which can exert the exact required pressure on the body utilizing the elasticity of knitted fabric. However, an appropriate structure should be selected, arranged and used for specific body parts when designing compression products because different knit structures show different stretch properties even in the same fabric.
Many research performance studies have analyzed clothing and material stretch properties. For example: garment patterns using knitted fabrics (Heo 2003; Kim and Suh 2005; Kim et al. 2012; Oh 2010), the relationship between mechanical properties of material and clothing pressure (Anand et al. 2013; Jeong 2008; Jung and Ryu 2002; Rhie 1992), and the effect of clothing pressure on the body (Baek and Choi 2007; Bruniaux and Lun 2012; Lee 2005). However, there has been limited research on the relationship between structural characteristics of high stretch knitted fabric and clothing pressure. High stretch knitted fabric is often used as a material for the compression garments because compression garments should fit very tightly to apply a firm and even pressure on skin. The pressure level of high stretch knitted fabric depends on knit structure, yarn composition, and knitting type; however, little is known about the correlation of fabric size, stretch properties, and clothing pressure of high stretch knitted fabric (Sang and Park 2011).
Previous research reviewed the type of knit structure and characteristics of commercially available compression garments (Sang and Park 2013). Knit structures were also classified into four groups in terms of three primary knit loops in previous research (Sang and Park 2013). This study now facilitates the design of high stretch compression garments and the development of various products by analyzing dimension features, stretch properties, and correlation of clothing pressure for high stretch knitted fabric to offer a proper knit structure appropriate for the demands of phased compression.
Knitting structure selection
Four kinds of knitted fabrics, (P, PF, PT, and PFT), were used as test specimens. They were basic knit stitches in four groups classified in previous research. Specimen ‘P’ was knitted using plain (or knit) technique only. Specimen ‘PF’ and ‘PT’ were knitted using float (or miss) and tuck respectively on a plain structure. Specimen ‘PFT’ was knitted using float and tuck technique on a plain structure.
Specimen size and making
Characteristics of yarn in specimen
Doubling and twisting condition
Polyurethane 40 D
Polyester 75 D/36 F
Specimens were conditioned in a standard atmosphere of 20 ± °C and 65 ± 2 % R.H. for at least 48 h without rinsing and were taken by KS K 0105:2011 standard for testing. Length in the wale and course direction of specimen were measured by KS K ISO 22198:2014 standard; subsequently, thickness and weight test method followed KS K ISO 5084:2011 and KS K ISO 0642:2013 standard.
Stretch properties test
ASTM D 2594-2004 (2008) standard test method for stretch properties of knitted fabric was applied under the form-fitting stretch percentage points to test the stretch and elastic recovery of specimens,
Clothing pressure test
Results and discussion
Correlation with clothing pressure, fabric size and stretch properties
Figure 3 shows the clothing pressure and the size of knitted specimen; in addition, a reduced size led to a consistently higher course-wise clothing pressure. A similar trend was also found in correlation with clothing pressure and stretch of knitted specimen (Fig. 6). The observed clothing pressure value of knitted specimen having lower stretch ratio was also higher course-wise; however, there was no significant tendency between clothing pressure and stretch ratio in wale-wise.
The correlation with clothing pressure and elastic recovery ratio (Fig. 7a, b) indicated no distinct difference recovery ratio among knit structures compared to clothing pressure value. Further research with a higher stretch knitted fabric than used this study should be used to define the relationship between clothing pressure and the elastic recovery of high stretch knitted fabric.
Garment pressure is related to the clothing material’s interaction with the body, and is based on how material stretches and recovers vis-a-vis fabric structure. This study compared the size and stretch properties of high stretch knitted fabric with different structures and analyzed the correlation with clothing pressure.
Miss of yarn caused shrinkage in both course and wale-wise of knitted samples due to drawn closer together yarns by the floats. Yarn overlapping caused release in course-wise and shrinkage in wale-wise due to tuck. High density caused by shrinkage in the course-wise due to floating of yarn rather than overlapping had a greater effect on the weight and thickness of knitted fabrics.
Miss of yarn reduced course-wise elasticity and increased wale-wise elasticity of high stretch knitted fabrics; however, overlapping of yarn reduced elasticity in both directions. In elastic recovery, the gap of recovery value among knitted specimens was lower at 1 h than at 60 s with no significant recovery value change. Accordingly, the size change by knit structure influenced stretch properties.
Clothing pressure measurement by knit structure indicated that the clothing pressure value of ‘PF’ was higher than 60 % that of ‘P’; however, there was no significant pressure value change between ‘PT’ and ‘P’.
The dimensional change in course-wise had more effect on clothing pressure than in wale-wise for the correlation among fabric size, stretch properties and clothing pressure; consequently, a smaller size course-wise resulted in higher clothing pressure. ‘PT’ had slightly higher value than that of ‘PF’ for elastic recovery. The clothing pressure value of ‘PF’ was higher than ‘PT’, because weight and thickness change of ‘PF’ was heavier and thicker than the ‘PT’ that exerted a strong influence on clothing pressure vertically press down on the body.
This paper proposed an appropriate knit structure and arrangement approach in consideration of fabric size and stretch properties of high stretch knitted fabric and correlation with clothing pressure. The analysis results verified that a variety of clothing pressure effects could be implemented by a combination of knit structure using principles of knitting and a proper knit structure arrangement when designing compression garments based on economics. This paper provides meaningful market data for the effective development of more diverse garment compression-related products along with the localization of manufacturing for functional and medical compression garments.
JSS designed and carried out the experiments, analyzed the data as well as drafted the manyscript. MSL and MJP guided and helped in feedback and comments in final format of the paper. All authors read and approved the final manuscript.
This work was supported by the research fund of Hanyang University (HY-2014).
The authors declare that they have no competing interests.
- Baek, Y. J., & Choi, J. W. (2007). Selection of the measurement points for garment pressure of the girdle and the all-in-one. Korean Journal of Community Living Science, 18(4), 615–616.Google Scholar
- Brackenbury, T. (1992). Knitted clothing technology (p. P24). Oxford: Blackewell Science.Google Scholar
- Heo, E. Y. (2003). A Study on tensile property of knitted fabrics and their application into knitted garment patterns. Doctoral thesis, Ewha Womans University, Korea.Google Scholar
- Jeong, Y. (2008). Fundamental relationship between reduction rates of stretch fabrics and clothing pressure. Korean Association of Human Ecology, 17(5), 972–973.Google Scholar
- Jung, M. S., & Ryu, D. H. (2002). The effect of dynamic characteristics of knitted fabrics on the clothing pressure of foundation wear. Korean Association of Human Ecology, 11(1), 79–93.Google Scholar
- Kim, S. A., & Suh, M. A. (2005). A Study on the knit pattern considering the characteristics of rib Stitch(2)-focused on 2×1 and 2×2 rib stitches. The Research Journal of the Costume Culture, 13(1), 47–59.Google Scholar
- Lee, Y. J. (2005). Prediction of the clothing pressure based on the 3D shape deformation and mechanical properties of fabrics. Doctoral thesis, Chungnam University, Korea.Google Scholar
- Lyle, D. (1977). Performance of textiles (pp. 168–169). New York: Wiley and Sons, Inc.Google Scholar
- Oh, J. Y. (2010). A Study on the one-piece dress pattern development according to the stretch rate of circular knitted fabric. Doctoral thesis, Mokpo University, Korea.Google Scholar
- Rhie, J. (1992). Fundamental relationship between extensibility of stretch fabric and It’s pressure. Family and Environment Research, 30(1), 1–2.Google Scholar
- Sang, J. S., & Park, M. J. (2011). Physical properties of knitted fabrics on knitting structure for medical compression garments. The Research Journal of the Costume Culture, 19(2), 334–345.Google Scholar
- Yamada, T., & Matsuo, M. (2009). Clothing pressure of knitted fabrics estimated in relation to tensile load under extension and recovery processes by simultaneous measurements. Textile Research Journal, 79(11), 1033.Google Scholar
Open AccessThis article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.