Abstract
This study aims are to present effects of periodic corrugations in rectangular ducts on the thermal-hydraulic behaviors of nanofluids. The applied corrugations were rectangular cavities with a constant cavity length. In this regard, three various dimensionless cavity shaped corrugation widths such as S/H = 0.1, 0.2, and 0.3 were investigated. Computations were carried out at different Reynolds numbers in the range of 500≤Re≤2000. Alternatively, for further improvement of thermal characteristics, effects of an alumina–water nanofluid flow on the aforementioned corrugated ducts were investigated using the constant nanoparticle size dp = 25 nm and various nanoparticle volume concentrations in the range of 1%≤ Φ ≤8%. The governing equations were solved numerically by means of the finite volume method. The obtained results revealed that application of periodic corrugations in ducts develops the turbulent flow all over the duct, which results in the higher flow mixing and thermal efficiency compared with the plain duct. Furthermore, rates of turbulence intensity and flow mixing change as a function of S/H. In addition, it was demonstrated that application of alumina–water flow in such corrugated ducts enhances the rate of heat transfer and thermal efficiency index compared with water flow. It is hoped that the obtained results arouse interest for thermal designer.
Similar content being viewed by others
References
Desrues, T., Marty, P., and Fourmigue, J.F., Numerical Prediction of Heat Transfer and Pressure Drop in Three-Dimensional Channels with Alternated Opposed Ribs, Appl. Therm. Eng., 2012, vols. 45/46, pp. 52–63.
García, A., Solano, J.P., Vicente, P.G., and Viedma, A., The Influence of Artificial Roughness Shape on Heat Transfer Enhancement: Corrugated Tubes, Dimpled Tubes and Wire Coils, Appl. Therm. Eng., 2012, vol. 35, pp. 196–201.
Yin, J., Yang, G., and Li, Y., The Effects ofWavy Plate Phase Shift on Flow and Heat Transfer Characteristics in Corrugated Channel, Energy Procedia, 2012, vol. 14, pp. 166–1573.
Faizal, M. and Ahmed, M.R., Experimental Studies on a Corrugated Plate Heat Exchanger for Small Temperature Difference Applications, Exp. Therm. Fluid Sci., 2012, vol. 36, pp. 242–248.
Bilen, K., Cetin, M., Gul, H., and Balta, T., The Investigation of GrooveGeometry Effect on Heat Transfer for Internally Grooved Tubes, Appl. Therm. Eng., 2009, vol. 29, pp. 753–761.
Ramadhan, A.A., Al Anii, Y.T., and Shareef, A.J., Groove Geometry Effects on Turbulent Heat Transfer and Fluid Flow, Heat Mass Transfer, 2013, vol. 49, pp. 185–195.
Mohammed, H.A., Abed, A.M., and Wahid, M.A., The Effects of Geometrical Parameters of a Corrugated Channel within Out-of-Phase Arrangement, Int. Comm. Heat Mass Transfer, 2013, vol. 40, pp. 47–57.
Eiamsa-ard, S. and Promvonge, P., Numerical Study on Heat Transfer of Turbulent Channel Flow over Periodic Grooves, Int. Comm. Heat Mass Transfer, 2008, vol. 35, pp. 844–852.
Agra, O., Demir, H., Atayilmaz, S.O., Kantas, F., and Dalkilic, A.S., Numerical Investigation of Heat Transfer and Pressure Drop in Enhanced Tubes, Int. Comm. Heat Mass Transfer, 2011, vol. 38, pp. 1384–1391.
Naphon, P. and Kornkumjayrit, K., Numerical Analysis on the Fluid Flow and Heat Transfer in the Channel with V-ShapedWavy Lower Plate, Int. Comm. Heat Mass Transfer, 2008, vol. 35, pp. 839–843.
Naphon, P., Effect of Corrugated Plates in an In-Phase Arrangement on the Heat Transfer and Flow Developments, Int. J. Heat Mass Transfer, 2008, vol. 51, pp. 3963–3971.
Elshafei, E.A.M., Awad,M.M., El-Negiry, E., and Ali, A.G., Heat Transfer and Pressure Drop in Corrugated Channels, Energy, 2010, vol. 35, pp. 101–110.
Abbasian-Arani, A.A. and Amani, J., Experimental Study on the Effect of TiO2–Water Nanofluid on Heat Transfer and Pressure Drop, Exp. Therm. Fluid Sci., 2012, vol. 42, pp. 107–115.
Peygamberzadeh, S.M., Hashemabadi, S.H., Jamnani, M.S., and Hoseini, S.M., Improving the Cooling Performance of Automobile Radiator with Al2O3/Water Nanofluid, Appl. Therm. Eng., 2011, vol. 31, pp. 1833–1838.
Abbasian-Arani, A.A., Sebdani, S.M., Mahmoodi, M., Ardeshiri, A., and Aliakbari, M., Numerical Study of Mixed Convection Flow in a Lid-Driven Cavity with Sinusoidal Heating on Sidewalls Using Nanofluid, Superlatt. Microstr., 2012, vol. 51, pp. 893–911.
Keshavarz Moraveji, M., Darabi, M., Hossein Haddad, S.M., and Davarnejad, R., Modeling of Convective Heat Transfer of a Nanofluid in the Developing Region of Tube Flow with Computational Fluid Dynamics, Int. Commun. Heat Mass Transfer, 2011, vol. 38, pp. 1291–1295.
Mohammed, H.A., Al-Shamani, A.N., and Sheriff, J.M., Thermal and Hydraulic Characteristics of Turbulent Nanofluids Flow in a Rib–Groove Channel, Int. Commun. Heat Mass Transfer, 2012, vol. 39, pp. 1584–1594.
Nasrin, R., Alim,M.A., and Chamkha, A.J., Combined Convection Flow in TriangularWavy Chamber Filled with Water–CuO Nanofluid: Effect of Viscosity Models, Int. Comm. Heat Mass Transfer, 2012, vol. 39, pp. 1226–1236.
Darzi, A.A.R., Farhadi, M., Sedighi, K., Shafaghat, R., and Zabihi, K., Experimental Investigation of Turbulent Heat Transfer and Flow Characteristics of SiO2/Water Nanofluid within Helically Corrugated Tubes, Int. Comm. Heat Mass Transfer, 2012, vol. 39, pp. 1425–1434.
Ahmed, M.A., Shuaib, N.H., and Yusoff, M.Z., Numerical Investigations on the Heat Transfer Enhancement in aWavy Channel Using Nanofluid, Int. J. Heat Mass Transfer, 2012, vol. 55, pp. 5891–5898.
Pandey, S.D. and Nema, V.K., Experimental Analysis of Heat Transfer and Friction Factor of Nanofluid as a Coolant in a Corrugated Plate Heat Exchanger, Exp. Therm. Fluid Sci., 2012, vol. 38, pp. 248–256.
Wilcox, D.C., Turbulence Modeling for CFD, 2nd ed., California: DCW Industries, 1994.
Patankar, S.V., Numerical Heat Transfer and Fluid Flow, New York, NY: Taylor and Francis, 1980.
Sharma, K.V., Syam Sundar, L., and Sarma, P.K., Estimation ofHeat Transfer Coefficient and Friction Factor in the Transition Flow with Low Volume Concentration of Al2O3 Nanofluid Flowing in a Circular Tube and with Twisted Tape Insert, Int. Comm. Heat Mass Transfer, 2009, vol. 36, no. 5, pp. 503–507.
Rabienataj Darzi, A.A., Farhadi, M., Sedighi, K., Aallahyari, S., and Aghajani Delavar, M., Turbulent Heat Transfer of Al2O3–Water Nanofluid inside Helically Corrugated Tubes: Numerical Study, Int. Comm. Heat Mass Transfer, 2013, vol. 41, pp. 68–75.
Shahi, M., Mahmoudi, A.H., and Talebi, F., A Numerical Investigation of Conjugated-Natural Convection Heat Transfer Enhancement of a Nanofluid in an Annular Tube Driven by Inner Heat Generating Solid Cylinder, Int. Comm. Heat Mass Transfer, 2011, vol. 38, no. 4, pp. 533–542.
Mahmoodi, M., Numerical Simulation of Free Convection of aNanofluid inL-ShapedCavities, Int. J. Therm. Sci., 2011, vol. 50, pp. 1731–1740.
Maxwell, J.C., A Treatise on Electricity and Magnetism, 2nd ed., vol. 1, Oxford, U.K.: Clarendon Press, 1881.
Hamilton, R.L. and Crosser, O.K., Thermal Conductivity of Heterogeneous Two-Component System, I EC Fundam., 1962, vol. 1, pp. 182–191.
Koo, J. and Kleinstreuer, C., A New Thermal Conductivity Model for Nanofluids, J. Nanopart. Res., 2004, vol. 6, pp. 577–588.
Xuan, Y., Li, Q., and Hu, W., Aggregation Structure and Thermal Conductivity of Nanofluids, AIChE J., 2003, vol. 49, no. 4, pp. 1038–1044.
Vajjha, R.S. and Das, D.K., Experimental Determination of Thermal Conductivity of Three Nanofluids and Development of New Correlations, Int. J. Heat Mass Transfer, 2009, vol. 52, pp. 4675–4682.
www.accuratus.com.
Incropera, F.P., DeWitt, D.P., Bergman, T.L., and Lavine, A.S., Fundamentals of Heat andMass Transfer, Wiley, 2011.
Shah, R.K. and London, A.L., Laminar Forced Convection in Ducts, New York: Academic Press, 1978.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hassanzadeh, R., Tokgoz, N. Thermal-hydraulic characteristics of nanofluid flow in corrugated ducts. J. Engin. Thermophys. 26, 498–513 (2017). https://doi.org/10.1134/S1810232817040063
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1810232817040063