Skip to main content
SpringerLink
Log in

Structure Formation of the Nitrogen-Containing Austenitic 04Kh20N6G11M2AFB Steel at Hot Deformation: Part II. Influence of the Phase Composition and Conditions of Hot Deformation on the Process of Dynamic Recrystallization

  • METAL SCIENCES. METALLURGY
  • Published:
Inorganic Materials: Applied Research Aims and scope

Abstract—

The impact of δ-ferrite in high-strength corrosion-resistant nitrogen-containing 04Kh20N6G11M2AFB steel on deformation resistance during hot deformation within the temperature range of 900–1200°С and strain rates of 0.1–10 s–1 was investigated. Analysis of diagrams shows that dynamic recrystallization of δ-ferrite steel starts at a lower threshold deformation rate compared with pure austenitic steel. The values of the deformation threshold necessary for the initiation and development of dynamic recrystallization depending on the phase composition of the nitrogen-containing steel were determined. The complex analysis of the structure proved that δ-ferrite contributes to the nucleation and development of dynamic recrystallization at 1200–1000°C (its initiation corresponds to the lowest deformation threshold) and formation of the recrystallized structure in a larger volume as compared with the purely austenitic structure.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.

Similar content being viewed by others

REFERENCES

  1. Kalinin, G.Yu., Mushnikova, S.Yu., Nesterova, E.V., Fomina, O.V., and Khar’kov, A.A., The structure and properties of high-strength corrosion-resistant nitrogen steel 04Kh20N6G11M2AFB, Vopr. Materialoved., 2006, no. 1 (45), pp. 45–53.

  2. Malyshevsky, V.A., Tsukanov, V.V., Kalinin, G.Yu., and Fomina, O.V., Modern low-magnetic steels for shipbuilding, Sudostroenie, 2009, no. 5, pp. 19–21.

  3. Gorynin, I.V., Rybin, V.V., Malyshevsky, V.A., Kalinin, G.Yu., Mushnikova, S.Yu., Malakhov, N.V., and Yampol’skii, V.D., Creation of prospective fundamentally new corrosion-resistant cored steels doped with nitrogen, Vopr. Materialoved., 2005, no. 2 (42), pp. 40–54.

  4. Gorynin, I.V., Malyshevsky, V.A., Kalinin, G.Yu., Mushnikova, S.Yu., Bannykh, O.A., Blinov, V.M., and Kostina, M.V., Corrosion-resistant high-strength nitro-genous steels, Vopr. Materialoved., 2009, no. 3 (59), pp. 7–16.

  5. Kalinin, G.Yu., Malyshevsky, V.A., Teplenicheva, A.S., Fomina, O.V., Mushnikova, S.Yu., and Kharkov, A.A., High-strength austenitic welded steel for shipbuilding, Inorg. Mater.: Appl. Res., 2015, vol. 6, no. 6, pp. 559–565.

    Article  Google Scholar 

  6. Kazakov, A.A., Oryshchenko, A.S., Fomina, O.V., Zhitenev, A.I., and Vikhareva, T.V., Controlling behavior of δ-ferrite in nitrogen-containing chromium–nickel–manganese steels, Inorg. Mater.: Appl. Res., 2017, vol. 8, no. 6, pp. 817–826.

    Article  Google Scholar 

  7. Kane, R.H., The Hot Deformation of Austenite, Oxford: Pergamon, 1977.

    Google Scholar 

  8. Pickering, F.B., Physical Metallurgy and the Design of Steels, London: Appl. Sci., 1978.

    Google Scholar 

  9. Livshits, L.S., Metallovedenie dlya svarshchikov (Metal Science for Welders), Moscow: Mashinostroenie, 1979.

  10. Demk, H., Deformation under Hot Working Conditions, London: Iron Steel Inst., 1968.

    Google Scholar 

  11. Sokol, I.Ya., Dvukhfaznye stali (Two-Phase Steels), Moscow: Metallurgiya, 1974.

  12. Fomina, O.V., Vikhareva, T.V., Sagaradze, V.V., and Kataeva, N.V., Structure formation of the nitrogen-containing austenitic 04Kh20N6G11M2AFB steel at hot deformation: Part I. influence of deformation temperature and strain rate on the process of dynamic recrystallization, Inorg. Mater.: Appl. Res., 2018, vol. 9, no. 6, pp. 1060–1069.

Download references

ACKNOWLEDGMENTS

Experimental studies were performed by using the equipment of the Center for Collective Use Composition, Structure, and Properties of Structural and Functional Materials of the National Research Center Kurchatov Institute—CRISM Prometey under the financial support of the Ministry of Education within the framework of agreement 14.595.21.0004, unique identifier RFMEFI59517X0004.

Author information

Authors and Affiliations

  1. National Research Center Kurchatov Institute—Central Research Institute of Structural Materials Prometey, 191015, St. Petersburg, Russia

    O. V. Fomina & T. V. Vikhareva

Authors
  1. O. V. Fomina
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. T. V. Vikhareva
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to O. V. Fomina.

Additional information

Translated by E. Grishina

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Fomina, O.V., Vikhareva, T.V. Structure Formation of the Nitrogen-Containing Austenitic 04Kh20N6G11M2AFB Steel at Hot Deformation: Part II. Influence of the Phase Composition and Conditions of Hot Deformation on the Process of Dynamic Recrystallization. Inorg. Mater. Appl. Res. 9, 1070–1075 (2018). https://doi.org/10.1134/S207511331806028X

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S207511331806028X

Keywords:

Search

Navigation