Abstract
The properties of the impregnating compounds used in the lamination of wood-panel materials consisting of imported ingredients and resins with a concentration of melamine of 35–40% are considered. A synthesis technology of melamine—formaldehyde impregnating resins containing 25–30% melamine and domestic ingredients is presented. It is shown that the paper–resin films obtained using modified impregnating resins are a high-quality facing material for finishing by lamination of wood-panel products.
Similar content being viewed by others
REFERENCES
M. A. Gorodetskii, V. A. Nalyub, G. V. Malysheva, A. Y. Shaulov, and A. A. Berlin, “Technology of forming and the properties of reinforced composites based on an inorganic binder,” Rus. Metallur. (Engl. Transl.), No. 13, 1195–1198 (2018).
P. P. Maung, G. V. Malysheva, and S. A. Gusev, “A study of the effect of network angle of fabrics on kinetics of impregnation upon molding of articles made from carbon plastics,” Polym. Sci., Ser. D 9, 407–410 (2016).
N. V. Bodrykh and G. V. Malysheva, “Repair of starter storage batteries,” Polym. Sci., Ser. D 3, 70–73 (2010).
E. A. Basharov and A. Yu. Vagin, “Analysis of polymeric composite materials application for helicopter airframe design,” Tr. Mosk. Aviats. Inst., No. 92, 13 (2017).
A. I. Endogur and V. A. Kravtsov, “Ideas of designing aerostructures of polymer composite materials,” Tr. Mosk. Aviats. Inst., No. 81, 4–16 (2015).
V. Nelyub and G. Malysheva, “Modern treatment technologies of carbon fibre for ensuring the high strength carbon fibre reinforced plastic,” MATEC Web Conf. 129, 02001 (2017).
Composite Materials. Handbook (Mashinostroenie, Moscow, 1990) [in Russian].
A. P. Petrova and G. V. Malysheva, Adhesives, Adhesive Binders, and Adhesive Prepregs (All-Russian Institute of Aviation Materials, Moscow, 2017) [in Russian].
N. V. Ivanov, Ya. M. Gurevich, M. A. Khaskov, and A. R. Akmeev, “Studying of cure mode of VSE-34 binding and its influences on mechanical properties,” Aviats. Mater. Tekhnol., No. 2, 50–55 (2017).
O. P. Machneva, V. E. Tsvetkov, and M. Yu. Ekimova, “Polyatomic alcohols as urea–formaldehyde resin modifiers,” Polym. Sci., Ser. D 12, 124–127 (2019).
M. Yu. Ekimova, V. E. Tsvetkov, and O. P. Machneva, “Aminoformaldehyde oligomers modified with salts of polyfunctional acids,” Polym. Sci., Ser. D 14, 13–16 (2021).
V. E. Tsvetkov, M. Yu. Zueva, and O. P. Machneva, “Study of the effect of surfactant additives on the surface tension of modified impregnating oligomers,” Vestn. Mosk. Gos. Univ. Lesa—Lesn. Vestn., No. 5, 135–138 (2011).
V. E. Tsvetkov, Yu. V. Pas’ko, O. P. Machneva, and K. V. Kremnev, Polymers in Manufacture of Wood Materials: Practical Work (Moscow State Forest Univ., Moscow, 2012) [in Russian].
Yu. G. Doronin, S. N. Miroshnichenko, and M. M. Svitkina, Synthetic Resin in Woodwork (Lesn. Prom-st’, Moscow, 1987) [in Russian].
S. V. Denisov and N. P. Plotnikov, Tests of Synthetic Resins and Adhesives on their Basis (Bratsk State Univ., Bratsk, 2012).
V. N. Volynskii, Technology of Wood-Based Panels and Composite Materials (Lan’, St. Petersburg, 2010) [in Russian].
S. P. Trishin, Technology of Wood-Based Panels, 3rd ed. (Moscow State Forest Univ., Moscow, 2007) [in Russian].
GOST (State Standard) 3916.1–96. General Purpose Plywood with Hardwood Veneer Outer Layers. Technical Conditions (Izd. Standartov, Moscow, 1996) [in Russian].
GOST (State Standard) 10632–2014. Wood Particle Panels. Technical Conditions (Standartinform, Moscow, 2014) [in Russian].
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by E. Boltukhina
Rights and permissions
About this article
Cite this article
Tsvetkov, V.E., Nikitin, A.A., Semochkin, Y.A. et al. Properties of Composites Based on Melamine–Formaldehyde Binding Agents. Polym. Sci. Ser. D 15, 49–53 (2022). https://doi.org/10.1134/S199542122201021X
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S199542122201021X