Abstract
A solution to the problem of deformation mode of adhesive overlapped joint under force and temperature effects using the contact4ayer method is presented. The influence of geometry and physical parameters of the model and experiment has been studied. Calculation results have been compared with the results of the experiment.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
R. A. Turusov and L. I. Manevich, Klei. Germet. Tekhnol., No. 6, 2–11 (2009).
B. I. Panshin, Glues and Gluing Technology (Oborongiz, Moscow, 1960 [in Russian].
A. Ya. Gol’dman and A. L. Rabinovich, Physical Chemistry and Mechanics of Oriented Fiberglass Reinforced Plastics (Nauka, Moscow, 1967) [in Russian].
A. L. Rabinovich, Introduction to the Mechanics of Reinforced Polymers (Nauka, Moscow, 1970) [in Russian].
A.S. Freidin and R. A. Turusov, Characteristics and Calculations of Adhesive Joints (Khimiya, Moscow, 1990) [in Russian].
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © R.A. Turusov, L.I. Manevich, 2009, published in Klei. Germetiki. Tekhnologii, 2009, No. 8, pp. 2–12.
Rights and permissions
About this article
Cite this article
Turusov, R.A., Manevich, L.I. Contact layer method in adhesive mechanics: One-dimensional problems and overlapped joint shear. Polym. Sci. Ser. D 3, 10–19 (2010). https://doi.org/10.1134/S1995421210010028
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1995421210010028