Skip to main content

Analysis of Arrangements of Heaters with Tubes Finned by Deforming Cutting

This is a preview of subscription content, access via your institution.


  1. 1

    Zaitsev, A.V., Complex Research in the Field of Ensuring Safe Microclimatic Conditions in Long Working Faces of Potash Mines of OAO Belarus’kalii, Strateg. Processy Osvoen. Geores., 2015, no. 13, pp. 260–263.

  2. 2

    Zaitsev, A.V., Levin, L.Yu., Butakov, S.V., and Semin, M.A., Heat Engineering Systems for Normalizing Microclimatic Air Parameters in Deep Mines of the Polar Division of PAO GMK Norilsk Nikel, Gornyi Zh., 2018, no. 6, pp. 34–39.

  3. 3

    Shipika, E.S., Thermophysical Substantiation of Parameters of the outside Air Heating System for Coal Mines Based on Natural Energy Sources, Cand. Sci. (Engin.) Dissertation, St. Petersburg, 2019.

  4. 4

    Saxena, A., Verma, P., and Srivastava, G., Design and Thermal Performance Evaluation of an Air Heater with Low Cost Thermal Energy Storage, Appl. Therm. Engin., vol. 167, p. 114768; 10.1016/j.applthermaleng.

  5. 5

    Galkin, A.F. and Nikolaeva, D.V., Substantiation of a Rational Method for Heating Mine Air, in Science Week of SPbGPU: Materials of Scientific and Practical Conference with International Participation, St. Petersburg: Polytech. Univ., 2014, pp. 94–96.

  6. 6

    Sotnikov, A.G., Protsessy, apparaty i sistemy conditsionirovaniya vozdukha i ventilyatsii (Processes, Devices, and Systems of Air Conditioning and Ventilation), vol. 1, St. Petersburg: AT-Publishing, 2006.

  7. 7

    Sotnikov, A.G., Air Heaters of SAC (SV) and Freezing of Water in Them: The Achilles Heel of Systems..., Mir Stroit. Nedvizh., 2012, no. 45, pp. 2–4.

  8. 8

    Sotnikov, A.G. and Rusakov, A.P., Mathematical Modeling of Hydraulic Balancing Modes and Control of Subsystem for Air Heating and Cooling/Dehumidification in SAC and SV, Inzh. Zh., 2011, no. 1, pp. 53–61.

  9. 9

    Mansurov, R., Experimental Study of Heat Exchange Processes with Variable Operating Modes of Air Heater-Fan System, J. Phys.: Conf. Ser., 2019, vol. 1382, p. 012135;

  10. 10

    Hartman, H., Mutmansky, J., Ramani, R., and Wan, Y., Mine Ventilation and Air Conditioning, New York: Wiley, 2012, 3rd ed.

  11. 11

    Dreitser, G.A., Problems in Developing Highly Efficient Tubular Heat Exchangers, Therm. Engin., 2006, vol. 53, no. 4, pp. 279–287.

  12. 12

    Zubkov, N.N. and Nikitenko, S.M., New-Design Heaters Using Tubes Finned by Deforming Cutting Method, Naukoemkie Tekhnol. Razrabotki Ispol’zov. Mineral. Res., 2017, no. 3, pp. 206–211.

  13. 13

    Zubkov, N.N., Nikitenko, S.M., and Nikitenko, M.S., New Design Heaters Using Tubes Finned by Deforming Cutting Method, Conf. Series: Materials Sci. Engin., 2017, vol. 253, p. 012021, pp. 1–5; doi: 10.1088/1757-899X/253/1/012021.

  14. 14

    Pavlenko, A.N., Kuznetsov, D.V., Volodin, O.A., et al., Heat Transfer and Dynamics of Transient Processes at Liquid Film Flowing on Smooth and Modified Surfaces, J. Phys.: Conf. Ser., 2019, 1369, no. 1, p. 012052; doi:10.1088/1742-6596/1369/1/012052.

  15. 15

    Volodin, O.A., Pecherkin, N.I., Pavlenko, A.N., et al., The Influence of the Surface Structuring Type on Heat Transfer in Falling Films of the Refrigerant Mixture, J. Phys.: Conf. Ser., 2019, vol. 1369, no. 1, p. 012046; doi:10.1088/1742-6596/1369/1/012046.

  16. 16

    Pavlenko, A.N., Perspectives and Problematic Issues in the Development of Heat Transfer Enhancement Methods at Boiling and Evaporation, J. Phys.: Conf. Ser., 2019, p. 012001; doi: 10.1088/1742-6596/1359/1/012001.

  17. 17

    Zubkov, N., Multitool Deformation and Cutting in Applying Fins to Heat-Exchanger Pipe, Russ. Engin. Res., 2015, vol. 35, no. 11, pp. 859–863.

  18. 18

    Zubkov, N.N., Multifunctional Technology for Increasing the Surface Area to Improve Heat-Exchange and Technological Properties of Parts, Polet (Aviatsiya, Raketnaya Tekhnika Kosmonavtika), 2003, no. 3, pp. 41–46.

  19. 19

    Stepanov, K., Mukhin, D., and Zubkov, N., Desorption of Aqueous Solution of Lithium Bromide on Enhanced Surfaces in a Single-Stage Lithium-Bromide Absorption Chiller, J. Eng. Therm., 2019, vol. 28, no. 4, pp. 529–537; doi: 10.1134/S1810232819040076.

  20. 20

    Skrypnik, A.N., Shchelchkov, A.V., Popov, I.A., et al., Thermohydraulic Efficiency of Tubes with Internal Spiral Finning, J. Engin. Phys. Thermophys., 2018, vol. 91, no. 1, pp. 52–63; doi: 10.1007/s10891-018-1718-y.

  21. 21

    Isaichenko, V.P., Osipov, V.A., and Sukomel, A.S., Teploperedacha (Heat Transfer), Moscow: Energiya, 1975, 3rd ed.

  22. 22

    Bogdanov, S.N., Buchko, N.A., Guigo, E.I., et al., Teoreticheskie osnovy khladotekhniki. Teplomassoobmen (Theoretical Foundations of Refrigeration Engineering. Heat and Mass Transfer), Guigo, E.I., Ed., Moscow: Agropromizdat, 1986.

  23. 23

    Pis’mennyi, E.N., Teploobmen i aerodinamika paketov poperechno-orebrennykh trub (Heat Transfer and Aerodynamics of Banks of Cross-Wise Finned Tube), Kiev: Alterpress, 2004.

  24. 24

    Kraus, A., Aziz, A., and Welty, J., Extended Surface Heat Transfer, New York: Wiley, 2001.

  25. 25

    Metodika teplovogo i aerodinamicheskogo rascheta apparatov vozdushnogo okhlazhdeniya (Method of Thermal and Aerodynamic Calculation of Air Cooling Units), Moscow: VNIIneftemash, 1971.

  26. 26

    Kutateladze, S.S. and Leontev, A.I., Heat Transfer, Mass Transfer, and Friction in Turbulent Boundary Layers, New York: Hemisphere, 1990.

  27. 27

    Chisholm, D., Two-Phase Flow in Pipelines and Heat Exchangers, New York: G. Godwin in association with Institution of Chemical Engineers, 1983.

  28. 28

    Idel’chik, I.E., Spravochnik po gidravlicheskim soprotivleniyam (Handbook on Hydraulic Resistance), Steinberg, M.O., Ed., Moscow: Mashinostroenie, 1992, 3rd ed.

Download references


The authors are grateful to the engineers of the Institute of Coal of the Federal Research Center of Coal and Coal Chemistry SB RAS Yu.E. Kiselev and A.I. Efremov for the assistance provided in the preparation and conduct of tests.

Author information



Corresponding author

Correspondence to S. M. Nikitenko.

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Zubkov, N.N., Nikitenko, S.M., Kaskov, S.I. et al. Analysis of Arrangements of Heaters with Tubes Finned by Deforming Cutting. J. Engin. Thermophys. 29, 600–611 (2020).

Download citation