Abstract
Relationships between the parameters of a bipolar-transistor (BT) common-base power amplifier, which provide compensation of the flicker component of the phase noise of the output signal during operation in the linear mode, are obtained. This effect is revealed in the microwave frequency band by means of numerical simulation. It is shown that after introduction of nonlinear parameters in the BT equivalent circuit, the effect persists in some vicinity of the compensation point calculated for the linear case.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
V. N. Kuleshov and T. I. Boldyreva, in Proc. 1997 IEEE Int. Frequency Control Symp., Orlando, May 28–30, 1997 (IEEE, New York, 1997), p. 446.
T. I. Boldyreva, in Proc. 2001 IEEE Int. Frequency Control Symp. and PDA Exhibition, Seattle, June 8, 2001 (IEEE, New York, 2001), p. 183.
T. I. Boldyreva and V. N. Kuleshov, in Proc. 13th European Frequency and Time Forum and 1999 IEEE Int. Frequency Control Symp., Besancon, France, April, 1999 (IEEE, New York, 1999), p. 1184.
Additional information
Original Russian Text © A.V. Pluteshko, D.P. Tsarapkin, 2012, published in Radiotekhnika i Elektronika, 2012, Vol. 57, No. 4, pp. 437–440.
Rights and permissions
About this article
Cite this article
Pluteshko, A.V., Tsarapkin, D.P. Compensation of the phase flicker noise in a bipolar-transistor power amplifier. J. Commun. Technol. Electron. 57, 400–403 (2012). https://doi.org/10.1134/S1064226912040171
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1064226912040171