Abstract
By methods of optical, scanning and transmission electron diffraction microscopy and microhardness and tribology parameters measurement the changes regularities of structure-phase states, defect substructure of rails surface after the long term operation (passed tonnage of gross weight 500 and 1000 mln. tons) were established. It is shown that the wear rate increases in 3 and 3.4 times after passed tonnage of gross weight 500 and 1000 mln. tons, accordingly, and the friction coefficient decreases in 1.4 and 1.1 times. The cementite plates are destroying absolutely and cementite particles of around form with the sizes 10–50 nm are forming after passed tonnage 500 mln tons. The appearance of dynamical recrystallization initial stages is marked after the passed tonnage 1000 mln tons. The possible mechanisms of established regularities are discussed. It is noted that two competitive processes can take place during rails long term operation: 1. Process of cutting of cementite particles followed by their carrying out into the volume of ferrite grains or plates (in the structure of pearlite). 2. Process of cutting, the subsequent dissolution of cementite particles, transition of carbon atoms to dislocations (into Cottrell atmospheres), transition of carbon atoms by dislocations into volume of ferrite grains or plates followed by repeat formation of nanosize cementite particles.
Similar content being viewed by others
References
V. E. Gromov, A. B. Yuriev, K. V. Morozov, and Yu. F. Ivanov, Microstructure of Hardened Rails (Cambridge Int. Sci. Publ., Cambridge, 2015).
V. I. Vorozhishchev, Composition and Production Technology of Rails of Increased Performance (Novokuznetsk. Poligraf. Kombinat, Novokuznetsk, 2008) [in Russian].
E. A. Shur, Damage to the Rails (Intekst, Moscow, 2012) [in Russian].
E. Sheinman, J. Frict. Wear 33 (4), 308 (2012).
Yu. Ivanisenko and H. J. Fecht, Steel Tech. 3 (1), 19 (2008).
Yu. Ivanisenko, I. Maclaren, X. Sauvage, R. Z. Valiev, H.-J. Fecht, Acta Mater. 54, 1659 (2006).
Ning Jiang-Li, E. Courtois-Manara, I. Kurmanaeva, A. V. Ganeev, R. Z. Valiev, C. Kübel, and Yu. Ivanisenko, Mater. Sci. Eng., A 581, 8 (2013).
V. G. Gavriljuk, Mater. Sci. Eng., A 345, 81 (2003).
Y. J. Li, P. Chai, C. Bochers, S. Westerkamp, S. Goto, D. Raabe, and R. Kirchheim, Acta Mater. 59, 3965 (2011).
V. G. Gavriljuk, Scr. Mater. 45, 1469 (2001).
V. V. Rybin, Large Plastic Deformation and Fracture of Metals (Metallurgiya, Moscow, 1986) [in Russian].
V. E. Gromov and V. A. Petrunin, Phys. Status Solidi A 139, 77 (1993).
Yu. F. Ivanov, V. E. Gromov, O. A. Peregudov, K. V.Morozov, and A. B. Yuriev, Steel Transl. 45 (3), 254 (2015).
V. E. Gromov, O. A. Peregudov, Yu. F. Ivanov, K. V. Morozov, K. V. Alsaraeva, and O. A. Semina, J. Surf. Invest.: X-ray, Synchrotron Neutron Tech. 10 (1), 76 (2016).
O. A. Peregudov, V. E. Gromov, Yu. F. Ivanov, K. V. Morozov, K. V. Alsaraeva, and O. A. Semina, AIP Conf. Proc. 1683, 020179 (2015).
P. B. Hirsch, A. Howie, R. B. Nicholson, D. W. Pashley, and M. J. Whelan, Electron Microscopy of Thin Crystals (Krieger, Melbourne, 1977).
L. M. Utevskii, Diffraction Electron Microscopy in Physical Metallurgy (Metallurgiya, Moscow, 1973) [in Russian].
Author information
Authors and Affiliations
Corresponding author
Additional information
The article is published in the original.
Rights and permissions
About this article
Cite this article
Gromov, V.E., Ivanov, Y.F., Morozov, K.V. et al. Long-term operation of rail steel: Degradation of structure and properties of surface layer. J. Surf. Investig. 10, 1101–1105 (2016). https://doi.org/10.1134/S1027451016050281
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1027451016050281