Abstract
The algorithm for calculation of dynamic compliance of multilayer coatings was developed. The compliance modulus and phase lag of coating surface motion vs. the current pressure depend on viscoelastic properties of materials, ratio of wavelength to layer thickness λ/H, and ratio of wave velocity to propagation velocity of shear vibrations in the base layer V / C t,2 0 Dynamic compliance of the two-layer coating consisting of a thick base layer and thin durable outer layer was calculated. The elasticity modulus of the outer layer ranged up to eight values of elastic modulus of the inner layer; the density of the outer layer either remained equal to the density of the inner layer or increased proportionally to the elastic modulus. Depending on V / C t,2 0 two scenarios of compliant coating interaction with the turbulent flow were distinguished: resonant and broadband ones. It is shown that the vibration properties of two-layer coatings can be significantly better than the properties of the monolayer coatings. This makes it possible either to increase the coating strength or to work efficiently at lower velocities.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
V.M. Kulik, Peculiarities of deformation of compliant coatings with increased strength, Thermophysics and Aeromechanics, 2011, Vol. 18, No. 4, P. 547-560.
K.-S. Choi, X. Yang, B.R. Clayton, E.J. Glover, M. Atlar, B.N. Semenov, and V.M. Kulik, Turbulent drag reduction using compliant surfaces, Proc. Royal Soc. London A, 1997, Vol. 453, P. 2229-2240.
V.M. Kulik, I. Lee, and H.H. Chun, Wave properties of coating for skin friction reduction, Phys. Fluids, 2008, Vol. 20, P. 075109-1-075109-10.
K.S. Yeo, H.Z. Zhao, and B.C. Khoo, Turbulent boundary layer over a compliant surface — absolute and convective, J. Fluid Mech., 2001, Vol. 449, P. 141-168.
V.M. Kulik, A.V. Boiko, B.N. Semenov, B.M. Seoudi, H.H. Chun, and I. Lee, Measurement of dynamic properties of viscoelastic materials, Experimental Mechanics, 2009, Vol. 49, No. 3, P. 417-425.
A.V. Boiko, V.M. Kulik, B.M. Seoudi, H.H. Chun, and I. Lee, Measurement method of complex viscoelastic material properties, Int. J. of Solids and Structures, 2010, Vol. 47, No. 3-4, P. 374-382.
L.D. Landau and E.M. Lifshitz, Theory of Elasticity, Pergamon Press, London, New York, 1970.
V.M. Kulik, Forced oscillations of a layer of viscoelastic material under the action of a convective pressure wave, J. Appl. Mech. Tech. Phys., 2007, Vol. 48, No. 2, P. 221-228.
V.M. Kulik and A.V. Boiko, Form factor for a compressed cylindrical sample, Measurement Technique, 2014, No. 8, P. 898-902.
B.N. Semenov, Analysis of deformational characteristics of viscoelastic coatings, in: Hydrodynamics and Acoustics of Near-Wall and Free Flows, Novosibirsk, 1981, P. 57-76.
Author information
Authors and Affiliations
Corresponding author
Additional information
The work was partially supported by the Russian Foundation for Basic Research (Grant 14-01-00052).
Rights and permissions
About this article
Cite this article
Kulik, V.M. Dynamic compliance of multilayer coatings. Thermophys. Aeromech. 23, 487–498 (2016). https://doi.org/10.1134/S0869864316040028
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0869864316040028