Skip to main content
SpringerLink
Log in

Numerical and Experimental Study of Loop Heat Pipe Steady-State Performance

  • HEAT AND MASS TRANSFER AND PROPERTIES OF WORKING FLUIDS AND MATERIALS
  • Published:
Thermal Engineering Aims and scope Submit manuscript

Abstract

Loop heat pipes (LHPs) have all the advantages of conventional heat pipes, are less susceptible to gravity effects, and offer better heat-transfer performance. They can readily be used in confined areas. As to temperature maintenance, they are self-regulating devices thereby preventing a considerable decrease in the temperature of the mounting seat of heat-releasing equipment on a heat load reduction. Miniature LHPs can replace conventional heat pipes in promising spacecrafts, while substantially increasing the ability to remove heat and reducing their weight. To develop effective methods for the design of LHPs, physical and mathematical models of conjugated heat and mass transfer in the device are required. This paper presents a procedure for the calculation of the steady-state performance of an LHP. This procedure is to be used to calculate the hydraulic resistance to the motion of liquid and vapor in LHP elements. The heat-transfer ability is determined by the ability of the capillary structure to transport the coolant against the hydraulic resistance. In the second part of the problem, the thermal condition of all elements is calculated using an approach based on the balance of heat fluxes. The model considers the potential vapor superheating in a vapor pipeline. Thermophysical properties of the coolant is calculated in each transport section as a function of the local temperature. The predictions describe the LHP performance quite accurately and agree with the results of testing an experimental loop heat pipe under various conditions at an evaporator temperature from –35 to +25°C. The tests were carried out at room temperature or in a climatic chamber, when the temperature of the radiator was almost equal to the temperature of the environment. The maximum deviation of the predicted evaporator temperature from the measured one was less than 5°С with the average deviation being below 3°С.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.
Fig. 7.
Fig. 8.

Similar content being viewed by others

REFERENCES

  1. R. G. Sudakov, Investigation of Non-Stationary and Oscillatory Regimes of Operation of Loop Heat Pipes, Candidate’s Dissertation in Physics and Mathematics (Inst. of Thermophysics of the Ural Branch of the Russian Academy of Sciences, Yekaterinburg, 2004).

  2. Yu. F. Maidanik, F. G. Fershtater, and V. G. Pastukhov, Loop Heat Pipes: Development, Research, Engineering Design Elements (Ural. Otd. Akad. Nauk SSSR, Sverdlovsk, 1989) [in Russian].

    Google Scholar 

  3. A. V. Romanov, Systems for Ensuring Thermal Regimes of Sealed Compartments and Nuclear Power Plants for Spacecraft (Professional, St. Petersburg, 2014) [in Russian].

    Google Scholar 

  4. S. V. Alekseev, I. F. Prokopenko, and B. I. Rybkin, Low-Temperature Heat Pipes for Space Technology, Vol. 1: Problems of Ensuring Operability (Novosti, Moscow, 2006) [in Russian].

  5. V. A. Antonov, M. A. Balykin, K. A. Goncharov, and K. N. Korzhov, “Research and development of precise thermal control system with loop heat pipe,” in Proc. Reshetnev Readings 2016, Krasnoyarsk, Russia, Nov. 9–12, 2016 (Sib. Gos. Univ. Nauki i Tekhnol. im. M. F. Reshetneva, Krasnoyarsk, 2016), Vol. 1, pp. 78–80.

  6. S. A. Ganenko, V. V. Basynin, and Z. A. Kazantsev, “Features of the thermal control system of the small spacecraft ‘Yubileiniy-2’,” Kosm. Apparaty Tekhnol., No. 2, 17–19 (2012).

  7. P. D. Dunn and D. A. Reay, Heat Pipes (Pergamon, Oxford, 1976; Energiya, Moscow, 1979).

  8. S. W. Chi, Heat Pipe Theory And Practice: A Sourcebook (Hemisphere, Washington, 1976; Mashinostroenie, Moscow, 1981).

  9. L. L. Vasil’ev, S. V. Konev, and V. V. Khrolenok, Heat Transfer Intensification in Heat Pipes (Nauka i Tekhnika, Minsk, 1983) [in Russian].

    Google Scholar 

  10. M. N. Ivanovskii, V. P. Sorokin, and I. V. Yagodkin, The Physical Principles of Heat Pipes (Atomizdat, Moscow, 1987; Clarendon, Oxford, 1982).

  11. T. L. Perel’man and M. M. Levitan, “Fundamental theory of heat pipes,” J. Eng. Phys. 25, 1366–1373 (1973).

    Article  Google Scholar 

  12. Ya. S. Kadaner and Yu. P. Rassalkin, “Laminar vapor flow in a heat pipe,” J. Eng. Phys. 28, 140–146 (1975).

    Article  Google Scholar 

  13. A. R. Rohani and C. L. Tien, “Analysis of the effects of vapor pressure drop on heat pipe performance,” Int. J. Heat Mass Transfer 17, 61–67 (1974). https://doi.org/10.1016/0017-9310(74)90038-6

    Article  MATH  Google Scholar 

  14. V. S. Mikhailov, A. I. Krapivin, P. I. Bystrov, and G. I. Pokandyuk, “Investigation of gasdynamics of a vapor stream in heat pipes under turbulent conditions,” IFZh 34, 125–128 (1978).

    Google Scholar 

  15. P. I. Bystrov, V. S. Mikhailov, and G. I. Pokandyuk, “Experimental study of turbulent flow hydrodynamics in heat pipes,” Teplofiz. Vys. Temp. 13, 379–385 (1975).

    Google Scholar 

  16. G. P. Nikolaev and O. Yu. Izoteeva, “Calculation of operating characteristics of loop heat pipes,” Molodoi Uch. 1 (3), 17–25 (2012).

    Google Scholar 

  17. N. L. Gruzdova, V. M. Kiseev, and A. V. Ostrovnskii, “Models of the heat and mass transfer in LHP evaporator,” in Proc. 12th Int. High Pipe Conf., Moscow, May 19–24, 2002 (Pergamon, Oxford, 2003), pp. 108–114.

  18. E. I. Altman, M. I. Mukminova, and H. F. Smirnov, “The loop heat pipe evaporators theoretical analysis,” in Proc. 12th Int. High Pipe Conf., Moscow, May 19–24, 2002 (Pergamon, Oxford, 2003), pp. 159–164.

  19. Yu. G. Fershtater and Yu. F. Maidanik, “Analysis of the temperature field in the capillary structure of an “antigravity” heat pipe,” J. Eng. Phys. 51, 897–900 (1986).

    Article  Google Scholar 

  20. M. Pauken and J. I. Rodriguez, “Performance characterization and model verification of a loop heat pipe,” in Proc. 30th Int. Conf. on Environmental Systems and 7th Eur. Symp. on Space Environmental Control Systems, Toulouse, France, July 10–13, 2000 (Society of Automotive Engineers International, Warrendale, Pa., 2000). https://doi.org/10.4271/2000-01-2317

  21. J. Baumann, “Heat pipe, CPL and LHP analysis integrated with finite element and finite difference CAD-based thermal modeling,” Presented at Int. Two Thermal Control Technology Workshop, Mitchellville, Md., Sept. 24–26, 2002.

  22. R. G. Sudakov and Y. F. Maidanik, “Development and investigation of an ammonia reversible loop heat pipe,” in Proc. 12th Int. High Pipe Conf., Moscow, May 19–24, 2002 (Pergamon, Oxford, 2003), pp. 177–181.

  23. I. E. Idelchik, Handbook of Hydraulic Resistance (Mashinostroenie, Moscow, 1975; Springer, Berlin, 1986).

  24. S. W. Chi, Heat Pipe Theory And Practice: A Sourcebook (Hemisphere, Washington, 1976; Mashinostroenie, Moscow, 1981).

  25. V. M. Polyaev, V. A. Maiorov, and L. L. Vasil’ev, Hydrodynamics and Heat Transfer in Porous Elements of Aircraft Structures (Mashinostroenie, Moscow, 1988) [in Russian].

    Google Scholar 

  26. H. Y. Wong, Handbook of Essential Formulae and Data on Heat Transfer for Engineers (Longman, London, 1977; Atomizdat, Moscow, 1979).

  27. O. G. Martynenko, Handbook of Heat Exchangers (Energoatomizdat, Moscow, 1987), Vol. 1 [in Russian].

    Google Scholar 

  28. N. B. Vargaftik, Handbook of Physical Properties of Liquids and Gases (Nauka, Moscow, 1972; Hemisphere, Washington, DC, 1975).

Download references

Author information

Authors and Affiliations

  1. State Scientific Center Keldysh Center, 125438, Moscow, Russia

    A. E. Belov, A. A. Velikanov, D. N. Il’mov, O. A. Nagornova, V. V. Sobolev & N. I. Filatov

Authors
  1. A. E. Belov
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. A. A. Velikanov
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. D. N. Il’mov
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. O. A. Nagornova
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. V. V. Sobolev
    View author publications

    You can also search for this author in PubMed Google Scholar

  6. N. I. Filatov
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to D. N. Il’mov.

Additional information

Translated by T. Krasnoshchekova

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Belov, A.E., Velikanov, A.A., Il’mov, D.N. et al. Numerical and Experimental Study of Loop Heat Pipe Steady-State Performance. Therm. Eng. 69, 190–201 (2022). https://doi.org/10.1134/S0040601522030028

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S0040601522030028

Keywords:

Search

Navigation