Abstract
Analysis of the thermal state of molten pools that can be formed on the vessel bottom of the VVER-600 medium-power reactor during a severe anticipated accident with melting of the core is represented. Two types of the molten pool of core materials, with the two-layer and inverse three-layer stratification, are considered. Thermal loads acting on the reactor vessel from the melt are estimated depending on its formation time. Features of the thermal state of the melt in the case of its inverse stratification are analyzed. It is shown that thermal loads on the reactor vessel exceed the critical heat flux (CHF) when forming the two-layer stratified molten pool 10 and 24 h after its shutdown, and the thermal load is close to the corresponding CHF or somewhat exceeds it in 72 h. In the case of the formation of the inverse structure of the melt, one can observe a decrease by more than 2.5 times (in comparison with the two-layer stratified structure) in the thermal load on the reactor vessel in the region of its contact with the upper layer of the steel melt. Analysis of results showed that maximum densities of heat flux to the reactor vessel from the bottom metallic layer with the melt inversion did not exceed corresponding CHFs 24 and 72 h after the reactor shutdown. Because the thermal load on the reactor vessel can be localized in the region of its bottom, where the CHF is relatively small, during the inverse stratification of the melt, there is a need to carry out further in-depth experimental and analytical investigations of conditions for formation of the stratified molten pool and to obtain corrected experimental CHFs for conditions and outlines of cooling the external surface of the VVER-600 vessel in a severe accident.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
V. V. Pazhetnov, V. P. Semishkin, A. N. Churkin, V. D. Loktionov, K. S. Dolganov, D. Yu. Tomaschik, A. S. Filippov, N. I. Drobyshevsky, and A. M. Danilov, “Consideration of conditions of prolonged exposure of the molten core fragments to WWPR-440 reactor pressure vessel during severe accidents,” Vopr. At. Nauki Tekhn., Ser. Obespech.Bezop. AES, No. 25, 161–172 (2009).
V. D. Loktionov, “Parametric analysis of the failure of a WWPR-440 vessel during a serious accident,” At. Energy 103, 986–989 (2007).
V. D. Loktionov, V. P. Semishkin, V. V. Pazhetnov, and V. A. Mokhov, “Study of WWPR vessel behavior for justification of the possibility of intervessel keeping of smelt at severe accident,” Vopr. At. Nauki Tekhn., Ser. Obespech. Bezopasn. AES, No. 15, 65–72 (2006).
N. G. Rassokhin, V. D. Loktionov, and E. S. Mukhtarov, “A combined thermal and strength analysis of the behavior of a WWPR-440 reactor’s vessel during an accident involving core melting,” Therm. Eng. 53, 675–681 (2006).
V. D. Loktionov, “Estimation of conditions and destruction time for WWPR-440 reactor vessel under the case of severe accident with core melting,” Vestn. Mos. Energ. Inst., No. 5, 43–48 (2006).
N. G. Rassokhin, V. D. Loktionov, E. S. Mukhtarov, V. E. Orlov, and K. E. Molodyk, “Numerical simulation of heat transfer when retaining the core melt in the reactor vessel,” Therm. Eng. 45, 495–504 (1998).
E. S. Loktionov, N. I. Mukhtarov, V. E. Yaroshenko, and V. E. Orlov, “Numerical investigation of the reactor pressure vessel behavior under severe accident conditions taking into account of the associated processes of the vessel creep phenomenon and the molten pool natural convection,” Nucl. Eng. Design 191, 31–52 (1998).
M. F. Rogov, S. A. Logvinov, V. S. Granovskii, S. V. Kovtunova, V. B. Khabenskii, V. V. Bezlepkin, and I. V. Kukhtevich, “Analyzing the possibility of retaining the corium in the vessel of a WWPR-640 reactor in a severe accident with a damaged core,” Therm. Eng. 43, 888–892 (1996).
S. I. Pantyushin, A. I. Frizen, S. I. Asadskii, V. P. Semishkin, D. O. Veselov, N. V. Bukin, M. A. Bykov, V. A.Mokhov, A. L. Volchek, Yu. A. Zvonarev, V. F. Strizhov, A. E. Kiselev, A. S. Filippov, N. I. Drobyshevskii, K. S. Dolganov, and E. V. Moiseenko, “Development of system of smelt keeping and reactor vessel cooling at severe beyond design basis accidents for atomic power stations with RU WWPR-600 and RU WWPR TOI,” Vopr. At. Nauki Tekhn. Ser. Obesp. Bezop. AES, No. 30, 45–59 (2011).
V. G. Asmolov, V. N. Zagryazkin, D. F. Tsurikov, Yu. G. Degal’tsev, V. Yu. Vishnevskii, E. K. D’yakov, A. Yu. Kotov, and V. M. Repnikov, “Investigation of the interaction of oxide melt and steel in a WWPR-1000 vessel during a serious accident,” At. Energy 104, 273–277 (2008).
V. S. Bechta, V. B. Granovsky, V. V. Khabensky, V. I. Gusarov, L. P. Almiashev, E. V. Mezentseva, S. Yu. Krushinov, R. A. Kotova, M. Kosarevsky, D. Barrachin, F. Bottomley, F. Fichot, and M. Fischer, “Corium phase equilibria based on MASCA, METCOR and CORPHAD results,” Nucl. Eng. Des. 238, 2761–2771 (2008).
A. Nieminen, The effect of late-phase melt pool configuration on pressure vessel rupture, Proc. 6th Europ. Rev. Meeting on Severe Accident Res. (ERMSAR-2013). Avignon (France), 2013, pp. 1–16.
M. Fukasawa, S. Hayakawa, and M. Saito, “Thermalhydraulic analysis for inversely stratified molten corium in lower vessel,” J. Nucl. Sci. Technol. 45, 873–888 (2008).
M. Fukasawa and S. Tamura, “Thermodynamic analysis for molten corium stratification test MASCA with ionic liquid U–Zr–Fe–O–B–C–FPs database,” J. Nucl. Sci. Technol. 44, 1210–1219 (2007).
K. H. Kang, “Experimental and analytical investigation on the layer inversion of melt pool during the severe accidents in the APR1400,” Proc. 8th Int. Topical Meeting on Nuclear Thermal-Hydraulics, Operation and Safety, China, Shanghai, 2010.
Yu. A. Zvonarev, M. A. Budaev, A. M. Volchek, V. A. Gorbaev, V. N. Zagryazkin, N. P. Kiselev, V. L. Kobzar’, A. V. Konobeev, and D. F. Tsurikov, “Calculation analysis of melt active zone keeping in reactor vessel at severe accidents on atomic power stations with WWPR,” Proc. 7th Int. Sci.-Tech. Conf. “Ensuring of Safety of Atomic Power Stations with WWPR” (Podol’sk, Russia, 2011).
D. F. Tsurikov, V. N. Zagryazkin, V. Yu. Vishnevskii, E.K. D’yakov, A. Yu. Kotov, and V. M. Repnikov, “U–Zr–Fe–O melt density,” At. Energy 107, 247–254 (2009).
V. G. Asmolov, V. N. Zagryazkin, and D. F. Tsurikov, “The thermodynamics of U–Zr–Fe–O melts,” High Temper. 45, 305–312 (2007).
L. A. Dombrovskii, L. I. Zaichik, Yu. A. Zeigarnik, E. S. Mukhtarov, and A. S. Sidorov, “Calculations of heat flowrates to the WWPR-440 reactor vessel during interaction of corium melt with the reactor vessel,” Therm. Eng. 53, 303–306 (2006).
L. A. Dombrovskii, L. I. Zaichik, Yu. A. Zeigarnik, E. S. Mukhtarov, and A. S. Sidorov, “Development of the corium bath during the melting of a WWPR-440 reactor core,” Therm. Eng. 52, 396–402 (2005).
L. A. Dombrovskii, L. I. Zaichik, and Yu. A. Zeigarnik, “A model of effective heat conduction for calculating free-convection heat exchange at large Rayleigh numbers,” Dokl. Phys. 44 (6), 358–361 (1999).
V. D. Loktionov, V. V. Pazhetnov, and G. G. Yan’kov, “Eksperimental-calculation studies of WWPR vessel cooling at severe accident in the conditions of high thermal loadings,” Proc. 8th Int. Sci.-Tech. Conf. “Ensuring of Safety of Atomic Power Stations with WWPR” (Podol’sk, Russia, 2013).
S. A. Logvinov, Yu. A. Bezrukov, and Yu. G. Dragunov, Experimental Foundation of Thermalhydraulic Safety of WWPR Reactors, (IzDAT, Moscow, 2003) [in Russian], pp. 84–90.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © V.D. Loktionov, E.S. Mukhtarov, 2016, published in Teploenergetika.
Rights and permissions
About this article
Cite this article
Loktionov, V.D., Mukhtarov, E.S. Estimation of thermal loads on the VVER vessel under conditions of inversion of the stratified molten pool in a severe accident. Therm. Eng. 63, 648–656 (2016). https://doi.org/10.1134/S0040601516090032
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0040601516090032