Abstract
Different approaches to simulation of momentum, mass, and energy transfer in packed beds are considered. The mathematical model of heat and mass transfer in a wetted packed bed for turbulent gas flow and laminar wave counter flow of the fluid film in sprinkler units of a water-cooling tower is presented. The packed bed is represented as the set of equivalent channels with correction to twisting. The idea put forward by P. Kapitsa on representation of waves on the interphase film surface as elements of the surface roughness in interaction with the gas flow is used. The temperature and moisture content profiles are found from the solution of differential equations of heat and mass transfer written for the equivalent channel with the volume heat and mass source. The equations for calculation of the average coefficients of heat emission and mass exchange in regular and irregular beds with different contact elements, as well as the expression for calculation of the average turbulent exchange coefficient are presented. The given formulas determine these coefficients for the known hydraulic resistance of the packed bed element. The results of solution of the system of equations are presented, and the water temperature profiles are shown for different sprinkler units in industrial water-cooling towers. The comparison with experimental data on thermal efficiency of the cooling tower is made; this allows one to determine the temperature of the cooled water at the output. The technical solutions on increasing the cooling tower performance by equalization of the air velocity profile at the input and creation of an additional phase contact region using irregular elements “Inzhekhim” are considered.
Similar content being viewed by others
References
J. Ch. Slattery, Momentum, Energy, and Mass Transfer in Continua (McGraw-Hill, New York, 1972; Mir, Moscow, 1978) [in Russian].
A. E. Sheidegger, Physics of Liquid Flow through Porous Media (Gostekhizdat, Moscow, 1960) [in Russian].
S. Ergun, Fluid flow through packed columns, Chem. Eng. Sci. 48, 89–94 (1952).
D. Vortmeyer and J. Shuster, Evaluation of steady flow profiles in rectangular and circular packed beds by a variation method, Chem. Eng. Sci. 38, 1691–1699 (1983).
M. A. Gol’tshtik, Transfer Processes in Granular Layer (Inst. Teplofiz. Sib. Otd. Akad. Nauk SSSR, Novosibirsk, 1984) [in Russian].
P. G. Shtern, E. A. Rudenchik, S. V. Turuntaev, I. S. Luk’yanenko, E. G. Bezrukova, and E. K. Popov, Incompressible fluid isothermal axisymmetric flow in radial-type contact apparatuses, J. Eng. Phys. Thermodynam. 56, 555–562 (1989).
I. I. Ioffe, Engineering Chemistry of Heterogeneous Catalysis (Khimiya, Moscow, 1956) [in Russian].
P. G. Shtern, E. A. Rudenchik, and I. S. Luk’yanenko, E. G. Bezrukova, and S. V. Turuntaev, Transfer processes in granular beds, Theor. Found. Chem. Eng. 31, 386–391 (1997).
V. L. Fedyaev, E. M. Vlasov, and R. F. Gainullin, Efficiency of irrigative cooling towers, Vestn. Mezhd. Akad. Kholoda, No. 4, 35–39 (2012).
O. S. Dmitrieva and A. V. Dmitriev, Development of the new cooling towers for increasing energy efficiency of industrial plants, Vestn. Kazan. Tekhnol. Univ., 17 (6), 134–136 (2014).
A. G. Laptev and I. A. Ved’gaeva, Equipment and Calculation of Industrial Cooling Towers (Kazan. Gos. Energ. Univ., Kazan, 2004) [in Russian].
V. S. Galustov and Yu. P. Belichenko, Contemporary Methods, Systems and Equipment for Reused Water Cooling (Neftemash, Moscow, 1988) [in Russian].
V. S. Ponomarenko, On reconstruction of fan-driven cooling towers, Khim. Prom., 92, (7), 40–45 (1996).
V. M. Ramm, Absorption of Gases (Khimiya, Moscow, 1976) [in Russian].
L. P. Kholpanov and V. Ya. Shkadov, Hydrodynamics and Heat and Mass Exchange with Interface (Nauka, Moscow, 1990) [in Russian].
N. G. Deen, T. Solberg, and B. H. Hjertager, Numerical simulation of the gas-liquid flow in a cross-sectioned bubble column, Proc. 14th Int. Congress on Chem. Proc. Eng., Praha, 2000, pp. 1–18.
G. F. Hewitt, Multiphase Science and Technology, (Hemisphere, Washington, 1987).
R. I. Nigmatullin, Dynamics of Multiphase Media, (Nauka, Moscow, 1987), Part. 1.
D. A. Drew and R. T. Lahey, Application of general constitutive principles to the derivation of multydimentional two-phase low equations, Int. J. Multiphase Flow 5, 243–264 (1979).
A. G. Laptev, Boundary Layer Models and Calculation of Heatmassexchange Processes (Kazan. Gos. Univ., Kazan, 2007) [in Russian].
A. G. Laptev and T. M. Farakhov, The mathematical model of heat transfer in channels containing packed and granular layers, Therm. Eng. 62, 76–80 (2015). doi 10.1134/S0040601514110032
A. G. Laptev and T. M. Farakhov, Heat transfer model in granular and packed layers, Izv. Vyssh. Uchebn. Zaved., Khim. Khim. Tekhnol., Ser. Khim. Khim. Prom. 56 (6), 92–96 (2013).
M. M. Farakhov, A. G. Laptev, and T. M. Farakhov, Gas phase mass transfer coefficient determination of irradiated packed column in countercurrent, Mezhd. Zh. Priklad. Fundam. Issled., Nos. 9–2, 50–53 (2014).
A. G. Laptev, T. M. Farakhov, and O. G. Dudarovskaya, Models of turbulent viscosity and mixing in channels and packed flow-through mixers, Russ. J. Appl. Chem., 86, 1046–1055 (2013).
A. M. Kagan, A. S. Pushnov, A. G. Laptev, and M. I. Farakhov, Contact Nozzles of Industrial Heatmassexchange Plants, Ed. by A. G. Laptev, (Otechestvo, Kazan, 2013) [in Russian].
A. G. Laptev, M. I. Farakhov, and N. G. Mineev, Foundations of Calculation and Modernization of Heatmasstransfer Plants in Oil Chemistry (Kazan. Gos. Energ. Univ., Kazan, 2010) [in Russian].
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.G. Laptev, E.A. Lapteva, 2016, published in Teploenergetika.
Rights and permissions
About this article
Cite this article
Laptev, A.G., Lapteva, E.A. Mathematical model and calculation of water-cooling efficiency in a film-filled cooling tower. Therm. Eng. 63, 724–729 (2016). https://doi.org/10.1134/S004060151607003X
Published:
Issue Date:
DOI: https://doi.org/10.1134/S004060151607003X