Skip to main content
Log in

Protection relay of phase-shifting device with thyristor switch for high voltage power transmission lines

  • Published:
Thermal Engineering Aims and scope Submit manuscript

Abstract

Problems of functioning of differential current protection systems of phase shifting devices (PSD) with mechanically changed coefficient of transformation of shunt transformer are analyzed. Requirements for devices of protection of PSD with thyristor switch are formulated. Based on use of nonlinear models of series-wound and shunt transformers of PSD modes of operation of major protection during PSD, switching to zero load operation and to operation under load and during short circuit operation were studied for testing PSD with failures. Use of the principle of duplicating by devices of differential current protection (with realization of functions of breaking) of failures of separate pares of PSD with thyristor switch was substantiated. To ensure protection sensitivity to the shunt transformer winding short circuit, in particular, to a short circuit that is not implemented in the current differential protection for PSD with mechanical switch, the differential current protection reacting to the amount of primary ampere-turns of high-voltage and low-voltage winding of this transformer was designed. Studies have shown that the use of differential current cutoff instead of overcurrent protection for the shunt transformer wndings allows one to provide the sensitivity during thyristor failure with the formation of a short circuit. The results of simulation mode for the PSD with switch thyristor designed to be installed as switching point of Voskhod-Tatarskaya-Barabinsk 220 kV transmission line point out the efficiency of the developed solutions that ensure reliable functioning of the PSD.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Protection of Phase Angle Regulating Transformers (PAR), IEEE Special Publication, 58 p. (1999)

  2. Interactive map of European hey energy infrastructure “projects of common interest” (PCI). http://ec.europa.eu/energy/infrastructure/pci/pci_en.htm

  3. M. A. Ibrahim and F. P. Stacom, “Phase angle regulating transformer protection,” IEEE Transaction on Power Delivery 9(1), 394–404 (1994).

    Article  Google Scholar 

  4. I. M. Akhmetov and V. F. Lachugin, “Relay protection of phase switch devices of different configuration,” ELEKTRO. Elektrotekhn., Electroenerg., Elektrotekhn. Prom., No. 5, 28–32 (2013).

    Google Scholar 

  5. Electrical Installations Code (ENAS, Moscow, 2003) [in Russian].

  6. Regulations for Relay Protection. Issue 13 B. Relay Protection of Reducing Transformersand Autotransformers of 110–500 kV: Calculations (Energoatomizdat, Moscow, 1985) [in Russian].

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to V. F. Lachugin.

Additional information

Original Russian Text © V.F. Lachugin, D.I. Panfilov, I.M. Akhmetov, M.G. Astashev, A.V. Shevelev, 2014, published in Izvestiya RAN. Energetika.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Lachugin, V.F., Panfilov, D.I., Akhmetov, I.M. et al. Protection relay of phase-shifting device with thyristor switch for high voltage power transmission lines. Therm. Eng. 61, 1040–1047 (2014). https://doi.org/10.1134/S0040601514140067

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S0040601514140067

Keywords

Navigation