Skip to main content
Log in

Influence of wind on seepage of gases through the shell of smoke stacks

  • Environment Protection
  • Published:
Thermal Engineering Aims and scope Submit manuscript

Abstract

The effect of wind on the distribution of static pressure at the outer surface of thermal power station smoke stacks is considered. It is shown that the wind velocity and direction are the main factors influencing on the seepage of gases through the shell of smoke stacks when no excess static pressure is exerted from the side of flue gases. A procedure for determining the wind influence zone on the seepage processes in smoke stacks is proposed. This procedure supplements the previously adopted approach for estimating the operating modes of smoke stacks taking the influence of wind into account. The proposed procedure is used for determining if seepage of flue gases is possible and for finding the wind influence lower boundary for different operating conditions. The described procedure can be used in designing new smoke stacks and in repairing and retrofitting existing ones, and also in developing new techniques for revealing through flaws in smoke stack shells during their examination by means of an infrared imager. As an example, the results from infrared flaw detection of a smoke stack are presented, which testify that a change occur in the direction of seepage processes taking place in a reinforced-concrete shell when a change occurs in the wind effect pattern.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. V. F. Rezinskikh and E. A. Grin’, “Reliability and Safety of Thermal Power Stations in Russia at the Present Stage: Problems and Future Objectives,” Therm. Eng., No. 1, 1 (2010).

    Google Scholar 

  2. K. E. Aronson, Yu. M. Brodov, P. N. Plotnikov, et al., “An Analysis of Indicators Characterizing the Reliability of Auxiliary Equipment of Power Units,” Therm. Eng., No. 8, 623 (2011).

    Google Scholar 

  3. SP (Code of Practice) 13-101-99: Regulations for Supervising, Examining, and Carrying out Maintenance and Repair of Industrial Smoke and Ventilation Stacks.

  4. L. A. Rikhter, “Aerodynamic Characteristics of Smoke Stacks,” Elektr. Stn., No. 4, 11–14 (1968).

    Google Scholar 

  5. L. A. Rikhter and E. I. Gavrilov, “Excess Pressure in Smoke Stacks and Ways for Eliminating It,” Elektr. Stn., No. 4, 38–41 (1974).

    Google Scholar 

  6. E. I. Gavrilov, “A Graphic-Analytical Method for Determining Static Pressures in the Smoke Stack Gas Removal Channels,” Therm. Eng., No. 8 (1978).

    Google Scholar 

  7. E. P. Volkov, E. I. Gavrilov, and F. D. Duzhikh, Gas Removal Stacks of Thermal and Nuclear Power Stations (Energoatomizdat, Moscow, 1984) [in Russian].

    Google Scholar 

  8. L. A. Rikhter, Gas-Air Paths of Thermal Power Stations (Energoatonizdat, Moscow, 1984) [in Russian].

    Google Scholar 

  9. F. P. Duzhikh, V. P. Osolovskii, and M. G. Ladygichev, Industrial Smoke and Ventilation Stacks (Teplotekhnik, Moscow, 2004) [in Russian].

    Google Scholar 

  10. VSN (Departmental Construction Regulations) 383-77: A Manual for Carrying out Thermal and Aerodynamic Calculation of Reinforced-Concrete Smoke Stacks with Back pressure in the Gap between the Shaft and Lining (TsBNTI Minmontazhspetsstroi SSSR, Moscow, 1979) [in Russian].

  11. L. A. Rikhter, E. I. Gavrilov, and V. B. Prokhorov, “Factors and Conditions Giving Rise to a Smoke Stack Self-Wrapping Process,” Therm. Eng., No. 11 (1980).

    Google Scholar 

  12. L. A. Rikhter, E. I. Gavrilov, and V. B. Prokhorov, “Studying the Smoke Stack Self-Wrapping Phenomenon in a Wind Tunnel,” Izv. Vyssh. Uchebn. Zaved., Energetika, No. 4, 47–51 (1985).

    Google Scholar 

  13. Climate of Russia (Gidrometeoizdat, St. Petersburg, 2001) [in Russian].

  14. P. A. Vorontsov, Aerodynamic Investigations of an Atmospheric Boundary Layer (Gidrometeoizdat, Moscow, 1960) [in Russian].

    Google Scholar 

  15. SP (Code of Practice) 20.13330.2011: Loads and Effects.

  16. SNiP (Construction Code) 23-01-99*: Climatology.

  17. A. A. Zhukauskas and I. Zhyugda, Heat Transfer of a Cylinder in Cross Flow of Liquid (MOKSLAS, Vilnyus, 1979) [in Russian].

    Google Scholar 

  18. E. Achenbach, “Total and Local Heat Transfer from a Smooth Circular Cylinder in Cross-Flow at High Reynolds Number,” Int. J. Heat Mass Transfer 18, 1387 (1975).

    Article  Google Scholar 

  19. A. Roshko, “Experiments on the Flow past a Circular Cylinder at Very High Reynolds Number,” J. Fluid Mech., No. 10, 345–356 (1961).

    Google Scholar 

  20. A. P. Maneev and Yu. V. Strizhko, “The Influence of Wind Load on Seepage of Flue Gases through the Construction Joints of Reinforced-Concrete Smoke Stacks and Methods for Eliminating Release of Condensate,” Elektr. Stn., No. 1, 2–4 (2002).

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Additional information

Original Russian Text © A.P. Maneev, M.I. Nizovtsev, V.I. Terekhov, 2013, published in Teploenergetika.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Maneev, A.P., Nizovtsev, M.I. & Terekhov, V.I. Influence of wind on seepage of gases through the shell of smoke stacks. Therm. Eng. 60, 248–254 (2013). https://doi.org/10.1134/S004060151304006X

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S004060151304006X

Keywords

Navigation