Abstract
The microstructure, phase composition, and mechanical properties of new low-scandium Al–6.0Mg–0.2Mn–0.05Sc–0.25Zr–0.3Yb and Al–6.0Mg–0.2Cr–0.05Sc–0.25Zr–0.3Yb alloys have been studied. Ytterbium leads to the formation of a quaternary phase (Al, Mg, Yb, Si) of crystallization origin in the Al–6.0Mg–0.2Mn–0.05Sc–0.25Zr–0.3Yb alloy. Phases have been detected in the Al–6.0Mg–0.2Cr–0.05Sc–0.25Zr–0.3Yb ingot, (Al, Fe, Si), (Al, Mg, Yb, Si), and (Al, Fe, Yb). The greatest strengthening has been achieved in ingots after annealing at 440°C for 10 hours owing to the precipitation of Al3(Sc, Zr, Yb) dispersed inclusions (L12 phase). The optimal combination of strength characteristics and plasticity have been reached in the rolled sheet made of Al–6.0Mg–0.2Cr–0.05Sc–0.25Zr–0.3Yb alloy by annealing at 200°C for 1 hour: yield stress of 356 MPa, ultimate tensile strength of 443 MPa, and elongation of 10.5%.
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1134%2FS0031918X20010111/MediaObjects/11508_2020_3328_Fig1_HTML.gif)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1134%2FS0031918X20010111/MediaObjects/11508_2020_3328_Fig2_HTML.gif)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1134%2FS0031918X20010111/MediaObjects/11508_2020_3328_Fig3_HTML.gif)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1134%2FS0031918X20010111/MediaObjects/11508_2020_3328_Fig4_HTML.gif)
Similar content being viewed by others
REFERENCES
S. P. Wen, K. Y. Gao, H. Huang, W. Wang, and Z. R. Nie, “Precipitation evolution in Al–Er–Zr alloys during aging at elevated temperature,” J. Alloys Compd. 574, 92–97 (2013).
C. Booth-Morrison, D. C. Dunand, and D. N. Seidman, “Coarsening resistance at 400°C of precipitation-strengthened Al–Zr–Sc–Er alloys,” Acta Mater. 59, 7029–7042 (2011).
Y. Zhang, H. Gao, Y. Kuai, Y. Han, J. Wang, B. Sun, S. Gu, and W. You, “Effects of Y additions on the precipitation and recrystallization of Al–Zr alloys,” Mater. Charact. 86, 1–8 (2013).
H. Gao, W. Feng, and Y. Wang, “Structural and compositional evolution of Al3(Zr,Y) precipitates in Al–Zr–Y alloy,” Mater. Charact. 121, 195–198 (2016).
A. V. Pozdniakov, R. Y. Barkov, A. S. Prosviryakov, A. Y. Churyumov, I. S. Golovin, and V. S. Zolotorevskiy, “Effect of Zr on the microstructure, recrystallization behavior, mechanical properties and electrical conductivity of the novel Al–Er–Y alloy,” J. Alloys Compd. 765, 1–6 (2018).
C. Tang and D. Zhou, “Precipitation hardening behavior of dilute binary Al–Yb alloy,” Trans. Nonferrous Met. Soc. China 24, 2326−2330 (2014).
Y. Zhang, K. Gao, S. Wen, H. Huang, W. Wang, Z. Zhu, Z. Nie, and D. Zhou, “Determination of Er and Yb solvuses and trialuminide nucleation in Al–Er and Al–Yb alloys,” J. Alloys Compd. 590, 526–534 (2014).
S. P. Wen, K. Y. Gao, H. Huang, W. Wang, and Z. R. Nie, “Role of Yb and Si on the precipitation hardening and recrystallization of dilute Al–Zr alloys,” J. Alloys Compd. 599, 65–70 (2014).
G. Peng, K. Chen, H. Fang, and S. Chen, “A study of nanoscale Al3(Zr,Yb) dispersoids structure and thermal stability in Al–Zr–Yb alloy,” Mater. Sci Eng., A 535, 311– 315 (2012).
Q. Vo. Nhon, B. Davaadorj, S. Amirreza, R. Evander, and D. C. Dunand, “Effect of Yb microadditions on creep resistance of a dilute Al–Er–Sc–Zr alloy,” Materialia 4, 65–69 (2018).
Y. Zhang, W. Zhou, H. Gao, Y. Han, K. Wang, J. Wang, B. Sun, S. Gu, and W. You, “Precipitation evolution of Al–Zr–Yb alloys during isochronal aging,” Scr. Mater. 69, 477–480 (2013).
M. E. Van Dalen, T. Gyger, D. C. Dunand, and D. N. Seidman, “Effects of Yb and Zr microalloying additions on the microstructure and mechanical properties of dilute Al–Sc alloys,” Acta Mater. 59, 7615–7626 (2011).
A. V. Pozdniakov, A. A. Aytmagambetov, S. V. Makhov, and V. I. Napalkov, “Effect of impurities of Fe and Si on the structure and strengthening upon annealing of the Al–0.2% Zr–0.1% Sc alloys with and without Y additive,” Phys. Met. Metallogr. 118, 479–484 (2017).
A. V. Pozdnyakov, A. A. Osipenkova, D. A. Popov, S. V. Makhov, and V. I. Napalkov, “Effect of low additions of Y, Sm, Gd, Hf and Er on the structure and hardness of alloy Al–0.2% Zr–0.1% Sc,” Met. Sci. Heat Treat. 58, 537–542 (2017).
H. C. Fang, P. J. Shang, L. P. Huang, K. H. Chen, G. Liu, and X. Xiong, “Precipitates and precipitation behavior in Al–Zr–Yb–Cr alloys,” Mater. Lett. 75, 192–195 (2012).
L. Z. He, X. H. Li, X. T. Liu, X. J. Wang, H. T. Zhang, and J. Z. Cui, “Effects of homogenization on microstructures and properties of a new type Al–Mg–Mn–Zr–Ti–Er alloy,” Mater. Sci. Eng., A 527, 7510–7518 (2010).
H. L. Hao, D. R. Ni, Z. Zhang, D. Wang, B. L. Xiao, and Z. Y. Ma, “Microstructure and mechanical properties of Al–Mg–Er sheets jointed by friction stir welding,” Mater. Des. 52, 706–712 (2013).
A. V. Pozdniakov, V. Yarasu, R. Yu. Barkov, O. A. Yakovtseva, S. V. Makhov, and V. I. Napalkov, “Microstructure and mechanical properties of novel Al–Mg–Mn–Zr–Sc–Er alloy,” Mater. Lett. 202, 116–119 (2017).
F. Cao, X. Zhu, S. Wang, L. Shi, G. Xu, and J. Wen, “Quasi-superplasticity of a banded-grained Al–Mg–Y alloy processed by continuous casting-extrusion,” Mater. Sci. Eng., A 690, 433–445 (2017).
R. Yu. Barkov, A. V. Pozdniakov, E. Tkachuk, and V. S. Zolotorevskiy, “Effect of Y on microstructure and mechanical properties of Al–Mg–Mn–Zr–Sc alloy with low Sc content,” Mater. Lett. 217, 135–138 (2018).
M. Song, Z. Wu, and Y. He, “Effects of Yb on the mechanical properties and microstructures of an Al–Mg alloy,” Mater. Sci. Eng., A 497, 519–523 (2008).
G. Peng, K. Chen, H. Fang, and S. Chen, “EIS study on pitting corrosion of 7150 aluminum alloy in sodium chloride and hydrochloric acid solution,” Mater. Des. 36, 279–283 (2012).
H. C. Fang, K. H. Chen, X. Chen, H. Chao, and G. S. Peng, “Effect of Cr, Yb and Zr additions on localized corrosion of Al–Zn–Mg–Cu alloy,” Corr. Sci. 51, 2872–2877 (2009).
K. H. Chen, H. C. Fang, Z. Zhang, X. Chena, and G. Liu, “Effect of Yb, Cr, and Zr additions on recrystallization and corrosion resistance of Al–Zn–Mg–Cu alloys,” Mater. Sci. Eng., A 497, 426–431 (2008).
R. W. Hyland, “Homogeneous nucleation kinetics of Al3Sc in a dilute Al–Sc alloy,” Metall. Trans. A 23, 1947–1955 (1992).
S. Iwamura and Y. Miura, “Loss in coherency and coarsening behavior of Al3Sc precipitates,” Acta Mater. 52, 591–600 (2004).
C. B. Fuller and D. N. Seidman, “Temporal evolution of the nanostructure of Al(Sc,Zr) alloys: Part II-coarsening of Al3(Sc1 – xZrx) precipitates,” Acta Mater. 53, 5415–5428 (2005).
V. S. Zolotorevskiy, R. I. Dobrojinskaja, V. V. Cheverikin, E. A. Khamnagdaeva, A. V. Pozdniakov, V. S. Levchenko, and E. S. Besogonova, “Evolution of structure and mechanical properties of Al–4.7Mg–0.32Mn–0.21Sc–0.09Zr alloy sheets after accumulated deformation during rolling,” Phys. Met. Metallogr. 117, 1163–1169 (2016).
V. S. Zolotorevskiy, R. I. Dobrojinskaja, V. V. Cheverikin, E. A. Khamnagdaeva, A. V. Pozdniakov, V. S. Levchenko, and E. S. Besogonova, “Strength and substructure of Al–4.7Mg–0.32Mn–0.21Sc–0.09Zr alloy sheets,” Phys. Met. Metallogr. 118, 407–414 (2017).
Funding
This work was supported by the Russian Science Foundation (project no. 17-79-10256).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by O. Golosova
Rights and permissions
About this article
Cite this article
Pozdnyakov, A.V., Barkov, R.Y. & Levchenko, V.S. Influence of Yb on the Phase Composition and Mechanical Properties of Low-Scandium Al–Mg–Mn–Zr–Sc and Al–Mg–Cr–Zr–Sc Alloys. Phys. Metals Metallogr. 121, 84–88 (2020). https://doi.org/10.1134/S0031918X20010111
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0031918X20010111