Abstract
Rate of steady-state swelling of fuel-element sheaths made of the 06Kh16N15M2G2TFR steel in the course of their operation in a BN-600 reactor has been calculated. In the calculations, the diffusion characteristics of point defects and the results of the determination of the characteristics of the irradiation-induced porosity have been used. The dependence of the dose rate of steady-state swelling on neutron-irradiation characteristics has been analyzed. It has been established that the dose rate of swelling at the steady-state stage is independent of the energy of migration of vacancies and the rate of generation of atomic displacements.
Similar content being viewed by others
References
A. G. Zaluzhnyi, “Effect of boundary conditions on the kinetics of helium release from structural materials,” Phys. Met. Metallogr. 116, 1103–1107 (2015).
N. V. Glushkova, I. A. Portnykh, and A. V. Kozlov, “Mechanism of the influence of transmutation helium produced in the claddings of fuel elements made of an austenitic steel ChS-68 during neutron irradiation on the formation of pores,” Phys. Met. Metallogr. 108, 263–269 (2009).
I. A. Portnykh, A. V. Kozlov, and V. L. Panchenko, “Effect of dose and temperature parameters of neutron irradiation to maximum damaging dose of 77 dpa on characteristics of porosity formed in steel 0.07C–16Cr–19Ni–2Mo–2Mn–Ti–Si–V–P–B,” Phys. Met. Metallogr. 115, 625–633 (2014).
A. V. Kozlov and I. A. Portnykh, “Conditions for the achievement of the stage of stationary radiation swelling,” Phys. Met. Metallogr. 103, 105–109 (2007).
A. V. Kozlov and I. A. Portnykh, “Relation between the rate of radiation swelling and the growth and coalescence of radiaton-induced voids,” Vopr. At. Nauki Tekhn., Ser. Materialov. Novye Mater., No. 2, 3–13 (2008).
A. V. Kozlov and I. A. Potnykh, ”Dependence of steadystate radiation swelling rate of 10.1C–16Cr–15Ni–2Mo–2Mn–Ti–Si austenitic steel on dpa rate and irradiation temperature,” J. Nuclear Mater. 386–388, 147–151 (2009).
A. V. Tselishchev, V. S. Ageev, Yu. P. Budanov, A. G. Ioltukhovskii, N. M. Mitrofanova, M. V. Leont’eva-Smirnova, I. A. Shkabura, L. M. Zabud’ko, A. V. Kozlov, and A. V. Povstyanko, “Development of structural steel for fuel elements and fuel assemblies of sodium-cooled fast reactors,” At. Energy 108, 274–280 (2010).
A. V. Kozlov, “Dependence of the concentration of point defects in the ChS-68 austenitic steel on the rate of their generation and temperature upon neutron irradiation,” Phys. Met. Metallogr. 107, 534–541 (2009).
A. V. Kozlov, “Radiation effects in austenitic steels upon neutron irradiation and their effect on physical and mechanical properties,” Izv. Vyssh. Uchebn. Zaved. Yadern. Energ., No. 1, 196–210 (2011).
A. V. Kozlov, I. A. Portnykh, A. V. Tselishchev, O. B. Shilo, and O. I. Asiptsov, “Energy of vacancy migration in 0.06C–16Cr–15Ni–2Mo–2Mn–Ti–Si–V–B and 0.07C–16Cr–19Ni–2Mo–2Mn–Ti–Si–V–P–B cladding steels,” Russ. Metall. (Metally), 2014, 412–417 (2014).
F. A. Garner, “Irradiation performance of cladding and structural steels in liquid metal reactors,” Mater. Sci. Tech.: A Compr. Treat. 10, 419–543 (1994).
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.V. Kozlov, I.A. Portnykh, 2016, published in Fizika Metallov i Metallovedenie, 2016, Vol. 117, No. 8, pp. 871–874.
Rights and permissions
About this article
Cite this article
Kozlov, A.V., Portnykh, I.A. Dependence of the rate of steady-state swelling of fuel-element claddings made of ChS68 steel on the characteristics of neutron irradiation. Phys. Metals Metallogr. 117, 843–846 (2016). https://doi.org/10.1134/S0031918X1608007X
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0031918X1608007X