Abstract
Results of experimental and numerical modeling of a supersonic flow around a cylinder with a frontal gas-permeable high-porosity insert aligned at different angles of attack are presented. The experiments are performed in a supersonic wind tunnel at the Mach number \(\mbox{M}_{\infty }=7\) and unit Reynolds number \(\mbox{Re}_{1}=1.5 \cdot 10^6\) m\(^{ - 1}\) in the range of the angles of attack \(0–25^\circ\). The numerical simulations are performed by means of solving three-dimensional Reynolds-averaged Navier–Stokes equations with the use of a three-dimensional ring skeleton model of the porous material. The drag and lift coefficients for a cylinder with a 95% porosity and pore diameter of 2 mm are obtained for different values of the insert length and angle of attack.
Similar content being viewed by others
REFERENCES
V. M. Fomin, S. G. Mironov, and K. M. Serdyuk, “Reduction of the Wave Drag of Bodies in a Supersonic Flow by Using Porous Materials," Pisma Zh. Tekh. Fiz. 35 (3), 39–45 (2009).
I. A. Bedarev, S. G. Mironov, K. M. Serdyuk, et al., “Physical and Mathematical Modeling of a Supersonic Flow around a Cylinder with a Porous Insert," Prikl. Mekh. Tekh. Fiz. 52 (1), 13–23 (2011) [J. Appl. Mech. Tech. Phys. 52 (1), 9–17 (2011)].
V. M. Fomin, V. I. Zapryagaev, A. V. Lokotko, and V. F. Volkov, “Effect of Gas-Permeable Regions of the Surface on the Aerodynamic Characteristics of the Body of Revolution at Supersonic Velocities," Dokl. Akad. Nauk 427 (5), 627–628 (2009).
V. M. Fomin, V. I. Zapryagaev, A. V. Lokotko, et al., “Aerodynamic Characteristics of a Body of Revolution with Gas-Permeable Surface Areas," Prikl. Mekh. Tekh. Fiz. 51 (1), 79–88 (2010) [J. Appl. Mech. Tech. Phys. 51 (1), 65–73 (2010)].
V. M. Fomin, B. V. Postnikov, and K. A. Lomanovich, “Changing the Regimes of the Supersonic Flow Past a Step by Means of Using Gas-Permeable Inserts," Pisma Zh. Tekh. Fiz. 41(18), 68–73 (2015).
A. A. Maslov, S. G. Mironov, T. V. Poplavskaya, S. V. Kirilovskiy, “Supersonic Flow around a Cylinder with a Permeable High-Porosity Insert: Experiment and Numerical Simulation," J. Fluid Mech.867, 611–632 (2019).
S. G. Mironov, A. A. Maslov, T. V. Poplavskaya, and S. V. Kirilovskiy, “Modeling of a Supersonic Flow around a Cylinder with a Gas-Permeable Porous Insert," Prikl. Mekh. Tekh. Fiz.56 (4), 12–22 (2015) [J. Appl. Mech. Tech. Phys.56 (4), 549–557 (2015)].
S. V. Kirilovskiy, A. A. Maslov, S. G. Mironov, and T. V. Poplavskaya, “Application of a Skeleton Model of a High-Porosity Cellular Material for Modeling a Supersonic Flow around a Cylinder with a Frontal Gas-Permeable Insert," Izv. Ross. Akad. Nauk, Mekh. Zhidk. Gaza, No. 3, 78–86 (2018).
S. G. Mironov, T. V. Poplavskaya, S. V. Kirilovskiy, and A. A. Maslov, “Similarity Criterion for a Supersonic Flow around a Cylinder with a Frontal High-Porosity Cellular Insert," Pisma Zh. Tekh. Fiz. 44 (6), 3–10 (2018).
F. L. Daum and G. Gyarmathy, “Condensation of Air and Nitrogen in Hypersonic Wind Tunnels," AIAA J. 6 (3), 458–465 (1968).
S. G. Mironov, S. V. Kirilovskiy, T. S. Militsina, et al., “Effect of the Structure of Skeleton Models of Cellular Materials on the Drag of a Cylinder with a Frontal Gas-Permeable Insert in a Supersonic Flow," J. Phys.: Conf. Ser. 1404, 012032 (2019).
V. I. Kornilov and V. I. Lysenko, “Investigation of the Aerodynamic Characteristics of Cylindrical Bodies in a Supersonic Gas Flow," Vest. Novosib. Gos. Univ., Ser. Fiz. 6 (4), 16–24 (2011).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Mironov, S.G., Kirilovskiy, S.V., Poplavskaya, T.V. et al. PHYSICAL AND MATHEMATICAL MODELING OF A SUPERSONIC FLOW AROUND BODIES WITH GAS-PERMEABLE POROUS INSERTS AT AN ANGLE OF ATTACK. J Appl Mech Tech Phy 61, 693–699 (2020). https://doi.org/10.1134/S0021894420050028
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0021894420050028