Abstract
The reference polymers and polymers with molecular imprints of carboxylic acids (MIPs-CA)—propionic (MIP-Propionic) and butyric (MIP-Butyric) acids—were synthesized on the surface of piezoelectric sensors using aromatic compounds by the non-covalent imprinting method. A molecularly imprinted polymer (MIP) is a polymer produced through molecular imprinting, which leaves cavities in the polymer matrix with affinity for a chosen “template” target molecule. The values of the imprinting factor and selectivity coefficients were calculated to assess the ability of MIPs-CA to recognize the target molecules. It was shown that the sensors modified by the molecularly imprinted polymers exhibited high selectivity for the acid that was a template during their synthesis. The detection limits for propionic and butyric acids were 7.40 × 10–6 and 8.81 × 10–6 g/dm3, respectively. Correctness of the carboxylic acid determination in model solutions was verified in the spike/recovery tests. The relative standard deviation was less than 10%. The modified piezoelectric sensors were tested in analysis of the intermediate products of edible ethanol production (distillate of fermentation mixture, epurate, bottom liquids of columns). The correctness of the determination of carboxylic acids in liquids was evaluated using an Agilent Technologies 7890B GC System. The difference in the results of acid determination between both methods (piezoelectric sensor and chromatography–mass spectrometry) did not exceed 6%. The modified piezosensors expand the potential of rapid determination of carboxylic acids in the intermediate products of ethyl alcohol production.
Similar content being viewed by others
REFERENCES
Handbook of Alcoholic Beverages: Technical, Analytical and Nutritional Aspects, Buglass, A.J., Ed., New York: Wiley, 2011.
Nikitina, S.Yu., Skhemotekhnika i metodiki rascheta brago-rektifikatsionnykh ustanovok (Circuitry and the Rectification Installations Calculation Methods), Voronezh: Voronezh. Gos. Arkh.-Stroit. Univ., 2013.
Nikitina, S.Yu., Shakhov, S.V., Pyl’nyi, D.V., et al., Analytical quality control of rectified ethanol, vodka and alcohol distillates, Pishchevaya Prom-st., 2018, no. 6, pp. 57–60.
Rudakov, O.B. and Nikitina, S.Yu., Trends in the analytical quality control of the potable ethanol, Anal. Kontrol, 2017, vol. 21, no. 3, pp. 180–196.
Savchuk, S.A., Nuzhnyi, V.P., and Rozhanets, V.V., Khimiya i toksikologiya etilovogo spirta i napitkov, izgotovlennykh na ego osnove: Khromatograficheskii analiz spirtnykh napitkov (Chemistry and Toxicology of Ethyl Alcohol and Alcoholic Beverages: Chromatographic Analysis of Alcoholic Beverages), Moscow: Lenand, 2017.
Kalach, A.V., Zyablov, A.N., and Selemenev, V.F., Sensory v analize gazov i zhidkostei (Use of Sensors for the Analysis of Gases and Liquids), Voronezh: LIO, 2011.
Zyablov, A.N., Kalach, A.V., Zhibrova, Yu.A., et al., Determination of glycine in aqueous solutions using a molecularly imprinted polymer-modified piezosensor, J. Anal. Chem., 2010, vol. 65, no. 1, pp. 91–93.
Dmitrienko, S.G., Irkha, V.V., Duisebaeva, T.B., et al., Synthesis and study of the sorption properties of 4-hydroxybenzoic acid-imprinted polymers, J. Anal. Chem., 2006, vol. 61, no. 1, pp. 14–19.
Gendrikson, O.D., Zherdev, A.V., and Dzantiev, B.B., Molecularly imprinted polymers and their use in biochemical analysis, Usp. Biol. Khim., 2006, vol. 46, pp. 149–192.
Lisichkin, G.V. and Krutyakov, Yu.A., Molecularly imprinted materials: synthesis, properties, applications, Russ. Chem. Rev., 2006, vol. 75, no. 10, pp. 901–918.
Zyablov, A.N., Govorukhin, S.I., Duvanova, O.V., et al., Flow-injection determination of valine with piezoelectric sensors, modifided by molecular imprinted polymers, Anal. Kontrol, 2014, vol. 18, no. 4, pp. 438–441.
Semiletova, E.S., Zyablov, A.N., Selemenev, V.F., et al., Thermogravimetric analysis of the polymers, Sorbtsionnye Khromatogr. Protsessy, 2012, vol. 12, no. 5, pp. 734–738.
Duvanova, O.V., Volodina, L.V., Zyablov, A.N., et al., Analysis of the morphology of the surface of polymers with molecular imprints of oleic and palmitic acids, Sorbtsionnye Khromatogr. Protsessy, 2013, vol. 13, no. 6, pp. 884–890.
Volodina, L.V., Duvanova, O.V., Zyablov, A.N., et al., Analysis of the structure and composition of polymers using molecular imprints of oleic and palmitic acids, Sorbtsionnye Khromatogr. Protsessy, 2014, vol. 14, no. 1, pp. 111–120.
Duvanova, O.V., Dashina, A.I., Zyablov, A.N., et al., Evaluation of the properties of molecularly imprinted polymers for determination of the fatty acids in fluids by piezoelectric sensors, Vestn. Voronezh. Gos. Agrar. Univ., 2014, no. 3 (42), pp. 147–157.
Zyablov, A.N., Duvanova, O.V., et al., RF Patent 137946, Byull. Izobret., 2014, no. 16.
Zyablov, A.N., Duvanova, O.V., et al., RF Patent 138636, Byull. Izobret., 2014, no. 8.
Osnovy analiticheskoi khimii (Fundamentals of Analytical Chemistry), Zolotov, Yu.A., Ed., Moscow: Akademiya, 2012, vol. 1.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
We have no conflicts of interest to declare.
Additional information
Translated by P. Vlasov
Rights and permissions
About this article
Cite this article
Cao Nhat Linh, Duvanova, O.V., Nikitina, S.Y. et al. The Use of Piezosensors for Determination of Carboxylic Acids in the Intermediate Products of Edible Ethanol Production. Inorg Mater 56, 1379–1383 (2020). https://doi.org/10.1134/S0020168520140083
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0020168520140083