Abstract—
Amorphous dielectric WO3 films with a surface roughness from 4 to 5 nm have been grown by room-temperature pulsed laser deposition on quartz and c-sapphire substrates using metallic targets. We have examined the effect of the nature of the substrates and the oxygen pressure during the growth process on the transmission spectrum of the WO3 films in the range from 400 to 2000 nm. The parameters of the films have been shown to depend on the oxygen pressure during the growth process. Raising the oxygen pressure from 20 to 60 mTorr during the film growth process increases the transmission of the WO3 films from 40 to 75% in the visible and UV spectral regions and from 10 to 70% in the IR. With increasing oxygen pressure during film growth, the band gap of the WO3 films increases from 3.01 to 3.34 eV in the case of sapphire substrates and from 2.95 to 3.42 eV in the case of quartz substrates, being only slightly dependent on the nature of the substrate. Using a WO3 film grown at room temperature, we have fabricated the first thin-film liquid-electrolyte electrochromic cell. Its transmission in the spectral range from 300 to 900 nm drops by 30% at an applied voltage of 2.5 V, with a coloration time on the order of 2 min.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
REFERENCES
Yano, M., Kuwagata, W., Mito, H., Koike, K., Kobayashi, S., and Inaba, K., Electrochromic properties of epitaxial WO3 thin films grown on sapphire substrates, Jpn. J. Appl. Phys., 2018, vol. 57, no. 10, paper 100 309.
Dinh, N.N., Ninh, D.H., Thao, T.T., and Truong, V.-V., Mixed nanostructured Ti–W oxides films for efficient electrochromic windows, J. Nanomater., 2012, paper 781 236.
Yano, M., Koike, K., Matsuo, M., Murayama, T., Harada, Y., and Inaba, K., Growth and crystallographic characterization of molecular beam epitaxial WO3 and MoO3/WO3 thin films on sapphire substrates, Appl. Surf. Sci., 2016, vol. 381, pp. 32–35.
Dhonge, B.P., Singh, A., Panda, A.K., Thirumurugesan, R., and Parameswaran, P., Synthesis of α-WO3 thin film using pulsed laser deposition: influence of thickness on optical and electrical properties, Trans. Indian Inst. Met., 2019, vol. 72, no. 3, pp. 733–740.
Evecan, D. and Zayim, E., Highly uniform electrochromic tungsten oxide thin films deposited by e-beam evaporation for energy saving systems, Curr. Appl. Phys., 2019, vol. 19, pp. 198–203.
Maiorov, V.A., Window glasses: state and prospects, Opt. Spektrosk., 2018, vol. 124, no. 4, pp. 594–608.
Parshina, L.S., Novodvorsky, O.A., Khramova, O.D., Petukhov, I.A., Mikhalevsky, V.A., Lotin, A.A., Cherebilo, E.A., and Panchenko, V.Ya., Properties of SnO2:Sb films produced on flexible organic substrates by droplet-free pulsed laser deposition method, Opt. Quantum Electron., 2016, vol. 48, no. 6, paper 316.
Novodvorsky, O.A., Mikhalevskii, V.A., Gusev, D.S., Lotin, A.A., Parshina, L.S., Khramova, O.D., and Cherebylo, E.A., Time-of-flight characteristics of a laser torch during ablation of a MnSi target in argon atmosphere, Tech. Phys. Lett., 2018, vol. 44, no. 3, pp. 271–274.
Novodvorsky, O.A., Khramova, O.D., Filippova, E.O., Sagdeev, R.Ya., Shevelev, A.K., Bartha, J.W., and Wenzel, C., An investigation of erosion plume emission spectra at laser ablation of metallic targets in vacuum, Proc. SPIE—Int. Soc. Opt. Eng., 2001, vol. 4644, pp. 58–63.
Afify, H.H., Hassan, S.A., Obaida, M., Moussa, I., and Abouelsayed, A., Preparation, characterization, and optical spectroscopic studies of nanocrystalline tungsten oxide WO3, Opt. Laser Technol., 2019, vol. 111, pp. 604–611.
Wang, C.X., Yang, G.W., Zhang, T.C., Liu, H.W., Han, Y.H., Luo, J.F., Gao, C.X., and Zou, G.T., Fabrication of transparent p–n-hetero-junction diodes by p-diamond film and n-ZnO film, Diamond Relat. Mater., 2003, vol. 12, no. 9, pp. 1548–1552. https://doi.org/10.1016/S0925-9635(03)00237-1
Zhang, G., Lu, K., Zhang, X., Yuan, W., Shi, M., Ning, H., Tao, R., Liu, X., Yao, R., and Peng, J., Effects of annealing temperature on optical band gap of sol–gel tungsten trioxide films, Micromachines, 2018, vol. 9, no. 8, paper 377. https://doi.org/10.3390/mi9080377
Belousov, A.L. and Patrusheva, T.N., Electrochromic oxide materials, Zh. Sib. Fed. Univ. Tekh. Tekhnol., 2014, vol. 7, no. 2, pp. 154–166.
ACKNOWLEDGMENTS
This work was supported by the Ministry of Science and Higher Education within the State assignment FSRC “Crystallography and Photonics” RAS in part of “the thin films synthesis” and the Russian Foundation for Basic Research (Project nos. 19-29-03032, 17-07-00615, and 16-29-05385) in part of “analysis of the thin films”.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Novodvorsky, O.A., Parshina, L.S., Khramova, O.D. et al. Low-Temperature Laser Synthesis of Thin Electrochromic WO3 Films. Inorg Mater 56, 382–387 (2020). https://doi.org/10.1134/S0020168520030140
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0020168520030140