Abstract
We have prepared magnetoelectric (ME) composite ceramics, free of foreign phases, in the lead zirconate titanate–cobalt nickel ferrite two-phase system: xPZT-36 + (100–x)Ni0.9Co0.1Fe2O4. The sol–gel derived ferrite powder used in our preparations seems to be doped with titanium cations from the PZT-36. The ceramics have a percolation threshold at x = 50–70 wt %, which is due to the increased electrical conductivity of Ni0.9Co0.1Fe2O4. As a consequence, the piezoelectric parameters of the ME ceramics drop sharply at x < 50–70 wt %: the piezoelectric moduli |dij| and piezoelectric voltage coefficients |gij| decrease by a factor of 3–5 in this composite range. The piezoelectric parameters |dij| and |gij| of the composites produced using the fine ferrite powder exceed those of the materials prepared using macrocrystalline Ni0.9Co0.1Fe2O4 powder by more than a factor of 2. The piezoelectric voltage coefficient g33 correlates with the ME coefficient ΔE/ΔH. The highest ME conversion efficiency (up to 45 mV/(cm Oe)) is offered by the 80 wt % PZT-36 + 20 wt % Ni0.9Co0.1Fe2O4 composites, whose composition lies in a subpercolation region. Even though the composites produced using the fine ferrite powder possess improved piezoelectric properties, they have smaller ΔE/ΔH coefficients (no greater than 25 mV/(cm Oe)), which can be tentatively attributed to the degradation of the properties of the ferrite as a consequence of doping with Ti4+ cations during the sintering of the composite ceramics.
Similar content being viewed by others
References
Lupeiko, T.G., Lopatin, S.S., Lisnevskaya, I.V., and Zvyagintsev, B.I., Magnetoelectric composite materials based on lead zirconate titanate and nickel ferrite, Inorg. Mater., 1994, vol. 30, no. 11, pp. 1353–1356.
Lisnevskaya, I.V., Bobrova, I.A., Bikyashev, E.A., and Lupeiko, T.G., Interfacial reactions and properties of Y3Fe5O12/Ba1 − xPbxTiO3 composites, Inorg. Mater., 2006, vol. 42, no. 10, pp. 1147–1151.
Nan, C.-W., Bichurin, M.I., Dong, S., Viehland, D., and Srinivasan, G., Multiferroic magnetoelectric composites: historical perspective, status and future directions, J. Appl. Phys., 2008, vol. 103, paper 031 101.
Lisnevskaya, I.V., Bobrova, I.A., and Lupeiko, T.G., Comparison of the properties of PZTNB-1 + Ni0.9Co0.1Cu0.1Fe1.9O4 − δ magnetoelectric composites manufactured from components synthesized by sol–gel processes, Russ. J. Inorg. Chem., 2012, vol. 57, no. 1, pp. 84–89.
Ma, J., Hu, J., Li, Z., and Nan, C.-W., Recent progress in multiferroic magnetoelectric composites: from bulk to thin films, Adv. Mater., 2011, vol. 23, pp. 1062–1087.
Lisnevskaya, I.V., Myagkaya, K.V., and Bobrova, I.A., Lithium sodium potassium niobate-modified nickel ferrite lead-free magnetoelectric composite ceramics, Ceram. Int., 2015, vol. 41, no. 10, pp. 15 217–15 221.
Lisnevskaya, I.V., Bobrova, I.A., Lupeiko, T.G., Agamirzoeva, M.R., and Myagkaya, K.V., Y3Fe5O12/Na,Bi,Sr-doped PZT particulate magnetoelectric composites, J. Magn. Magn. Mater., 2016, vol. 405, pp. 62–65.
Lupeiko, T.G., Lisnevskaya, I.V., Chkheidze, M.D., and Zvyagintsev, B.I., Laminated magnetoelectric composites based on nickel ferrite and PZT materials, Inorg. Mater., 1995, vol. 31, no. 9, pp. 1139–1142.
Bichurin, M.I., Petrov, V.M., and Petrov, R.V., Direct and inverse magnetoelectric effect in layered composites in electromechanical resonance range: a review. J. Magn. Magn. Mater., 2012, vol. 324, no. 21, pp. 3548–3550.
Lisnevskaya, I.V. and Lupeiko, T.G., PZT-36/NiCo0.02Cu0.02Mn0.1Fe1.8O4 − δ magnetoelectric rod composites with 1–3, 3–1, and 1–1 connectivity, Inorg. Mater., 2012, vol. 48, no. 4, pp. 410–415.
Lisnevskaya, I.V., Lupeiko, T.G., and Lagunova, N.G., Influence of the connectivity pattern, the nature of the piezoelectric material, and rod thickness on the properties of 50 vol % PZT/50 vol % NiCo0.02Cu0.02-Mn0.1Fe1.8O4 − δ magnetoelectric composites, Inorg. Mater., 2014, vol. 50, no. 7, pp. 723–727.
Lisnevskaya, I.V., Lupeiko, T.G., and Myagkaya, K.V., Investigation of the influence of various factors on the dielectric, piezoelectric, and magnetoelectric properties of 1–3, 3–1, and 1–1 multiferroic composites, J. Compos. Mater., 2017, vol. 51, no. 4, pp. 507–517.
Suchtelen, J.V., Product properties: a new application of composite materials, Philips Res. Rep., 1972, vol. 27, no. 1, pp. 28–37.
Newnham, R.E., Composite electroceramics. Part 1, CHEMTECH, 1986, vol. 16, no. 12, pp. 732–739.
Newnham, R.E., Composite electroceramics. Part 2, CHEMTECH, 1987, vol. 17, no. 1, pp. 38–45.
Sorokin, V.V., Smirnov, A.M., Badelin, A.G., and Karpasyuk, V.K., RF Patent, 2011.
Lisnevskaya, I.V., Bobrova, I.A., Petrova, A.V., and Lupeiko, T.G., Low-temperature sol–gel synthesis of modified nickel ferrite, Russ. J. Inorg. Chem., 2012, vol. 57, no. 4, pp. 474–477.
Lisnevskaya, I.V., Bobrova, I.A., and Lupeiko, T.G., Synthesis of magnetic and multiferroic materials from polyvinyl alcohol based gels, J. Magn. Magn. Mater., 2017, vol. 51, no. 4, pp. 507–517.
Kovba, L.M. and Trunov, V.K., Rentgenofazovyi analiz (X-ray Diffraction Analysis), Moscow: Mosk. Gos. Univ., 1976.
Bracke, L.P.M. and van Vliet, R.G., A broadband magneto-electric transducer using a composite material, Int. J. Electron., 2007, vol. 51, no. 3, pp. 255–262.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © I.V. Lisnevskaya, N.A. Levshina, 2018, published in Neorganicheskie Materialy, 2018, Vol. 54, No. 8.
Rights and permissions
About this article
Cite this article
Lisnevskaya, I.V., Levshina, N.A. Influence of the Preparation Conditions and Percolation Threshold on the Properties of Lead Zirconate Titanate/Cobalt Nickel Ferrite Magnetoelectric Composites. Inorg Mater 54, 851–858 (2018). https://doi.org/10.1134/S0020168518080113
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0020168518080113