Advertisement

Russian Metallurgy (Metally)

, Volume 2019, Issue 13, pp 1466–1470 | Cite as

Experimental Estimation of the Technological Indices of the Machining of Metals by Edge Tool at an Ultrahigh Cutting Speed

  • V. M. KorneevaEmail author
  • S. S. Korneev
METAL FORMING

Abstract

The wear and the surface quality of various structural materials are studied after machining at ultrahigh cutting speeds. The periodicity of cutting is shown to decrease the wear of tool, to reach the stability of tool that is economically efficient, and to achieve the surface quality that is higher than that after conventional cutting.

Keywords:

ultrahigh cutting speed coefficient of periodicity cutting stroke time idle stroke time red-hardness temperature steady cutting time 

Notes

REFERENCES

  1. 1.
    V. M. Korneeva and S. S. Korneev, “Experimental estimation of the possibility of ultrahigh-speed cutting by edge tool using a temperature factor,” Tekhn. Mashinostr., No. 9, 16–20 (2016).Google Scholar
  2. 2.
    V. M. Korneeva and S. S. Korneev, “Development of a model for the chip formation under ultrahigh-speed cutting conditions,” Tekhn. Mashinostr., No. 11, 54–58 (2014).Google Scholar
  3. 3.
    V. M. Korneeva and S. S. Korneev, “Theoretical estimation of the force loading of cutting tool at ultrahigh cutting speeds,” Fund. Prikl. Probl. Tekhn. Tekhol., No. 3 (11), 1000–105 (2015).Google Scholar
  4. 4.
    V. M. Korneeva and S. S. Korneev, “Analysis of the force loads on cutting tool during ultrahigh-speed cutting,” Tekhn. Mashinostr., No. 1, 23–25 (2017).Google Scholar
  5. 5.
    G. S. Andreev, “Thermal state of the cutting part of tool during continuous cutting,” Vestn. Mashinostr., No. 8, 57–60 (1976).Google Scholar
  6. 6.
    V. M. Korneeva and S. S. Korneev, “Thermophysical substantiation of the possibility of increasing the cutting speed during the machining of polymer composite materials,” Tekhn. Metallov, No. 6, 2–7 (2017).Google Scholar
  7. 7.
    V. F. Bez’’yazychnyi, M. V. Timofeev, R. N. Fomenko, and E. V. Kiselev, “Analysis of the techniques used to set cutting conditions,” Tekhn. Metallov, No. 12, 2–10 (2017).Google Scholar

Copyright information

© Pleiades Publishing, Ltd. 2019

Authors and Affiliations

  1. 1.Bauman Moscow State Technical UniversityMoscowRussia

Personalised recommendations