Skip to main content
SpringerLink
Log in

A Unified Method for Calculating the Center of Pressure during Wheelchair Propulsion

  • Published:
Annals of Biomedical Engineering Aims and scope Submit manuscript

Abstract

The measurement of the center of pressure (COP) has been and continues to be a successful tool for gait analysis. The definition of a similar COP for wheelchair propulsion, however, is not straightforward. Previously, a COP definition similar to that used in force plate analysis had been proposed. Unfortunately, this solution has the disadvantage of requiring a separate COP definition for each plane of analysis. A definition of the generalized center of pressure (GCOP) which is consistent in all planes of analysis is derived here. This definition is based on the placement of a force-moment system, equivalent to the force-moment system at the hub, on a line in space where the moment vector (wrench moment) is parallel to the force vector. The parallel force-moment system is then intersected with three planes defined by anatomical landmarks on the hand. Data were collected using eight subjects at propulsion speeds of 1.34 m/s and 2.24 m/s (1.34 m/s only for subject 1, 0.894 m/s and 1.79 m/s for subject 8). Each subject propelled a wheelchair instrumented with a SMARTWheel. A PEAK 5 video system was used to determine the position of anatomical markers attached to each subject’s upper extremity. The GCOP in the transverse plane of the wrist formed clusters for all subject’s except subject 2 at 1.34 m/s. The clustering of the GCOP indicates that the line of action for the force applied by the hand is approximately perpendicular to the transverse plane through the wrist. When comparing the magnitude of the moment vector part of the wrench with the moment of the force vector of the wrench about the hub, the wrench moment is approximately an order of magnitude smaller. This indicates that the role of the wrist for wheelchair propulsion is primarily to stabilize the force applied by the arm and shoulder. © 1998 Biomedical Engineering Society.

PAC98: 8745Dr, 8710+e

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

REFERENCES

  1. Aljure, J., I. Eltorai, W. E. Bradley, J. E. Lin, and B. Johnson. Carpal tunnel syndrome in paraplegic patients. Paraplegia 23:182-186, 1985.

    Google Scholar 

  2. Asato, K., R. A. Cooper, R. N. Robertson, and J. F. Ster. SMARTWheels. Development and testing of a system for measuring manual wheelchair propulsion dynamics. IEEE Trans. Biomed. Eng. 40:1320-1324, 1993.

    Google Scholar 

  3. Beer, F. P., and E. R. Johnston. Vector Mechanics for Engineers: Statics and Dynamics, 5th ed. New York: McGraw-Hill, 1988, pp. 104-110.

    Google Scholar 

  4. Bobbert, M. F., and H. C. Schambardt. Accuracy of determining the point of force application with piezoelectric force plates. J. Biomech. 23:705-710, 1990.

    Google Scholar 

  5. Burnham, R. S., and R. D. Steadward. Upper extremity peripheral nerve entrapments among wheelchair athletes: prevalence, location, and risk factors. Arch. Phys. Med. Rehabil. 75:519-524, 1994.

    Google Scholar 

  6. Cooper, K. T., R. N. Asato, and J. F. Robertson. Ster. 2-dimensional kinetic analysis of manual wheelchair propulsion with an improved SMARTWheel. In: Proceedings of IEEEEMBS 14th International Conference, Paris, France, 1992, Vol. 14, pp. 1544-1545.

    Google Scholar 

  7. Cooper, R. A., D. P. VanSickle, R. N. Robertson, M. L. Boninger, and G. Ensminger. A method for analyzing center of pressure during manual wheelchair propulsion. IEEE Trans. Rehab. Eng. 3:289-298, 1995.

    Google Scholar 

  8. International Organization for Standards (ISO). Wheelchairs—Determination of seating dimensions— Definitions and measurement methods, ISO Standard 7176/7. Washington, DC: RESNA Press, 1991.

    Google Scholar 

  9. Janssen, T. W., C. A. J. M. van Oers, L. H. V. van der Woude, and A. P. Hollander. Physical strain in daily life of wheelchair users with spinal cord injuries. Med. Sci. Sports Exercise. 26:661-669, 1994.

    Google Scholar 

  10. Johnson, A. T. Biomechanics of Exercise Physiology. New York: Wiley, 1991, pp. 31-70.

    Google Scholar 

  11. MathWorks. MATLAB Reference Guide. The MathWorks Inc., 1992.

  12. McCaw, S. T., and P. DeVita. Errors in alignment of center of pressure and foot coordinates affect predicted lower extremity torques. J. Biomech. 28:985-988, 1995.

    Google Scholar 

  13. McMinn, R. M. H., R. T. Hutchings, J. Pegington, and P. Abrahms. Color Atlas of Human Anatomy, 3rd ed. Baltimore: Mosbey-Wolfe, 1993, pp. 135-154.

    Google Scholar 

  14. Mow, V. C., and W. C. Hayes. Basic Orthopedic Biomechanics. New York: Raven, 1991, pp. 51-92.

    Google Scholar 

  15. Nemchausky, B. A., and R. M. Ubiluz. Upper extremity neuropathies in patients with spinal cord injuries. J. Spinal Cord Med. 18:95-97, 1995.

    Google Scholar 

  16. Robertson, R. N., and R. A. Cooper. Kinetic characteristic of wheelchair propulsion utilizing the SMARTWheel. In: Proceedings of the 17th Annual Meeting of the American Society of Biomech., Iowa City, Iowa, 1993, pp. 202-203.

  17. Robertson, R. N., R. A. Cooper, G. J. Ensminger, and K. J. Stewart. Upper extremity net joint forces and moments during wheelchair propulsion. In: Proceedings of the 17th Annual RESNA Conference, Nashville, Tennessee, 1994, pp. 155-157.

  18. Schumann, T., M. S. Redfern, J. M. Furman, A. El-Jaroudi, and L. F. Chaparro. Time-frequency analysis of postural sway. J. Biomech. 28:603-606, 1995.

    Google Scholar 

  19. Stefaniwsky, L., D. S. Bilowitt, and S. S. Prasad. Reduced motor conduction velocity of the ulnar nerve in spinal cord injured patients. Paraplegia 18:21-24, 1980.

    Google Scholar 

  20. Stewart, G. W. Introduction to Matrix Computations. Orlando: Academic, 1973, pp. 216, 327-394.

    Google Scholar 

  21. Strang, G. Linear Algebra and Applications, 2nd ed. Orlando: Academic, 1980, pp. 211-215.

    Google Scholar 

  22. VanSickle, D. P., R. A. Cooper, and R. N. Robertson. SMARTWheel. Development of digital force and moment sensing pushrim. In: Proceedings of RESNA 17th Annual Conference, Canada, Vancouver, 1995, pp. 325-352.

  23. Vaughan, C. L., B. L. Davis, and J. C. O'Connor. Dynamics of human gait. Champaign, IL: Human Kinetics, 1992, pp. 1-132.

    Google Scholar 

  24. Veeger, H. E. J., L. H. V. van der Woude, and R. H. Rozendal. Load on the upper extremity in manual wheelchair propulsion. J. Electromyograph. Kinesiol. 1:270-280, 1991.

    Google Scholar 

  25. Veeger, H. E. J., L. H. V. van der Woude, and R. H. Rozendal. Orientation of the scapula in a simulated wheelchair push. Clin. Biomech. 8:81-90, 1993.

    Google Scholar 

  26. Winter, D. A. Biomechanics and Motor Control of Human Movement. New York: Wiley, 1990, pp. 75-102.

    Google Scholar 

  27. Chou, Y.-L., F.-C. Su, S. H. Hong, and P.-H. Chou. Initial gait analysis. Chin. J. Mech. 9:301-307, 1993.

    Google Scholar 

  28. Zimmerman, G. R. Carpal tunnel syndrome. J. Athletic Training 29:22-30, 1994.

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Department of Rehabilitation Science and Technology, University of Pittsburgh, Pittsburgh, PA

    David P. VanSickle, Rory A. Cooper, Michael L. Boninger, Rick N. Robertson & Sean D. Shimada

  2. Department of Bioengineering, Human Engineering Research Laboratories, University of Pittsburgh, Pittsburgh, PA

    David P. VanSickle & Sean D. Shimada

  3. Research Service, Highland Drive Veterans Affairs Medical Center, Pittsburgh, PA

    David P. VanSickle, Rory A. Cooper, Rory A. Cooper, Michael L. Boninger & Rick N. Robertson

  4. Department of Mechanical Engineering, University of Pittsburgh, Pittsburgh, PA

    Rory A. Cooper

  5. Division of Physical Medicine and Rehabilitation, Department of Orthopaedic Surgery, University of Pittsburgh Medical Center, Pittsburgh, PA

    Rory A. Cooper, Michael L. Boninger, Rick N. Robertson & Sean D. Shimada

Authors
  1. David P. VanSickle
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Rory A. Cooper
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Michael L. Boninger
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Rick N. Robertson
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Sean D. Shimada
    View author publications

    You can also search for this author in PubMed Google Scholar

Rights and permissions

Reprints and permissions

About this article

Cite this article

VanSickle, D.P., Cooper, R.A., Boninger, M.L. et al. A Unified Method for Calculating the Center of Pressure during Wheelchair Propulsion. Annals of Biomedical Engineering 26, 328–336 (1998). https://doi.org/10.1114/1.80

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1114/1.80

Search

Navigation