Abstract
The estimated components of the error in the determination of the effective area of a measuring piston-cylinder assembly of a piston manometer with a non-sealed piston are reported. Such manometers are incorporated into the secondary standard of the unit of pressure.
Similar content being viewed by others
REFERENCES
GOST 8.017-79, State System for Traceability Assurance (GSI), State Primary Standard and All-Union Verification System for Measuring Instruments for Overpressure up to 250 MPa.
M. K. Zhokhovskii, Theory and Design of Instruments with an Unsealed Piston [in Russian], Izd. Standartov, Moscow (1980).
International Recommendation OIML R 110. Pressure Balances (1994).
G. D. Burdun and B. N. Markov, Foundations of Metrology [in Russian], Izd. Standartov, Moscow (1975).
K. N. Markov, G. B. Kainer, and P. A. Satserdotov, Error and Choice of Instruments in Linear Measurements [in Russian], Mashinostroenie, Moscow (1967).
G. B. Kainer, Izmer. Tekh., No. 12, 10 (1998).
GOST 8.381-80, State System for Traceability Assurance (GSI), Standards. Methods of Expressing Errors.
V. N. Gorobei and Yu. A. Kiselev, Izmer. Tekh., No. 3, 41 (1995).
Rights and permissions
About this article
Cite this article
Kartashev, V.I., Stetsyura, V.I., Fursa, A.N. et al. Increasing the Accuracy of Reproduction of Pressure by Means of the Ukrainian Secondary Standard of the Unit of Pressure. Measurement Techniques 47, 53–57 (2004). https://doi.org/10.1023/B:METE.0000022504.74362.f4
Issue Date:
DOI: https://doi.org/10.1023/B:METE.0000022504.74362.f4