Abstract
Direct Coagulation Casting (DCC) method was applied for an alumina powder molding. In the paper the results of studies on the application of the reaction of acetic acid generation from glycerol triacetate catalyzed by lipase PPL for the flocculation of ceramic slips are presented. The ceramic samples obtained according this method were homogenous of a low content of organic binder (below 0.5 mass%), high tensile strength in the green state (>1 MPa) and high uniformity of thickening and a uniform structure.
Similar content being viewed by others
References
L. J. Gauckler, T. J. Graule, F. H. Baader and J. Will, Key Eng. Mater., 159-160 (1999) 135.
L. J. Gauckler, T. Graule and F. H. Baader, Mater. Chem. Phys., 61 (1999) 78.
W. Huismann, T. Graule and L. J. Gauckler, J. Am. Ceram. Soc., 51 (1995) 451.
W. Huismann, T. Graule and L. J. Gauckler, J. Eur. Ceram. Soc., 15 (1995) 811.
T. J. Graule, F. H. Baader and L. J. Gauckler, Chemtech., The American Chemical Society, (1995) 31.
P. Hidber, T. J. Graule and L. J. Gauckler, J. Am. Ceram. Soc., 795 (1996) 1857.
G. V. Franks, B. V. Velamakanni and F. F. Lange, J. Am. Ceram. Soc., 785 (1995) 1324.
M. Szafran and G. Rokicki, J. Am. Ceram. Soc., 84 (2001) 1231.
M. Szafran, G. Rokicki, Z. Florjańczyk, E. Zygadło-Monikowska and N. Langwald, Ind. Ceramics, 20, 3 (2000) 190.
M. Szafran, P. Wiśniewski, G. Rokicki and L. Łukasik, J. Therm. Anal. Cal., 66 (2001) 603.
D. Santhiya, S. Subramanian, K. A. Natarajan and S. G. Malghan, Coll. Surf. A: Physicochemical and Engineering Aspects, 164 (2000) 143.
D. Das, K. Kalyan and P. Somasundaran, Coll. Surf. A: Physicochemical and Engineering Aspects, 182 (2001) 25.
Liu Yangqiao, Gao Lian and Guo Jingkun, Coll. Surf. A: Physicochemical and Engineering Aspects, 174 (2000) 349.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Szafran, M., Jach, K., Tomaszewska-Grzeda, A. et al. Utilisation of enzymatic reactions in Al2O3 powder moulding process. Journal of Thermal Analysis and Calorimetry 74, 639–646 (2003). https://doi.org/10.1023/B:JTAN.0000005205.24098.81
Issue Date:
DOI: https://doi.org/10.1023/B:JTAN.0000005205.24098.81