Skip to main content
SpringerLink
Log in

Interrelation between toughness and both strength and structural parameters of material*

  • Published:
International Journal of Fracture Aims and scope Submit manuscript

Abstract

The Neuber-Novozhilov fracture criterion is proposed for a description of tensile and shear fracture in the vicinity of the tip of a V-shaped cut. In the criterion proposed, the averaged limits of stresses on the cut axis depend on the presence, size and location of defects in the initial material. The parameter of the crystal lattice of material is chosen for the specific linear size. For V-shaped cuts, simple relations for tension and shear have been obtained that relate stress intensity factors at modified singularity coefficients; also obtained are these singularity coefficients and theoretical tensile and shear strengths of single crystal material with consideration of damage of the material in the vicinity of the cut tip. In the relations obtained, the passage to the limit by the angle from the V-shaped cut to a crack is possible. It has been shown that the critical stress intensity factor that is used when evaluating the strength of cracked solids is not a material constant.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  • Dunn, M.M., Suwito, W. and Cunningham, S. (1997). Fracture initiation at sharp notches: correlation using critical stress intensities, Int. J. Solids Structures 34(29), 3873-3883.

    Article  Google Scholar 

  • Hellan, K. (1984). Introduction to fracture mechanics, McGraw-Hill, New York.

    Google Scholar 

  • Kerstein, I.M., Klushnikov, B.D., Lomakin, E.V. and Shesterikov, S.A. (1989). The bases of experimental fracture mechanics, Izdatelstvo Moskovskogo Universiteta, Moscow.

    Google Scholar 

  • Kornev, V.M. (1996). Integral criteria of a brittle strength of cracked bodies with defects with vacancies in the crack tip. The strength of compacted bodies like ceramics, J. Appl. Tech. Phys. 37(5), 168-177.

    CAS  Google Scholar 

  • Kornev, V.M. (2000). Hierarchy of strength criteria of structured brittle media. Satellite initiation of microcracks, J. Appl. Tech. Phys. 41(2), 177-187.

    Google Scholar 

  • Kornev, V.M. (2000a). Large-scale criteria of shearing strength of block brittle media. Satellite birth of micropores, Physicotechnical problems mineral resources mining 40(5), 7-16.

    Google Scholar 

  • Kornev, V.M. (2002). Generalized sufficient strength criterion. The description of pre-fracture zone, J. Appl. Tech.Phys. 43(5), 153-161.

    Google Scholar 

  • Kornev, V.M. (2002a). Modification of Neuber-Novozhilov's fracture criterion for V-shapes (anti-plane problem), J. Appl. Tech. Phys. 43(1), 153-159.

    Google Scholar 

  • MacMillan, N.H. (1983). The ideal strength of solids. In: Atomistic of Fractue (Edited by R. Latanision J.R. Pickens), Plenum Press, New York, 95-164.

    Google Scholar 

  • Morozov, N.F. (1988). Problems of a brittle fracture and their investigation by means of elasticity theory methods.In: Mechanics and technical-scientific progress. Vol. 3: Mechanics of solids, Nauka, Moscow, 54-63.

    Google Scholar 

  • Morozov, N.F. and Semenov, B.N. (1986). Application of criterion of V.V. Novozhilov's brittle fracture for determination of fracture loads for V-shaped cut under complex stress state, Izv. acad. of science USSR, Mechanics of Solids. 1, 122-126.

    Google Scholar 

  • Neuber, H. (1937). Kerbspannunglehre: Grundlagen fur Genaue Spannungsrechnung, Springer-Verlag, Berlin.

    Google Scholar 

  • Novozhilov, V.V. (1969). About the necessary and sufficient brittle strength criteria, Prikl. Mat. Mekh. 33(2), 212-222.

    Google Scholar 

  • Panasyuk, V.V., Andreykiv, A.E. and Kovchik, S.E. (1977). The determination of fracture viscosity of structural materials by their mechanical characteristics and structure parameters, Phys. Chem. Mech. of Materials 13(2), 120-122.

    CAS  Google Scholar 

  • Savruk, M.P. (1988). Stress intensity factors in cracked bodies. In: Fracture mechanics and strength of material, vol. 2, Naukova Dumka, Kiev.

    Google Scholar 

  • Thompson, P. (1983). Physics of fracture. In: Atomistic of Fracture (Edited by R. Latanision and J.R. Pickens), Plenum Press, New York, 104-144.

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Lavrentyev Institute of Hydrodynamics SB RAS, 630090, Novosibirsk, Russia

    V.M. Kornev & V.D. Kurguzov

Authors
  1. V.M. Kornev
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. V.D. Kurguzov
    View author publications

    You can also search for this author in PubMed Google Scholar

Rights and permissions

Reprints and permissions

About this article

Cite this article

Kornev, V., Kurguzov, V. Interrelation between toughness and both strength and structural parameters of material* . International Journal of Fracture 128, 195–203 (2004). https://doi.org/10.1023/B:FRAC.0000040982.36528.b7

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1023/B:FRAC.0000040982.36528.b7

Search

Navigation