Abstract
Modeling of initial plastic zone by two slip-lines is considered. It is shown that such a model does not remove stress singularity at the crack tip.
Similar content being viewed by others
References
Cherepanov, G.P. (1979), Mechanics of brittle fracture. McGraw-Hill, New York.
Dudik, M.V., Kipnis, L.A., Pavlenko, A.V. (2002). Analysis of plastic slip-lines at the tip of a crack terminating at the interface of different media. International Applied Mechanics (Transl. of “Prikladnaya Mekhanika”) 38, 197–202.
Kaminsky, A.A., Kipnis, L.A., Khazin, G.A. (2002). Analysis of the plastic zone at the corner point by the "trident” model, International Applied Mechanics (Transl. of “Prikladnaya Mekhanika”) 38, 611–616.
Kipnis, L.A. (1998). Shear cracks and dislocation pileups at a notch. In Fracture: A Topical Encyclopedia of Current Knowledge (Ed. G.P. Cherepanov). Krieger Publ. Co, Malabar, Florida, 106–124.
Kundrat N.M. (2002). On the initial development of the slip band near an inclusion in the interface. International applied mechanics (Transl. of “Prikladnaya Mekhanika”) 38, 578–584.
Lo K.K. (1979). Modelling of plastic yielding at a crack tip by inclined slip planes. Int. J. Fracture 15, 583–589.
Noble, B. (1958). Methods Based on the Wiener-Hopf Technique for the Solution of Partial Differential Equations. Pergamon Press, London.
Ufliand, Ya.S. (1967). Integral Transformations in Problems of the Theory of Elasticity. Nauka, Leningrad (in Russian).
Vitvistkii, P.M., Panasyuk, V.V., Yarema, S.Ya. (1975). Plastic deformation around crack and fracture criteria. Eng. Fract. Mech. 7 305–319.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Kaminsky, A.A., Kipnis, L.A. & Dudik, M.V. Modeling of the Crack Tip Plastic Zone by Two Slip Lines and the Order of Stress Singularity. International Journal of Fracture 127, L105–L109 (2004). https://doi.org/10.1023/B:FRAC.0000035083.26389.db
Issue Date:
DOI: https://doi.org/10.1023/B:FRAC.0000035083.26389.db