Abstract
First feed support system, which is one of the key technologies of Five hundred meter Aperture Spherical Telescope (FAST) was discussed in this paper. A 1:30 scaled model (20 m × 20 m × 6 m) has been built to make systemic research on the feasibility of the system. The root mean square of pointing error of moving cable car was measured and the displacements of cable car within the wind speed of 8 m/s, which is the maximal wind speed of the place where the FAST will be located, were evaluated. Then the total maximal pointing error of cable car was computed. Experimental results demonstrate that the total pointing error of the cable car is less than 50 cm, the required pointing accuracy error of the system.
Similar content being viewed by others
References
Duan, B. et al.: 1996, ‘Study of the Feed System for a Large Radio Telescope from the Viewpoint of Mechanical and Structural Engineering‘, in R.G. Strom, B. Peng, R. Nan (eds), Proc. of the LTWG-3&W-SRT, pp. 85–102.
Duan, B. et al.: 1999, Mech. Eng. China 10(9):1002–1004.
Zhu Wenbai: 1999, Description of feed motion of FAST, MEMOS of the FAST.
Large Radio Telescope Lab: 1999, National Observatory, Report on the Pre-research of large radio telescope FAST, 2000.3.31.
Yu, L. et al.: 2001, Eng. Design 4, 173–175.
The Technical Scheme for FAST, http://www.bao.ac.cn/bao/LT/Publications.htm.
Zhou zhou: 2001, “Dynamic Research of Cable Car Configuration Without Flat of Large Radio Telescope”, Master Thesis, Tsinghua University.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yu, L., Hock, F.T.E., Suo, S. et al. Experimental Research of First Feed-Support System of FAST. Experimental Astronomy 15, 113–122 (2003). https://doi.org/10.1023/B:EXPA.0000036174.97636.db
Published:
Issue Date:
DOI: https://doi.org/10.1023/B:EXPA.0000036174.97636.db