Skip to main content
Log in

Investigation of the Mixing of Coolant Flows in a VVÉR Vessel

  • Published:
Atomic Energy Aims and scope

Abstract

The mixing of flows in a flow-through channel of a VVÉR-1000 reactor in the case where a flow with high or low boron concentration and a flow whose temperature is different from the temperature in the reactor are fed into the same circuit is studied. To this end investigations were performed on a bench at the Special Design Office Gidropress with a model VVÉR-1000 reactor on a 1:5 scale. Regimes with the main circulation pump switched on and with natural circulation restored for an accident with a small leak are studied.

Intercircuit mixing in the VVÉR-1000 reactor setup is also studied in the case where the temperature of the coolant changes in one of the circuits (regimes with a break in a steam pipe and closure of the steam channel of the turbine) or with asymmetric feeding of boron into the first loop when one of the tanks in the system for rapid introduction of boron fails. An analytical solution of the problem and the results of measurements performed on units with VVÉR-1000 reactors are presented.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

REFERENCES

  1. V. N. Ul'yanovskii, Yu. A. Bezrukov, S. A. Logvinov, and L. A. Salii, “Investigation of the mixing of flows with different boron concentration at the entrance into the core,” in: International Conference on the Thermophysical Aspects of VVÉR Safety, Obninsk, May 26- 29, 1998, Vol. 1, pp. 37–46.

    Google Scholar 

  2. S. A. Logvinov, V. N. Ulyanovsky, Yu. A. Bezrukov, and A. N. Kozlov, “Mixing of coolant with different boron concentration at the VVER-1000 core inlet during RCP start-up,” in: Proceedings of the Annual Meeting on Nuclear Technology 2000, Bonn, May 22- 24, 2000, p. 421.

  3. O. I. Melikhov, V. I. Melikhov, S. E. Yakush, and Yu. A. Bezrukov, “Analysis of boron dilution in VVER-1000 reactor,” in: Proceedings of Annual Meeting on Nuclear Technology 2001, Dresden, May 15- 17, 2001, pp. 117–120.

  4. B. Hemstroom and N. Andersson, “Physical modelling of rapid boron dilution. Transient-1. Reynolds number snsi-tivity study for the Ringhals case,” Report No. US 95:5. Vattenfall Utveckling AB (1995).

  5. S. A. Tsymbalov and A. V. Kraiko, “Temperature field in the coolant at the entrance into a VVÉR-440 core,” At. Énerg., 52, No. 5, 304–308 (1982).

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Bezrukov, Y.A., Dragunov, Y.G., Logvinov, S.A. et al. Investigation of the Mixing of Coolant Flows in a VVÉR Vessel. Atomic Energy 96, 391–398 (2004). https://doi.org/10.1023/B:ATEN.0000041205.60891.10

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1023/B:ATEN.0000041205.60891.10

Keywords

Navigation