References
H. Soyama, Y. Ito, K. Uranishi, H. Kato and R. Oba, in Proceedings of the 15th IAHR Symposium (1990) Paper No. H 4.
H. Soyama, H. Kato and R. Oba, in Proceedings of the 3rd International Conference on Cavitation (1992) p. 103.
H. Soyama, S.R. Lee, M. Tonasaki, K. Uranishi, S.Saito, T. Okamura, H. Kato and R. Oba, in Proceedings of the 3rd International Symposium on Cavitation (1998) p. 135.
C. E. Brennen, in “Cavitation and Bubble Dynamics” (Oxford University Press, 1995) p. 78.
H. Soyama, J. D. Park and M. Saka, Trans. ASME, J. Manuf. Sci. and Eng. 122 (2000) 83.
H. Soyama, JSME Inter. J., Ser. A 43 (2000) 173.
H. Soyama, T. Kusaka and M. Saka, in Proceedings of the 6th International Conference on Residual Stresses (2000) p. 674.
Idem., J. Mater. Sci. Lett. 20 (2001) 1263.
Idem., Trans. ASME, J. Eng. Mater. Technology 124 (2002) 135.
H. Soyama, D. Odhiambo and K. Saito, in 8th International Conference on Shot Peening, in press.
T. Shoji, Met. Sci. 10 (1976) 165.
R.W. Cahn and P. Haasen, in “Physical Metallurgy,” 4th ed. (North-Holland, Amsterdam, 1996) p. 2400.
D. M. Jaegar and A. R. Jones, in Proceedings of Mater. Adv. Power Engineering, edited by D. Coutsouradis et al. (Kluwer Academic Publishers, The Netherlands, 1994) p. 1507.
T. S. Chous and H. K. D. H. Bhadeshia, J. Mater. Sci. Technol. 9 (1993b) 890.
N. Rajmohan and J. A. Szpunar, Scripta Mater. 44 (2001) 2387.
H. Regle and A. Alamo, J. de Physics IV C 7(3) (1993) 727.
C. Capedevila, Y. L. Chen, A. R. Jones and H. K. D. H. Bhadeshia, in Proceedings of 21st Riso International Symposium on Mater. Sci., Recrystallisation—Fundamental aspects and relations to deformation microstructure, edited by N. Hansen et al. (2000).
T. Shoji, H. Takahashi and M. Suzuki, Met. Sci. 12 (1978) 579.
T. Meyer and H. von Kanel, Phys. Rev. Lett. 78 (1997) 3133.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Macodiyo, D.O., Soyama, H. & Saka, M. Recrystallization-etch observation of plastic deformation caused by cavitation shotless peening. Journal of Materials Science Letters 22, 115–117 (2003). https://doi.org/10.1023/A:1021858718994
Issue Date:
DOI: https://doi.org/10.1023/A:1021858718994