Abstract
The paper deals with different scenarios of electric arc discharge propagation in the ITER tokamak toroidal magnet conductor. Estimates are obtained for the rate of discharge propagation along an insulated conductor and the conditions under which the conductor is cut by a direct current arc with typical values of 10–80 kA. The modes of a vacuum arc and normal and high‐pressure arcs are considered. The analysis was based on steady‐state heat‐ and mass‐transfer equations in a combination with the model of evaporation of the Knudsen–Langmuir surface.
Similar content being viewed by others
REFERENCES
F. Iida, K. Yoshida, S. Stoner, and A. Tesini “ITER magnet interface system,” in: Proc. of the 15th Int. Conf. on Magnet Technol., Part 1, S.n., Beiging, China (1997), pp. 433–436.
D. P. Ivanov, B. N. Kolbasov, D. K. Kurbatov, et al., “Qualitative analysis of accidents possible in ITER magnets,” Plasma Devices Operations, 7, 205–217 (1999).
V. V. Frolov (ed.), Theory of Welding Processes [in Russian], Vysshaya Shkola (1988).
V. A. Karkhin, Thermal Fundamentals of Welding [in Russian], Leningrad State Tech. Univ., Leningrad (1990).
R. V. Mitin, “Stationary and pulsed high-and hyperhigh-pressure arcs and methods of their diagnostics,” in: Properties of a Low-Temperature Plasma and Methods of Its Diagnostics [in Russian], Nauka, Novosibirsk (1977), pp. 105–138.
B. V. Alekseev and A. M. Grishin, Physical Gas Dynamics of Reactive Media [in Russian], Vysshaya Shkola (1985).
N. V. Afanas'ev and O. F. Shlenskii, Short-Duration Thermal Stability of Nonmetallic Materials [in Russian], St. Petersburg State Tech. Univ., St. Petersburg (1995).
_E. _E. Shpil'rain and P. M. Kissel'man, Fundamentals of the Theory of Thermal Properties of Materials, [in Russian], _Energia, Moscow (1977).
G. A. Kukekov, High-Voltage Alternating-Current Switches [in Russian], _Energiya, Leningrad (1972).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Titkov, V.V. Speed of Motion of a Short‐Circuit Arc in an Insulated Conductor. Journal of Applied Mechanics and Technical Physics 44, 129–134 (2003). https://doi.org/10.1023/A:1021798217665
Issue Date:
DOI: https://doi.org/10.1023/A:1021798217665