Abstract
The experimentally observed tensile properties (tensile strength and modulus) of short sisal fibre-reinforced LDPE with different fibre loading have been compared with the existing theories of reinforcement. The macroscopic behaviour of fibre-filled composites is affected by fibre loading, orientation and length of the fibres in the continuous medium. The interfacial adhesion between fibre and matrix also plays a major role in controlling the mechanical properties of the fibre-filled composites. In this study, a comparison is made between experimental data and different theoretical models. Composite models, such as parallel and series, Hirsch, Cox, Halpin–Tsai, modified Halpin–Tsai and modified Bowyer and Bader, have been tried to fit the experimental data.
Similar content being viewed by others
References
M. J. FOLKES, “Short Fibre Reinforced Thermoplastics” (Research Studies Press, Wiley, New York, 1982).
R. P. SHELDON, “Composite Polymeric Materials” (Applied Science, London, 1982) p. 58.
A. KELLY and N. H. MACMILLAN, “Strong Solids” (Clarendon Press, Oxford, 1986) p. 240.
W. BROSTOW and R. D. CORNELIUSSEN, “Failure of Plastics” (Hanser, New York, 1986) p. 443.
D. HULL, “An Introduction to Composite Materials” (Cambridge University Press, London, 1981).
H. L. COX, Br. J. Appl. Phys. 3 (1952) 72.
M. R. PIGGOT, Acta Metall. 14 (1966) 1429.
P. T. CURTIS, M. G. BADER and J. E. BAILEY, J. Mater. Sci. 13 (1978) 377.
M. R. PIGGOT, “Load Bearing Fibre Composites” (Pergamon Press, Oxford, 1980) p. 100.
Y. TERMONIA, J. Polym. Sci. Polym. Phys. 32 (1994) 969.
L. MONETTE, M. P. ANDERSON and G. S. GREST, Polym. Compos. 14 (1993) 101.
G. N. KARAM, J. Compos. Technol. Res. JCTRER 16 (1994) 154.
I. M. ROBINSON and J. M. ROBINSON, J. Mater. Sci. 29 (1995) 4663.
J. R. SARASUA, P. M. REMIRO and J. POUYET, ibid. 30 (1995) 3501.
A. KELLY and W. R. TYSON, J. Mech. Phys. Solids 13 (1965) 329.
K. K. CHAWLA, “Composites in Materials Science and Engineering” (Springer, New York, 1987) p. 177.
H. M. SMALLWOOD, J. Appl. Phys. 15 (1944) 758.
E. GUTH, ibid. 16 (1945) 20.
L. H. COHAN, India Rubber World 117 (1947) 343.
E. H. KERNER, Proc. Phys. Soc. 69B (1956) 808.
L. E. NIELSON, J. Appl. Phys. 4 (1970) 4626.
L. J. BROUTMAN and R. H. KROCK. “Modern Composite Materials” (Addison Wesley, Reading, MA, 1967).
T. J. HIRSCH, J. Am. Con. Inst. 59 (1962) 427.
C. RADHESH KUMAR, K. E. GEORGE and S. THOMAS, J. Appl. Polym. Sci., 61 (1996) 2383.
S. GEORGE, R. JOSEPH, K. T. VARUGHESE and S. THOMAS, Polymer 36 (1995) 4405.
B. W. ROSEN, in “Fibre Composite Materials” (American Society for Metals, Metals Park, OH, 1965) p. 58.
J. C. HALPIN and S. W. TSAI, “Environmental Factors in Composite Materials Design” (AFMLTR, 1967) p. 67.
J. R. LAYER and R. R. JUNE, J. Compos. Mater. 3 (1969) 48.
L. E. NIELSON, “Mechanical Properties of Polymers and Composites”, Vol. 2 (Marcel Dekker, New York, 1974).
L. E. NIELSON, Rheol. Acta 13 (1974) 86.
W. H. BOWYER and M. G. BADER, J. Mater. Sci. 7 (1972) 1315.
M. H. LADIZESKY and I. M. WARD, Compos. Sci. Technol. 26 (1986) 139.
K. JOSEPH, S. THOMAS, C. PAVITHRAN and M. BRAMHAKUMAR, J. Appl. Sci. 47 (1993) 1731.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
KALAPRASAD, G., JOSEPH, K., THOMAS, S. et al. Theoretical modelling of tensile properties of short sisal fibre-reinforced low-density polyethylene composites. Journal of Materials Science 32, 4261–4267 (1997). https://doi.org/10.1023/A:1018651218515
Issue Date:
DOI: https://doi.org/10.1023/A:1018651218515