D.C. I–V characteristics and steady-state photoconductivity of Au/Pb2CrO5/SnO2 sandwich-structure films under illumination in the visible region

Abstract

The room temperature d.c. current–voltage (I–V) characteristics of an Au/Pb2CrO5/SnO2 sandwich-structure 1.39 μm thick film have been measured for d.c. voltages, Vd.c., in the range 0.25 V≤Vd.c.≤5.0 V. These measurements were carried out under both dark and visible-light illumination conditions. For Vd.c.<2.5 V, the I–V curves of the sample in both dark and light environments were found to be non-linear and conform to space-charge-limited (SCL) current governed by traps uniformly distributed in energy. At higher d.c. voltages, a nearly Mott–Gurney V2 behaviour of the dark current has been observed, whereas the I–V behaviour of the illuminated specimen was a combination of an ohmic conduction and a V2 dependence at low illumination levels and became highly ohmic at large light intensities. This behaviour can be understood in terms of a reduction in the SCL dark current in favour of a larger ohmic d.c. photocurrent as a result of neutralization of the majority-carrier space charge by the photogenerated minority carriers of the electron–hole pairs produced under the illumination with visible light of energy ℏω≅EG(∼2.1–2.3 eV for the Pb₂CrO₅ material). The d.c. photocurrent, I_phot, at a fixed d.c. voltage, was found to follow a power-law dependence on light intensity, F, of the form I_phot∝F^γ, with the exponent γ being dependent on the applied d.c. voltage. At the low-voltage side (V_d.c.<1.5 V), γ∼0.5, a value usually obtained when the photoconductivity behaviour is governed by bimolecular recombination mechanisms. As the d.c. voltage is increased further, γ increases monotonically until it saturates at a value of about 0.9 for d.c. voltages beyond 3.5 V, where monomolecular recombination processes seem to be more operative with increasing d.c. voltage.