Abstract
Results of an investigation of the influence of the parameters of a sintered porous copper coating on heat transfer under conditions of propane boiling are reported. The experiments were carried out within the ranges of specific heat fluxes of q = 102–6.4·104 W/m2 and of saturation vapor pressures of p s = 0.48–1.08 MPa (T s = 0–30°C). Optimum parameters of the porous coating were determined within the investigated saturation pressure range. A dimensionless equation is suggested for determination of the heat‐transfer rate in propane boiling on sintered porous copper coatings.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
REFERENCES
L. L. Vasil'ev, V. V. Khrolenok, and A. S. Zhuravlev, in: Heat and Mass Transfer-97 [in Russian], Minsk (1997), pp. 9–14.
M. N. Novikov, Vestn. GGTU, No. 2, 58–66 (2000).
A. G. Sirotin, in: Boiling and Condensation [in Russian], Riga (1984), pp. 20–27.
L. I. Roizen, D. G. Rachitskii, I. R. Rubin, et al., Teplofiz. Vys. Temp., 20, No. 2, 304–310 (1982).
V. I. Tolubinskii, Boiling Heat Transfer [in Russian], Kiev (1980).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Novikov, M.N. Optimization of the Parameters of a Porous Coating under Conditions of Pool Boiling of Propane. Journal of Engineering Physics and Thermophysics 75, 134–139 (2002). https://doi.org/10.1023/A:1014883009905
Issue Date:
DOI: https://doi.org/10.1023/A:1014883009905