Skip to main content
SpringerLink
Log in

A New Test to Evaluate the Fire Performance of Residential Sprinklers

  • Published:
Fire Technology Aims and scope Submit manuscript

Abstract

Fire tests were conducted using the Underwriters Laboratories (UL) UL 1626 Fire Test for residential sprinklers. The results indicated that sprinkler performance in UL 1626 could not be reproduced due to differences in material flammability properties. This conclusion was reached in a cooperative effort with UL. Factory Mutual Research's Approval fire test that had been redesigned based on UL 1626 was thus subject to the same variability. A new fire test was developed using fuel with controlled material flammability parameters based upon the use of the ASTM E2058 Fire Propagation Apparatus. The new fuel package consists of a wood crib (one half the height of the one which was used in UL 1626) supported over a pan with heptane, two polyether foam cushions (about 60% greater in density than the foam previously used in UL 1626) measuring 34 in by 30 in by 3 in (864 mm by 762 mm by 76 mm) and \( \frac{1}{4}\) in (6 mm) Douglas Fir plywood paneling. The new fire test was shown in a series of sprinklered fire tests to provide a reproducible challenge to residential sprinklers comparable to that observed in the Factory Mutual Research and the Los Angeles Residential Test Programs.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. H.-C. Kung, R.D. Spaulding, E.E. Hill, and A.P. Symonds, “Field Evaluation of Residential Prototype Sprinkler—Los Angeles Fire Test Program,” Technical Report J.I. 0E0R3.RA(1), Factory Mutual Research Corporation, Norwood, MA, February 1982.

    Google Scholar 

  2. “Standard for the Installation of Sprinkler Systems in One-and Two-Family Dwellings and Mobile Homes,” NFPA 13-D-1984, National Fire Protection Association, Batterymarch Park, Quincy, MA, 1984.

  3. H.-C. Kung, R.D. Spaulding, and E.E. Hill, Jr., “Sprinkler Performance in Residential Fire Tests,” Technical Report RC80-T-16, Serial No. 22574, Factory Mutual Research Corporation, Norwood, MA, July 1980.

    Google Scholar 

  4. H.-C. Kung, R.D. Spaulding, and E.E. Hill, Jr., “Sprinkler Performance in Living Room Fire Tests: Effect of Link Sensitivity and Room Size,” Technical Report FMRC J.I. 0F0N5.RA, Factory Mutual Research Corporation, July 1983.

  5. “Approval Standard—Residential Automatic Sprinklers,” Class 2030, Factory Mutual Research Corporation, Norwood, MA, September 1983.

  6. B.G. Vincent, H.-C. Kung, and E.E. Hill, “Residential Sidewall Sprinkler Fire Tests with Limited Water Supply,” Technical Report J.I. 0M3N5.RA(2), Factory Mutual Research Corporation, Norwood, MA, February 1988.

    Google Scholar 

  7. R.G. Bill, Jr., H.-C. Kung, W.R. Brown, and E.E. Hill, “Effects of Cathedral and Beamed Ceiling Construction on Residential Sprinkler Performance,” Proceedings of the 2nd International Symposium for Fire Safety Science, Tokyo, Japan: Hemisphere Publishing Corp., 1988, pp. 643–653s.

    Google Scholar 

  8. R.G. Bill, Jr., H.-C. Kung, W.R. Brown, E.E. Hill, and R.D. Spaulding, “Predicting the Suppression Capability of Quick Response Sprinklers in a Light Hazard Scenario, Part 1: Fire Growth and Required Delivered Density (RDD) Measurements,” J. Fire Protect. Engr., vol. 3, no.3, 1991, pp. 79–91.

    Google Scholar 

  9. R.G. Bill, Jr., H.-C. Kung, B.G. Vincent, W.R. Brown, and E.E. Hill, “Predicting the Suppression Capability of Quick Response Sprinklers in a Light Hazard Scenario, Part 2: Actual Delivered Density (ADD) Measurements and Full-Scale Tests,” Journal of Fire Protection Engineering, vol. 3, no.3, 1991 pp. 93–105.

    Google Scholar 

  10. R.G. Bill, Jr. and H.-C. Kung, “Limited-Water-Supply Sprinkler for Manufactured (Mobile) Homes,” Fire Technology, vol. 29, 1993, pp. 203–225.

    Google Scholar 

  11. R.G. Bill, Jr. and E.E. Hill, Jr., “Sprinkler Protection of Manufactured Homes with Sloped Ceilings Using Prototype Limited-Water-Supply Sprinklers,” Fire Technology, vol. 31, 1995, pp. 5–16.

    Google Scholar 

  12. “Proposed First Edition of the Standard for Residential Sprinklers for Fire Protection Service,” UL 1626, Underwriters Laboratory, Inc., Northbrook, IL, April 1986.

  13. “Fire Protection Equipment Directory,” Underwriters Laboratories Inc., Northbrook, IL 1998.

  14. R.G. Bill, Jr., P. Stavrianidis, E.E. Hill, Jr., and W.R. Brown, “Water Mist Fire Protection in Residential Occupancies,” Technical Report J.I. 0Y1N9.RA, Factory Mutual Research Corporation, Norwood, MA, November 1995.

    Google Scholar 

  15. R.G. Bill, Jr., R. Ferron, and A. Braga, “Water Mist (Fine Spray) Protection in Light Hazard Occupancies,” Journal of Fire Protection Engineering, vol. 3, no.0, 2000, pp. 1–22.

    Google Scholar 

  16. ASTM E-2058-00, “Standard Test Method for Measurement of Synthetic Polymer Material Flammability Using a Fire Propagation Apparatus (FPA),” ASTM, West Conshohocken, PA.

  17. A. Tewarson, “Generation of Heat and Chemical Compounds in Fires,” in The SFPE Handbook of Fire Protection Engineering, 2nd ed., National Fire Protection Assoc., Quincy MA, 1995, Section 3/Chapter 4.

    Google Scholar 

  18. ASTM E84-97A, “Standard Test Method for Surface Burning Characteristics of Building Materials,” 1997 Annual Book of ASTM Standards, vol. 4.07, ASTM, West Conshohocken, PA, 1997.

    Google Scholar 

  19. R.G. Bill, Jr. and S.K. Anderson, “An Evaluation of the UL 1626 Residential Fire Test,” Technical Report, J.I. 0003000723, Factory Mutual Research, Norwood, MA, May 1999.

  20. “Standard for the Installation of Sprinkler Systems,” NFPA 13, 1999 Edition, National Fire Protection Association, Quincy, MA.

  21. “Standard for the Installation of Sprinkler Systems,” TIA 88-1 (NFPA 13), Reference: 7-9.2.2, 1999 Edition, National Fire Protection Association, Quincy, MA.

  22. ASTM E 1354, “Standard Test Method for Heat and Visible Smoke Release Rates for Materials and Products Using an Oxygen Consumption Calorimeter,” ASTM, West Conshohocken, PA.

  23. R.G. Bill, Jr., H.-C. Kung, S.K. Anderson, and R. Ferron, “A New Test to Evaluate the Fire Performance of Residential Sprinklers,” Technical Report J.I. 0003004531, Factory Mutual Research, Norwood, MA, January 2001.

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Factory Mutual Research, 1151 Boston-Providence Turnpike, Norwood, MA, 02062

    Robert G. Bill, Hsiang-Cheng Kung, Scott K. Anderson & Richard Ferron

Authors
  1. Robert G. Bill
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Hsiang-Cheng Kung
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Scott K. Anderson
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Richard Ferron
    View author publications

    You can also search for this author in PubMed Google Scholar

Rights and permissions

Reprints and permissions

About this article

Cite this article

Bill, R.G., Kung, HC., Anderson, S.K. et al. A New Test to Evaluate the Fire Performance of Residential Sprinklers. Fire Technology 38, 101–124 (2002). https://doi.org/10.1023/A:1014407200101

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1023/A:1014407200101

Search

Navigation