Abstract
An aqueous solution process has been used for dip coating onto substrates of 316L stainless steel. Coatings of LiCoO2, Li(Co0.5Fe0.5)O2 and LiFeO2 were applied and heat treated to 650°C for 3 hrs. Thermal analysis, X-ray diffraction analysis, and SEM analysis were carried out to characterize the microstructure of the coatings. Results showed that the coatings transformed from a gel to a porous, crystalline layer between 270 and 350°C. Microhardness measurements at low load (50 g) were used as an indication of the surface coverage. Samples subjected to 10 thermal cycles at 10°C/min to 650°C and back to ambient, to simulate use in a molten carbonate fuel cell, showed no decrease in microhardness.
Similar content being viewed by others
References
K. Kordesch and G. Simader, Fuel Cells and their Applications (VCH/Weinheim, New York, 1996).
C. Yuh, R. Johnsen, M. Farooque, and H. Maru, J. Power Sources 56, 1 (1995).
P. Biendenkopf, M. Spiegel, and H.J. Grabke, Materials and Corrosion 48, 731 (1997).
M. Murai, K. Takazawa, K. Soejima, and H. Sotouchi, J. Electrochem. Soc. 143, 2481 (1996).
R.C. Makkus, K. Hemmes, and J.H.W. deWit, J. Electrochem. Soc. 141, 3429 (1994).
J. Rouxel and M. Tournoux, Solid State Ionics 84, 141 (1996).
P. Barboux, J.M. Tarascon, and F.K. Shokoohi, J. Solid State Chemistry 94, 185 (1991).
A. Lundblad and B. Bergman, Solid State Ionics 96, 173 (1997).
A. Lundblad and B. Bergman, Solid State Ionics 96, 183 (1997).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Chen, W., Klein, L. & Huang, C. Solution Preparation of Li(Co, Fe)O2 Coatings for Molten Carbonate Fuel Cell Components. Journal of Sol-Gel Science and Technology 21, 203–211 (2001). https://doi.org/10.1023/A:1011234621460
Issue Date:
DOI: https://doi.org/10.1023/A:1011234621460