Abstract
The size distribution of aerosols was measured near traffic intersections of Marol link road in air quality control region (AQCR1), which is a moderately industrial area and Dadar Khodad circle in AQCR2, which is a heavily commercial core of the Mumbai City. The reason behind selecting the two unidentical regions was to study the contribution from vehicles to the size separated PM10 and that of Pb. It is recognised that particulates in urban air are responsible for serious health effects. As very small particles are assumed to be important for the adverse health effects, the particle size distribution is thus an important factor that needs to be addressed whenever the particulates pollution is concerned. The size measurements were done with a cascade impactor of eight stages with a back-up filter. It effectively separates the particulate matter into nine-sizes ranging from 0.0–0.4 to 9.0–10.0 μm. Samples were analysed in nine-particle size fractions with special reference to a toxic metal – lead (Pb) by atomic absorption spectrophotometry (AAS). It was found that PM10 and Pb at both the intersections could easily be classified by the size distribution. The fractions of the PM10 and that of Pb showing a tendency of trimodal distributions with the first peak at coarse mode ∼9.0–10.0 μm, second at ∼5.8 μm and the third at coarse mode ∼1.1 μm. The significant percentage of Pb was found in the range below 2.5 μm at both the intersections. However, Pb in AQCR1 is found in the coarserrange as well, which could probably be the influence of various industrial activities in the area. PM10 concentration values in the coarser range in AQCR2 are associated with the resuspension of dust particles and mechanical erosions.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Aceves, M. and Grimalt, J. O.: 1993, ‘Seasonally dependent size distributions of aliphatic and polycyclic aromatic hydrocarbons in urban aerosols from densely populated areas’, Environ. Sci. Technol. 27, 2896–2908.
American Conference of Governmental Industrial Hygienists (ACGIH): 1994–1995, ‘TLVs for Chemical Substances and Physical Agents and Biological Exposure Indices’, ACGIH Publications, Kemper-Woods Center, Cincinnati, pp. 42–46.
Anderson: 1992, Standard Manual for Anderson Sampler, Anderson Samplers Inc., Atlanta, Georgia.
Carl, T. V., Martin A. J. and John, H. J.: 1976, ‘The measurement and analysis of the physical character of diesel particulate emissions’, Soc. Automotive Eng., Paper 760131, pp. 555–597.
Chan, T. L. and Lawson, D. R.: 1981, ‘Characteristics of cascade impactor in size determination of diesel particles’, Atmos. Environ. 15, 1273–1279.
Charles, H. M.: 1984, Handbook of Particle Sampling and Analysis Methods, Verlag Chemie International, Florida.
Cooper, D. W. and Guttrich, G. L.: 1981, ‘A study of the cut diameter concept for interpreting particle sizing data’, Atmos. Environ. 15, 1699–1707.
Fernandez, A. J., Ternero, M., Barragan, F. J. and Jimenez, J. C.: 2001, ‘Size distribution of metals in urban aerosols in Seville (Spain)’, Atmos. Environ. 35, 2595–2601.
Gad Shani, Haccoun, A. and Kushelevsky, A.: 1984, ‘Aerosol and air pollution size distribution’, Atmos. Environ. 18, 2223–2229.
Gokhale, S. B.: 1996, ‘Monitoring and Prediction of Aerosols from Vehicular Sources’, M.-Tech Dissertation, Indian Institute of Technology, Bombay, India.
Infante, R. and Acosta, I. L.: 1991, ‘Size distribution of trace metals in Ponce, Puerto Rico air particulate matter’, Atmos. Environ. 25B, 121–131.
International Organization for Standardization (ISO), 1995, ISO7708: 1995 (E): ‘Air Quality-Particle Size Fraction Definitions for Health Related Samplings’, ISO Publications, 1st edition, 1995-04-01.
Lodge, J. P. and Waggoner, A. P.: 1981, ‘Non-health effects of airborne particulate matter’, Atmos Environ. 15, 431–482.
Michaud, D., Baril, M., Dion, Ch. and Perrault, G.: 1996, ‘Characterization of airborne dust from two nonferrous foundries by physico-chemical methods and multivariate statistical analysis’, Air Waste Manage. Assoc. 46, 450–457
O'connor, B. H., Kerrigan, G. C., Thomas, W. W. and Pearce, A. T.: 1977, ‘Use of bromine levels in airborne particulate samples to infer vehicular lead concentrations in the atmosphere’, Atmos. Environ. 11, 635–638.
Puttock, J. S.: 1981, ‘Data inversion for cascade impactors: Fitting sums of log-normal distributions’, Atmos. Environ. 15, 1709–1716.
Sadasivan, S., Negi, B. S. and Mishra, U. C.: 1987, ‘Atmospheric lead levels in some cities of India’, Indian J. Environ. Health 29, 280–286.
Santanaria, J., Fernandez, M., Mendez, J. and Bomboi, M. T.: 1990 ‘Particle size distribution of metals in the atmosphere of Madrid (Spain)’, Fresenius J. Anal. Chem. 337, 362–365.
Trijonis, J.: 1983, ‘Development and application of methods for estimating inhalable and fine particle concentrations from routine hi-vol data’, Atmos. Environ. 17, 999–1008.
Winchester, J. W. and Mu-Tian, Bi.: 1984, ‘Fine and coarse aerosol composition in a urban setting: A case study in Beijing, China’, Atmos. Environ. 18, 1399–1409.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Gokhale, S.B., Patil, R.S. Size Distribution of Aerosols (PM10) and Lead (Pb) near Traffic Intersections in Mumbai (India). Environ Monit Assess 95, 311–324 (2004). https://doi.org/10.1023/B:EMAS.0000029911.81865.b6
Issue Date:
DOI: https://doi.org/10.1023/B:EMAS.0000029911.81865.b6