Abstract
The distributions of heat flux along the height and the circumferential direction of round billet mould were measured continuously. The influence of casting speed, carbon content, powder, and pouring temperature on the average longitudinal and circumferential heat flux in the “high heat flux region” was discussed. The experimental and analytical results provide a basis for an intelligent mould with online detection of defects, adjustment of operational parameters, optimization of the monitoring system, and even prediction of abnormal heat transfer.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
YANG Li-min. Heat Flux Calculation and Visualization Research of Mould Powder in Round Billet Continuous Casting [D]. Dalian, China: Dalian University of Technology, 2005 (in Chinese).
Chow C, Samarasekera I V. High Speed Continuous Casting of Steel Billets Part 1: General Overview [J]. Ironmaking and Steelmaking, 2002, 29(1): 53.
Pinheiro C A M, Samarasekera I V, Brimacombe J K, et al. Mould Heat Transfer and Continuously Cast Billet Quality With Mould Flux Lubrication Part 1 Mould Heat Transfer [J]. Ironmaking and Steelmaking, 2000, 27(1): 37.
Kumar S, Meech J A, Samarasekera I V, et al. Development of Intelligent Mould for Online Detection of Defects in Steel Billets [J]. Ironmaking and Steelmaking, 1999, 26(4): 269.
Chow C, Samarasekera I V, Walker B N, et al. High Speed Continuous Casting of Steel Billets Part 2: Mould Heat Transfer and Mould Design [J]. Ironmaking and Steelmaking, 2002, 29(1): 61.
YAO Man, YIN He-bei, FANG Da-cheng. Real-Time Analysis on Non-Uniform Heat Transfer and Solidification in Mould of Continuous Casting Round Billets [J]. ISIJ International, 2004, 44(10): 1696.
Yao M, Yin H, Wang J C, et al. Monitoring and Analysis of Local Mould Thermal Behaviour in Continuous Casting of Round Billets [J]. Ironmaking and Steelmaking, 2005, 32(4): 360.
YIN He-bi. Analysis of Thermo-Mechanical Behaviors in the Mould for Small Round Billet Continuous Casting [D]. Dalian, China: Dalian University of Technology, 2005 (in Chinese).
Alvarez de Toledo G, Ciriza J, Laraudogoitia J J, et al. Abnormal Transient Phenomena in the Continuous Casting Process: Part 2 [J]. Ironmaking and Steelmaking, 2003, 30(5): 360.
Author information
Authors and Affiliations
Corresponding author
Additional information
Foundation Item: Item Sponsored by Science and Technology Research Project of Ministry of Education of China (03051)
Rights and permissions
About this article
Cite this article
Zhan, Hy., Wang, Xd., Guo, Ll. et al. Real Heat Flux Analysis of Continuously Casting Round Billet. J. Iron Steel Res. Int. 15, 25–29 (2008). https://doi.org/10.1016/S1006-706X(08)60006-0
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1016/S1006-706X(08)60006-0