Avoid common mistakes on your manuscript.
1 Correction to: Nanomanufacturing and Metrology (2021) 4:156–164 https://doi.org/10.1007/s41871-021-00102-w
The original version of this article unfortunately contained a mistake. The following declaration text was missing.
Eberhard Manske is an editorial board member for "Nanomanfucturing and Metrology" and was not involved in the editorial review, or the decision to publish this article. All authors declare that there are no competing interests.
The original article has been corrected.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
About this article
Cite this article
Schienbein, R., Fern, F., Theska, R. et al. Correction: Fundamental Investigations in the Design of Five-Axis Nanopositioning Machines for Measurement and Fabrication Purposes. Nanomanuf Metrol 5, 437 (2022). https://doi.org/10.1007/s41871-022-00162-6
Published:
Issue Date:
DOI: https://doi.org/10.1007/s41871-022-00162-6