Microstructural properties of nano-rice husk ash concrete

Abstract

In modern science, the material behavior can be controlled by incorporating nano-building blocks or objects in concrete. Nanoparticle used in this study is rice husk ash. By using SEM analysis, the size of the nanoparticle was found to be in a range of 70–90 nm. In this investigation, the durability characteristics of concrete modified with fly ash and nano-rice husk ash in M35 grade are determined. Two different samples were prepared: one by replacing 3% nano-RHA with concrete and the other sample by replacing 20% fly ash with concrete. The tests conducted in this works are carbonation test, rapid chloride penetration test, surface and crushed pH test, antibacterial test, porosity test. Nano-RHA concrete shows better results when compared with fly ash concrete.

This is a preview of subscription content, log in to check access.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

References

  1. 1.

    Nazari A, Riahi S (2011) Improvement compressive strength of concrete in different curing media by Al2O3 nanoparticles. Mater Sci Eng, A 528(3):1183–1191

    Article  Google Scholar 

  2. 2.

    Givi AN, Rashid SA, Farah NA, Aziz MA, Salleh M (2010) Experimental investigation of the size effects of SiO2 nano-particles on the mechanical properties of binary blended concrete. Compos B Eng 41(8):673–677

    Article  Google Scholar 

  3. 3.

    Land G, Stephan D (2015) Controlling cement hydration with nanoparticles. Cement Concr Compos 57:64–67

    Article  Google Scholar 

  4. 4.

    Shaikh FUA, Supit SWM (2014) Mechanical and durability properties of high volume fly ash (HVFA) concrete containing calcium carbonate (CaCO3) nanoparticles. Constr Build Mater 70:309–321

    Article  Google Scholar 

  5. 5.

    Shaikh FUA, Supit SWM (2015) Compressive strength and durability of high-volume fly ash concrete reinforced with calcium carbonate nanoparticles. Fillers Reinforcements Adv Nanocomposites 11:275–307

    Article  Google Scholar 

  6. 6.

    Liu J, Li Q, Shilang X (2015) Influence of nanoparticles on fluidity and mechanical properties of cement mortar. Constr Build Mater 101(Part 1):892–901

    Article  Google Scholar 

  7. 7.

    Singh LP, Ali D, Sharma U (2016) Studies on optimization of silica nanoparticles dosage in cementitious system. Cement Concr Compos 70:60–68

    Article  Google Scholar 

  8. 8.

    Niewiadomski P, Ćwirzeń A, Hoła J (2015) The influence of an additive in the form of selected nanoparticles on the physical and mechanical characteristics of self-compacting concrete. Procedia Eng 111:601–606

    Article  Google Scholar 

  9. 9.

    Ronzhya YR, Praveenkumar TR (2015) Durability study of self compacting concrete using hybrid glass fibres. Int J ChemTech Res 8(2):836–844

    Google Scholar 

  10. 10.

    Praveenkumar TR, Vijayalakshmi MM (2015) Effect of nano particles on the properties of concrete. Int J ChemTech Res 8(7):50–55

    Google Scholar 

  11. 11.

    Yu S, Li J, Chengqing W, Pengtao W, Li Z-X (2016) Influences of nano-particles on dynamic strength of ultra-high performance concrete. Compos B Eng 91:595–609

    Article  Google Scholar 

  12. 12.

    Priya AK, Nithya M, Rajeswari M, Priyanka PM, Vanitha R (2016) Experimental investigation on developing low cost concrete by partial replacement of waste sludge. Int J ChemTech Res 9(1):240–247

    Google Scholar 

  13. 13.

    Madhavi TC, Pavan Kumar PVR, Jothilingam M (2015) Effect of copper slag on the mechanical strengths of concrete. Int J ChemTech Res 8(12):442–449

    Google Scholar 

  14. 14.

    Anjali D, Vivek SS, Dhinakaran G (2015) Compressive strength of metakaolin based self-compacting concrete. Int J ChemTech Res 8(2):622–625

    Google Scholar 

  15. 15.

    Praveen Kumar TR, Sudheesh C, Sasi Kumar S (2015) Strength characteristics of saw dust ash based geopolymer concrete. Int J ChemTech Res 8(2):738–745

    Google Scholar 

  16. 16.

    Santhiyaa Jenifer J, Ramasundaram S (2015) Strength and durability characteristics of laterite sand mixed concrete. Int J ChemTech Res 8(3):1253–1259

    Google Scholar 

  17. 17.

    Kirthika K, Praveenkumar TR (2015) Experimental investigation on flexural behavior of glass beams with stainless steel. Int J ChemTech Res 8(8):183–187

    Google Scholar 

  18. 18.

    Kumar KR, Yalamesh G, Ramakrishnan K (2015) Study of strength of concrete by partially replacing fine aggregate with bottom ash and marine sand. Int J ChemTech Res 8(8):161–166

    Google Scholar 

  19. 19.

    Abhiram K, Saravanakumar P (2015) Properties of recycled aggregate concrete containing hydrochloric acid treated recycled aggregates. Int J ChemTech Res 8(1):72–78

    Google Scholar 

  20. 20.

    ASTM C1202 (2017) Standard test method for electrical indication of concrete’s ability to resist chloride ion penetration. ASTM, West Conshochocken

    Google Scholar 

Download references

Acknowledgement

We express our sincere acknowledgement to the management of Sathyabama Institute of Technology for providing an opportunity to carry out this research work.

Author information

Affiliations

Authors

Corresponding author

Correspondence to T. R. Praveenkumar.

Ethics declarations

Conflict of interest

There is no conflict of interest among all the authors involved in this experimental work.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Praveenkumar, T.R., Vijayalakshmi, M.M. Microstructural properties of nano-rice husk ash concrete. Nanotechnol. Environ. Eng. 4, 9 (2019). https://doi.org/10.1007/s41204-019-0056-4

Download citation

Keywords

  • Fly ash
  • Nano-rice husk ash
  • Antibacterial test