Skip to main content

Advertisement

SpringerLink
Log in

Experimental investigation of a new sustainable approach for recycling waste styrofoam food containers in lightweight concrete

  • Technical paper
  • Published:
Innovative Infrastructure Solutions Aims and scope Submit manuscript

Abstract

The disposal and treatment of non-biodegradable styrofoam food containers are excessively expensive for any government. So, finding a technical economic solution to reuse and utilize these waste products in a sustainable environmentally friendly approach is a big challenge. This study represents a novel preliminary investigation of utilizing waste styrofoam food containers to partially replace the natural aggregate in lightweight concrete mixes. Six types of concrete mixes were prepared with different aggregates substitution percentages of 0%, 2.5%, 5%, 7.5%, 10%, and 12.5% by volume. The results indicated that the replacement of aggregate by appropriate WSFC content produced a workable concrete with a maximum density reduction of approximately 21.8% when the percentage replacement of the natural aggregate by waste styrofoam was 12.5%. The results revealed that compressive and flexural strength decreased with increasing the waste styrofoam content at different curing ages of 7, 14, 21, and 28 days. The maximum decrement ratio was 81.5% and 57% for compressive and flexural strength, respectively, for WSFC5 at 28-day curing, while, by increasing the temperature to 600 °C for one hour, the maximum decrement ratio of compressive strength was 10.18% compared to the plain concrete mix. Also, the results demonstrated that about 46% was the maximum decrement ratio of thermal conductivity for WSFC5 at 28-day curing compared to the plain concrete.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8

Similar content being viewed by others

References

  1. Cassidy K, Elyashiv-Barad S (2007) US FDA’s revised consumption factor for polystyrene used in food-contact applications. Food Addit Contam 24:1026–1031

    Article  Google Scholar 

  2. Chandra M, Kohn C, Pawlitz J, Powell G (2016) Real cost of styrofoam. Saint Louis University, Missouri, US, Experiential learning project study

    Google Scholar 

  3. Ingrao C, Giudice AL, Bacenetti J, Khaneghah AM, Sant’Ana AS, Rana R, Siracusa V (2015) Foamy polystyrene trays for fresh-meat packaging: life-cycle inventory data collection and environmental impact assessment. Food Res Int 76:418–426

    Article  Google Scholar 

  4. Huda MDN, Jumaat MZ, Islam ABMS, Al-kutti AA (2018) Performance of high strength lightweight concrete using palm wastes. IIUM Eng J 19:30–41

    Article  Google Scholar 

  5. Nazreen MS, Mohamed RN, Ab Kadir MA, Azillah N, Shukri NA, Mansor S, Zamri F (2018), Characterization of lightweight concrete made of palm oil clinker aggregates, MATEC Web of Conferences, 250 03002

  6. Ismail ZZ, Al-Hashmi EA (2008) Reuse of waste iron as a partial replacement of sand in concrete. Waste Manag 28:2048–2053

    Article  Google Scholar 

  7. Ismail ZZ, Al-Hashmi EA (2009) Recycling of waste glass as a partial replacement for fine aggregate in concrete. Waste Manag 29:655–659

    Article  Google Scholar 

  8. Ismail ZZ, Jaeel AJ (2014) A novel use of undesirable wild giant reed biomass to replace aggregate in concrete. Constr Build Mater 67:68–73

    Article  Google Scholar 

  9. Ismail ZZ, Abdelkareem HN (2015) Sustainable approach for recycling waste lamb and chicken bones for fluoride removal from water followed by reusing fluoride-bearing waste in concrete. Waste Manag 45:66–75

    Article  Google Scholar 

  10. Aljubori DE, Al-Hubboubi SK, Alwared AI (2018) Thermal properties of lead-acid battery plastic lightweight concrete. J Eng 24:35–44

    Article  Google Scholar 

  11. Alwared AI, Jaeel AJ, Ismail ZZ (2019) Recycling of waste compact discs in concrete mix: lab investigations and artificial neural networks modeling. J Solid Waste Technol Manag 45:369–379

    Article  Google Scholar 

  12. Záleská M, Pavlíková M, Jankovský O, Pokorný J, Pavlík Z (2018) Lightweight concrete made with waste expanded polypropylene-based aggregate and synthetic coagulated amorphous silica. Ceramics-Silikáty 62:221–232

    Article  Google Scholar 

  13. Bui NK, Satomi T, Takahashi H (2018) Recycling woven plastic sack waste and PET bottle waste as fiber in recycled aggregate concrete: an experimental study. Waste Manag 78:79–93

    Article  Google Scholar 

  14. Belmokaddem M, Mahi A, Senhadji Y, Pekmezci BY (2020) Mechanical and physical properties and morphology of concrete containing plastic waste as aggregate. Constr Build Mater 257:119559

    Article  Google Scholar 

  15. Zhang Y, Chen D, Liang Y, Qu K, Kong M (2020) Study on engineering properties of foam concrete containing waste seashell. Constr Build Mater 260:119896

    Article  Google Scholar 

  16. Guo P, Meng W, Nassif H, GouBao HY (2020) New perspectives on recycling waste glass in manufacturing concrete for sustainable civil infrastructure. Constr Build Mater 257:119579

    Article  Google Scholar 

  17. Ahmed H, Lee YL, Omer RC, Malek MA (2008) Mix design of styrofoam concrete, Proceeding of International Conference on Construction and Building Technology (ICCBT). 285–296

  18. S.S.L.B.B. Sham (2011) Styrofoam waste as bitumen modifier in hot mix asphaltic concrete. PhD thesis, Department of Civil Engineering, Universiti Teknologi PETRONAS

  19. Caderea CA, Barbuta M, Rosca B, Serbanoiu AA, Burlacu A, Oancea I (2018) Engineering properties of concrete with polystyrene granules. Procedia Manuf 22:288–293

    Article  Google Scholar 

  20. British Standard Institution (1952), Methods of testing concrete, B.S.1881, BSI, London

  21. American Society for Testing and Materials (1979) Standard test method for flexural strength of concrete (using simple beam with center-point loading), ASTM C293, Annual book of ASTM standards

  22. American Society for Testing and Materials (1988) Standard practice for making and curing concrete test specimens in laboratory. ASTM C192, Annual book of ASTM standards

  23. Koehler EP, Fowler DW (2003) ICAR 105: measuring the workability of high fines concrete for aggregate. University of Texas at Austin, International Center for Aggregate Research

    Google Scholar 

  24. Moon AS, Pradnya B, Lingait PB, Meshram SB, Maske MS, Mohinkar KG, Chimurkar KS (2020) Investigation of EPS concrete. Int Res J Eng Technol (IRJET) 7:6269–6272

    Google Scholar 

  25. Marzouk OY, Dheilly RM, Queneudec M (2007) Valorization of post-consumer waste plastic in cementitious concrete composites. Waste Manag 27:310–318

    Article  Google Scholar 

  26. Pezzi L, De Lice P, Vuono D, Chiappetta F, Nastro A (2006) Concrete products with waste’s material (bottle, glass, plate). Mater Sci Forum 514–516:1753-0

    Google Scholar 

  27. Arivumangai A, Felixkala T (2015) Experimental investigation on fire resistance of granite powder concrete. Int J Appl Eng Res 10:21675–21680

    Google Scholar 

  28. Badur S, Chaudhary R (2008) Utilization of hazardous waste and by- products as a green concrete material through S/S process: a review. Rev Adv Mater Sci 17:42–61

    Google Scholar 

  29. Poonyakan A, Rachakornkij M, Wecharatana M, Smittakorn W (2018) Potential use plastic wastes for low thermal conductivity concrete. Materials 11:1938

    Article  Google Scholar 

  30. Chandru G, Vijay N, Vignesh V, Sachin VK (2017) Study on behavior of concrete blocks with EPS and partial replacement of fly ash and quarry dust. Int J Adv Eng Res Sci 4(1):236–239

    Article  Google Scholar 

  31. Nassar R-U-D, Soroushian P (2012) Strength and durability of recycled aggregate concrete containing milled glass as partial replacement for cement. Constr Build Mater 29:368–377

    Article  Google Scholar 

  32. Dhanalakshmi A, Ayyathurai P (2006) Behavioral study on lightweight concrete. Int J Sci Res 5:1521–1524

    Google Scholar 

  33. Kartini K, Mahmud HB, Hamidah MS (2010) Absorption and permeability performance of Selangor rice husk ash blended grade 30 concrete. J Eng Sci Technol 5:1–5

    Google Scholar 

  34. Pitroda J, Umrigar FS (2013) Evaluation of sorptivity and water absorption of concrete with partial replacement of cement by thermal industry waste (Fly Ash). Int J Eng Innova Technol 2:245–249

    Google Scholar 

Download references

Acknowledgement

The authors acknowledge laboratory support extended from the Department of Civil Engineering, University of Wasit, Iraq, throughout this study. Also, the authors would like to extend their appreciation to the National Center for Construction Laboratories, the Ministry of Construction, and the Housing and General Municipalities in Iraq for technical their support.

Author information

Authors and Affiliations

  1. Department of Environmental Engineering, University of Baghdad, Baghdad, Iraq

    Zainab Z. Ismail & Abeer M. Alwared

  2. Department of Civil Engineering, University of Wasit, Wasit, Iraq

    Ali J. Jaeel

  3. Barry University, Miami, FL, USA

    Anita Závodská

Authors
  1. Zainab Z. Ismail
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Ali J. Jaeel
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Abeer M. Alwared
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Anita Závodská
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Zainab Z. Ismail.

Ethics declarations

Conflict of interest

The authors would like to confirm that they do not have competing interests to declare.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Ismail, Z.Z., Jaeel, A.J., Alwared, A.M. et al. Experimental investigation of a new sustainable approach for recycling waste styrofoam food containers in lightweight concrete. Innov. Infrastruct. Solut. 6, 110 (2021). https://doi.org/10.1007/s41062-021-00463-7

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s41062-021-00463-7

Keywords

Search

Navigation