Advertisement

International Journal of Civil Engineering

, Volume 16, Issue 4, pp 409–419 | Cite as

Numerical Simulation of Soil Stress State Variations due to Mini-Pile Penetration in Clay

  • Mohammadreza Khanmohammadi
  • Kazem Fakharian
Research Paper

Abstract

During installation of prefabricated piles in saturated clayey soils, excess pore water pressure (EPWP) is generated around the pile shaft and tip. The developed excess pore pressure is extremely important for evaluation of changes of stress state in clay and subsequent pile bearing capacity. Therefore, the main objective of this paper is to present a numerical finite-element model (FEM) to simulate a mini-pile installation and subsequent pore water pressure dissipation over time. The mini-pile is inserted from the ground surface into the soil to the desired depth. The numerical model is validated using the results of a physical model in which a piezocone is penetrated into a consolidation chamber containing saturated clay. The effects of Over-Consolidation Ratio (OCR), coefficient of lateral soil pressure (K0), penetration rate (PR), and soil hydraulic conductivity (K i ) on soil stress state are investigated. The verification results have shown that the numerical model has successfully simulated the penetration of mini-pile, generation, and subsequently dissipation of the excess pore water pressure (EPWP). The parametric study revealed that increasing the OCR and K0 has resulted in increase of the effective radial stresses on the pile skin compared to its initial value, after dissipation of EPWP. The results indicate that the variations in radial stresses at the end of dissipation are independent from the penetration rate. The dissipation of EPWP is more correlated with horizontal hydraulic conductivity of the soil, because the dissipation rate is accelerated in the radial direction.

Keywords

Mini-pile installation Numerical modeling Soil stress state Saturated clay Parametric studies 

Notes

Compliance with ethical standards

Funding

No funding information available.

References

  1. 1.
    Trochanis AM, Bielak J, Christiano P (1991) Three-dimensional nonlinear study of piles. J Geotech Eng 117(3):429–447CrossRefGoogle Scholar
  2. 2.
    Sharafi H, Sojoudi Y (2016) Experimental and numerical study of pile-stabilized slopes under surface load conditions. Int J Civil Eng. doi: 10.1007/s40999-016-0017-2 Google Scholar
  3. 3.
    Mabsout ME, Tassoulas JL (1994) A finite element model for the simulation of pile driving. Int J Numer Methods Eng 37(2):257–278. doi: 10.1002/nme.1620370206 CrossRefzbMATHGoogle Scholar
  4. 4.
    Lee J, Kim Y, Jeong S (2010) Three-dimensional analysis of bearing behavior of piled raft on soft clay. Comput Geotech 37(1):103–114CrossRefGoogle Scholar
  5. 5.
    Mabsout M, Sadek S (2003) A study of the effect of driving on pre-bored piles. Int J Numer Anal Methods Geomech 27(2):133–146CrossRefzbMATHGoogle Scholar
  6. 6.
    Chung S-H, Yang S-R (2016) Numerical analysis of small-scale model pile in unsaturated clayey soil. Int J Civil Eng. doi: 10.1007/s40999-016-0065-7 Google Scholar
  7. 7.
    Broere W, van Tol AF (2006) Modelling the bearing capacity of displacement piles in sand. Proc ICE Geotech Eng 159(3):195–206CrossRefGoogle Scholar
  8. 8.
    Said I, De Gennaro V, Frank R (2009) Axisymmetric finite element analysis of pile loading tests. Comput Geotech 36(1–2):6–19. doi: 10.1016/j.compgeo.2008.02.011 CrossRefGoogle Scholar
  9. 9.
    Abu-Farsakh MY, Voyiadjis GZ, Tumay MT (1998) Numerical analysis of the miniature piezocone penetration tests (PCPT) in cohesive soils. Int J Numer Anal Methods Geomech 22 (10):791–818. doi: 10.1002/(SICI)1096-9853(1998100)22:10<791::AID-NAG941>3.0.CO;2-6 CrossRefzbMATHGoogle Scholar
  10. 10.
    Sheng D, Eigenbrod KD, Wriggers P (2005) Finite element analysis of pile installation using large-slip frictional contact. Comput Geotech 32(1):17–26. doi: 10.1016/j.compgeo.2004.10.004 CrossRefGoogle Scholar
  11. 11.
    Hügel H, Henke S, Kinzler S (2008) High-performance Abaqus simulations in soil mechanics. In: Proceedings of Abaqus users conference, pp 192–205Google Scholar
  12. 12.
    Sheng D, Nazem M, Carter JP (2009) Some computational aspects for solving deep penetration problems in geomechanics. Comput Mech 44(4):549–561CrossRefzbMATHGoogle Scholar
  13. 13.
    Dijkstra J, Broere W, Heeres OM (2011) Numerical simulation of pile installation. Comput Geotech 38(5):612–622. doi: 10.1016/j.compgeo.2011.04.004 CrossRefGoogle Scholar
  14. 14.
    Dijkstra J, Broere W, van Tol AF (2009) Eulerian simulation of the installation process of a displacement pile. In: Contemporary topics in in situ testing, analysis, and reliability of foundations. American Society of Civil Engineers, Reston, pp 135–142Google Scholar
  15. 15.
    Qiu G, Henke S, Grabe J (2011) Application of a coupled Eulerian–Lagrangian approach on geomechanical problems involving large deformations. Comput Geotech 38(1):30–39CrossRefGoogle Scholar
  16. 16.
    Pucker T, Grabe J (2012) Numerical simulation of the installation process of full displacement piles. Comput Geotech 45(0):93–106. doi: 10.1016/j.compgeo.2012.05.006 CrossRefGoogle Scholar
  17. 17.
    Mahutka K, König F, Grabe J (2006) Numerical modelling of pile jacking, driving and vibratory driving. In: Triantafyllidis T (ed) Proceedings of the international conference on numerical modelling of construction processes in geotechnical engineering for urban environment, pp 235–246Google Scholar
  18. 18.
    Liyanapathirana D (2009) Arbitrary Lagrangian Eulerian based finite element analysis of cone penetration in soft clay. Comput Geotech 36(5):851–860CrossRefGoogle Scholar
  19. 19.
    Tolooiyan A, Gavin K (2011) Modelling the cone penetration test in sand using cavity expansion and arbitrary lagrangian eulerian finite element methods. Comput Geotech 38(4):482–490. doi: 10.1016/j.compgeo.2011.02.012 CrossRefGoogle Scholar
  20. 20.
    Abu-Farsakh M, Rosti F, Souri A (2015) Evaluating pile installation and subsequent thixotropic and consolidation effects on setup by numerical simulation for full-scale pile load tests. Can Geotech J 52(11):1734–1746 CrossRefGoogle Scholar
  21. 21.
    Rosti F, Abu- Farsakh M Numerical Simulation of Pile Installation and Setup for Bayou Lacassine Site. In: IFCEE 2015, 2015.Google Scholar
  22. 22.
    Elias MB (2008) Numerical simulation of pile installation and setup. Dissertation, The University of Wisconsin, Milwaukee, WIGoogle Scholar
  23. 23.
    Fakharian K, Attar I, Haddad H (2013) Contributing factors on setup and the effects on pile design parameter. In: Proceeding of the 18 th international conference on soil mechanics and geotechnical engineering. ParisGoogle Scholar
  24. 24.
    Kurup P, Voyiadjis G, Tumay M (1994) Calibration chamber studies of piezocone test in cohesive soils. J Geotech Eng 120(1):81–107CrossRefGoogle Scholar
  25. 25.
    Systèmes D (2012) Abaqus 6.12 User’s manual. Dessault Systémes Simulia Corp, Providence, USAGoogle Scholar
  26. 26.
    Tekeste M, Raper R, Tollner E, Way T (2007) Finite element analysis of cone penetration in soil for prediction of hardpan location. Trans ASABE 50(1):23–31CrossRefGoogle Scholar
  27. 27.
    Abu-Farsakh M, Tumay M, Voyiadjis G (2003) Numerical parametric study of piezocone penetration test in clays. Int J Geomech 3(2):170–181CrossRefGoogle Scholar
  28. 28.
    Ahmadi M, Robertson P (2008) A numerical study of chamber size and boundary E ects on CPT tip resistance in NC Sand. Scientia Iranica 15(5):541–553Google Scholar
  29. 29.
    O’Neill MW, Lecture) (2001) Side resistance in piles and drilled shafts. J Geotech Geoenviron Eng 127(1):3–16CrossRefGoogle Scholar
  30. 30.
    Yu-nong L, Jing-pei L (2009) Behavior of the penetration process of model jacked pile in layered soil. Electron J Geotech Eng 14(Bund. P):1–10Google Scholar
  31. 31.
    Society CG (2006) Canadian Foundation Engineering Manual. Can Geotech SocGoogle Scholar

Copyright information

© Iran University of Science and Technology 2017

Authors and Affiliations

  1. 1.Department of Civil and Environmental EngineeringAmirkabir University of TechnologyTehranIran

Personalised recommendations