Abstract
The driving characteristics of a vehicle, combined with a wind tunnel test and field measurement, can produce wind. This study proposes a transiting test method of building wind pressure under ideal road conditions via theoretical derivation and field testing. In this work, the basic theory of the transiting test was formulated, and the transiting test of a physical test platform was designed and assembled, and a software test system was established. The test data processing method was investigated and adopted for testing the mean wind pressure coefficient of the CAARC standard model’s typical measuring points. The influence of different speeds on the mean wind pressure coefficient was studied, and the difference of the mean wind pressure coefficient of repeated tests with the same speed was analyzed. Results showed the accuracy of the theoretical formula of the proposed transiting test, and the hardware and software systems were acceptable. The mean wind pressure coefficient of the typical measuring points of the standard model agreed well with the wind tunnel test results from relevant literature. Moreover, different speeds minimally affected the mean wind pressure coefficient. Thus, the technique is feasible under ideal road conditions. The transiting test method proposed in this study provides a new test technique for structural wind resistance research.
Similar content being viewed by others
References
Li QS, Xiao YQ, Wu JR, Fu JY, Li ZN (2008) Typhoon effects on super-tall buildings. J Sound Vib 313:581–602
Chen B, Wu T, Yang Y, Yang Q, Li Q, Kareem A (2016) Wind effects on a cable-suspended roof: full-scale measurements and wind tunnel based predictions. J Wind Eng Ind Aerodyn 155:159–173
Kikuchi K, Suzuki M (2015) Study of aerodynamic coefficients used to estimate critical wind speed for vehicle overturning. J Wind Eng Ind Aerodyn 147:1–17
Caracoglia L, Sangree RH, Jones NP, Schafer BW (2008) Interpretation of full-scale strain data from wind pressures on a low-rise structure. J Wind Eng Ind Aerodyn 96:2363–2382
Yi J, Li QS (2015) Wind tunnel and full-scale study of wind effects on a super-tall building. Journal of Fluids and Structures 58:236–253
Sohankar A (2006) Flow over a bluff body from moderate to high Reynolds numbers using large eddy simulation. Comput Fluids 35:1154–1168
Daniels SJ, Castro IP, Xie Z (2013) Peak loading and surface pressure fluctuations of a tall model building. J Wind Eng Ind Aerodyn 120:19–28
Braun AL, Awruch AM (2009) Aerodynamic and aeroelastic analyses on the CAARC standard tall building model using numerical simulation. Comput Struct 87:564–581
Li S, An Y, Wang C, Wang D (2017) Experimental and numerical studies on galloping of the flat-topped main cables for the long span suspension bridge during construction. J Wind Eng Ind Aerodyn 163:24–32
Zhang Y, Habashi WG, Khurram RA (2015) Predicting wind-induced vibrations of high-rise buildings using unsteady CFD and modal analysis. J Wind Eng Ind Aerodyn 136:165–179
Watakabe M, Ohashi M, Okada H (2002) Comparison of wind pressure measurements on tower-like structure obtained from full-scale observation, wind tunnel test, and the CFD technology. J Wind Eng Ind Aerodyn 90:1817–1829
Elshaer A, Aboshosha H, Bitsuamlak G, El Damatty A, Dagnew A (2016) LES evaluation of wind-induced responses for an isolated and a surrounded tall building. Eng Struct 115:179–195
Kim Y, Kanda J (2010) Characteristics of aerodynamic forces and pressures on square plan buildings with height variations. J Wind Eng Ind Aerodyn 98:449–465
Yu XF, Xie ZN, Zhu JB, Gu M (2015) Interference effects on wind pressure distribution between two high-rise buildings. J Wind Eng Ind Aerodyn 142:188–197
Kim YC, Yoshida A, Tamura Y (2012) Characteristics of surface wind pressures on low-rise building located among large group of surrounding buildings. Eng Struct 35:18–28
Kim YC, Kanda J (2013) Wind pressures on tapered and set-back tall buildings. Journal of Fluids and Structures 39:306–321
Gu M, Du XQ, Li SY (2009) Experimental and theoretical simulations on wind–rain-induced vibration of 3-D rigid stay cables. J Sound Vib 320:184–200
Lam KM, Li A (2009) Mode shape correction for wind-induced dynamic responses of tall buildings using time-domain computation and wind tunnel tests. J Sound Vib 322:740–755
An YH, Wang CQ, Li SL (2016) Galloping of steepled main cables in long-span suspension bridges during construction. Wind Struct 23:595–613
Páscoa JC, Brójo FP, Santos FC, Fael PO Fael (2012) An innovative experimental on-road testing method and its demonstration on a prototype vehicle. J Mech Sci Technol 26:1663–1670
Zaki SA, Hagishima A, Tanimoto J, Ikegaya N (2011) Aerodynamic parameters of urban building arrays with random geometries. Boundary-Layer Meteorol 138:99–120
Melbourne WH (1980) Comparison of measurements on the CAARC standard tall building model in simulated model wind flows. J Wind Eng Ind Aerodyn 6:73–78
Kwon K, Kim D, Kim R, Ha T, Lee I (2016) Evaluation of wind pressure coefficients of single-span greenhouses built on reclaimed coastall and using a large-sized wind tunnel. Biosyst Eng 141:58–81
Niu JQ, Zhou D, Liang XF (2017) Experimental research on the aerodynamic characteristics of a high-speed train under different turbulence conditions. Exp Thermal Fluid Sci 80:117–125
Tanaka H, Lawen N (1986) Test on the CAARC standard tall building model with a length scale of 1:1000. J Wind Eng Ind Aerodyn 15:15–29
Yang GF, Zhang KH, Han JJ (2011) Monitoring the cattle truck inside the wind and temperature change. Journal of Anhui Agricultural University 38:486–490
Tecle A, Bitsuamlak GT, Jiru TE (2013) Wind-driven natural ventilation in a low-rise building. A boundary layer wind tunnel study. Build Environ 59:275–289
Lim H, Tsukamoto K, Ohba M, Mizutani K (2014) Study on the surface pressure distribution of cubes in cross-wind arrays. J Wind Eng Ind Aerodyn 133:18–26
Siniu E, Scanlan RH (1996) Wind effects on structures. Third edition, Newyork: John Wiley &Sons, Inc, 156–157
Huang P, Gu M, Quan Y (2008) Wind tunnel test research on CAARC standard tall building model. Chinese Quarterly Of Mechanics 29:628–633
Acknowledgements
The authors are grateful for the financial support from the National Natural Science Foundation of China (51778587, 51808510), Natural Science Foundation of Henan Province of China (162300410255), Supported by Foundation for University Young Key Teacher by Henan Province (2017GGJS005), Outstanding Young Talent Research Fund of Zhengzhou University (1421322059) and Science and technology planning project of Transportation in Henan Province (2016Y2-2, 2018 J3).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Publisher’s Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Li, S., Liu, L., Wu, H. et al. New Test Method of Wind Pressure Coefficient Based on CAARC Standard Model Determined Using Vehicle Driving Wind. Exp Tech 43, 707–717 (2019). https://doi.org/10.1007/s40799-019-00330-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40799-019-00330-2