Abstract
In this study, we designed and fabricated a capacitive oil detector using a polydimethyl siloxane (PDMS) sponge and evaluated its performance. A PDMS sponge has a hydrophobic/oleophilic characteristic, which blocks water infiltration yet absorbs oil. The absorbed oil changes the detector capacitance between the two electrodes within the PDMS sponge. We used three primary types of marine fuel oils (diesel, crude oil, and heavy oil) to evaluate the performance of the fabricated oil detector. Diesel was detected in the shortest time, followed by crude oil and heavy oil. That is, oils with lower viscosity were detected more rapidly. The measured capacitance was the lowest for diesel and the highest for heavy oil. Oils with higher dielectric constants had a higher measured capacitance. Water did not seep into the microcavity of the capacitive oil detector until it reached a depth of 140 cm. We were able to detect the presence of an oil-film below 900 μm. The fabricated detector showed almost the same capacitance throughout the ten cycles of repeated cleaning and measurements.
Similar content being viewed by others
Abbreviations
- w:
-
Oil detector width
- h:
-
Oil detector height
- t:
-
Oil detector thickness
- d:
-
Pore diameter of PDMS sponge
- p:
-
Maximum allowable pressure
- γ:
-
Water surface tension
- ε 0 :
-
Permittivity of vacuum
- ε 1 :
-
Dielectric constant of the air or the absorbed oil
- ε 2 :
-
Dielectric constant of PDMS
- n:
-
Porosity (the proportion of pores in the sponge)
- g:
-
Distance between electrodes
- A:
-
Electrode area
References
Wang, Z. and Fingas, M., “Differentiation of the Source of Spilled Oil and Monitoring of the Oil Weathering Process Using Gas Chromatography-Mass Spectrometry,” Journal of Chromatography A, Vol. 712, No. 2, pp. 321–343, 1995.
MacLean, A., Moran, C., Johnstone, W., Culshaw, B., Marsh, D., et al., “Detection of Hydrocarbon Fuel Spills Using a Distributed Fibre Optic Sensor,” Sensors and Actuators A: Physical, Vol. 109, No. 1, pp. 60–67, 2003.
Brown, C. E. and Fingas, M. F., “Review of the Development of Laser Fluorosensors for Oil Spill Application,” Marine Pollution Bulletin, Vol. 47, No. 9, pp. 477–484, 2003.
Koo, J., Jung, J. Y., Lee, S., Lee, M., and Chang, J., “Development of Waterborne Oil Spill Sensor Based on Printed ITO Nanocrystals,” Marine Pollution Bulletin, Vol. 98, No. 1, pp. 130–136, 2015.
Yoon, Y. S., Kim, D. Y., and Lee, J. B., “Hierarchical Micro/Nano Structures for Super-Hydrophobic Surfaces and Super-Lyophobic Surface Against Liquid Metal,” Micro and Nano Systems Letters, Vol. 2, No. 3, p. 3, 2016.
Lee, J. M., Lee, S. H., Kim, Y. J., and Ko, J. S., “Effect of the Diffusion Rate of the Copper Ions on the Co-Electrodeposition of Copper and Nickel,” Int. J. Precis. Eng. Manuf., Vol. 14, No. 11, pp. 2009–2014, 2013.
Jung, K. K., Choi D. H., Jung, I. D., Lee, J. M., and Ko, J. S., “Capacitive Micro-Oil Detector with a Nanotextured Superhydrophobic/Superoleophilic Surface,” Sensors and Actuators B: Chemical, Vol. 237, pp. 974–983, 2016.
Choi, S. J., Kwon, T. H., Im, H., Moon, D. I., Baek, D. J., et al., “A Polydimethylsiloxane (PDMS) Sponge for the Selective Absorption of Oil from Water,” ACS Applied Materials & Interfaces, Vol. 3, No. 12, pp. 4552–4556, 2011.
Tran, D. N., Kabiri, S., Sim, T. R., and Losic, D., “Selective Adsorption of Oil-Water Mixtures Using Polydimethylsiloxane (PDMS)-Graphene Sponges,” Environmental Science: Water Research & Technology, Vol. 1, No. 3, pp. 298–305, 2015.
Nguyen, D. D., Tai, N. H., Lee, S. B., and Kuo, W. S., “Superhydrophobic and Superoleophilic Properties of Graphene-Based Sponges Fabricated Using a Facile Dip Coating Method,” Energy & Environmental Science, Vol. 5, pp. 7908–7912, 2012.
Wang, C. F. and Lin, S. J., “Robust Superhydrophobic / Superoleophilic Sponge for Effective Continuous Absorption and Expulsion of Oil Pollutants from Water,” ACS Applied Materials & Interfaces, Vol. 5, No. 18, pp. 8861–8864, 2013.
Johnson Jr, R. E. and Dettre, R. H., “Contact Angle Hysteresis. III. Study of an Idealized Heterogeneous Surface,” The Journal of Physical Chemistry, Vol. 68, No. 7, pp. 1744–1750, 1964.
Lee, S. M., Oh, D. J., Jung, I. D., Jung, P. G., Chung, K. H., et al., “Evaluation of the Waterproof Ability of a Hydrophobic Nickel Micromesh With Array-Type Microholes,” Journal of Micromechanics and Microengineering, Vol. 19, No. 12, Paper No. 125024, 2009.
Demori, M., Ferrari, V., Strazza, D., and Poesio, P., “A Capacitive Sensor System for the Analysis of Two-Phase Flows of Oil and Conductive Water,” Sensors and Actuators A: Physical, Vol. 163, No. 1, pp. 172–179, 2010.
Dow. Corning, Electronics Sylgard 184 Silicone Elastomer, Prod. Datasheet, pp. 1-3, 2013.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Jung, Y., Jung, K.K., Park, B.G. et al. Capacitive Oil Detector Using Hydrophobic and Oleophilic PDMS Sponge. Int. J. of Precis. Eng. and Manuf.-Green Tech. 5, 303–309 (2018). https://doi.org/10.1007/s40684-018-0032-7
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40684-018-0032-7