Skip to main content

Permanent Deformation Prediction Model of Unbound Granular Materials for Flexible Pavement Design

Abstract

Constitutive prediction models in flexible pavement are used to predict the permanent deformation (PD) of the unbound granular materials (UGMs). The most recent flexible pavement structural design guide in Australia does not consider the response of the UGMs layers as a design criterion. Additionally, it referred to the absence of an appropriate prediction model. The available prediction models have complex equations with many variables; the use of some of which has been found to be unsuitable in Australia. Thus, the aim of this study was to develop a new simple constitutive model based on an empirical regression equation, which has two predictor variables and four regression parameters. Repeated load triaxial test data covering many loading cycles and stages of stresses were used in order to validate the proposed model by calibration. The tested materials, specified by VicRoads as high-quality base and subbase crushed rocks, were used to prepare 46 samples with a range of moisture contents, gradations, densities, and stress conditions. Additional validation was conducted by predicting the PD response of recycled crushed concrete for different stress conditions. The proposed model excellently matches the experimental PDs with the sum of squared error less than 0.060 and R2 more than 0.96 over the tested matrix for both the crushed rocks and recycled concrete. This high prediction accuracy could lead to a better design of pavement materials and their thicknesses. A new update is proposed for the current Austroads flexible pavements design procedure by involving two more critical locations as performance criteria in the base and subbase layers based on the developed constitutive model. Adopting the proposed model can better generalise the design procedure to determine the accumulated vertical PD for the whole layer system.

This is a preview of subscription content, access via your institution.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7

References

  1. 1.

    Alnedawi, A., Nepal, K. P. and Al-Ameri, R.: A comparison study between basalt and granite crushed rocks under repeated traffic loads. The First MoHESR and HCED Iraqi Scholars Conference in Australasia. Melbourne, Australia (2017)

  2. 2.

    Alnedawi, A., Nepal, K.P., Al-Ameri, R.: Mechanistic behavior of open and dense graded unbound granular materials under traffic loads. International Journal of GEOMATE. 14, 124–129 (2018a)

    Article  Google Scholar 

  3. 3.

    Alnedawi, A., Nepal K. P., al-Ameri R., Alabdullah M.: Effect of vertical stress rest period on deformation behaviour of unbound granular materials: experimental and numerical investigations. J. Rock Mech. Geotech. Eng. (2018b)

  4. 4.

    Australian Standard: Soil Compaction and Density Tests-Determination of the Dry Density/Moisture Content Relation of a Soil Using Modified Compactive Effort. Sydney, Australia: Standards Australia (2003)

  5. 5.

    Austroads: Austroads repeated load triaxial test method: determination of permanent deformation and resilient modulus characteristics of unbound granular materials under drained conditions, AG-PT/T053. Austroads Publication, 1–29 (2007)

  6. 6.

    Austroads: Guide to pavement technology / part 2: pavement structural design. 100–102 (2017)

  7. 7.

    Azam, A.M., Cameron, D.A., Rahman, M.M.: Permanent strain of unsaturated unbound granular materials from construction and demolition waste. J. Mater. Civ. Eng. 27(3), 04014125 (2015)

    Article  Google Scholar 

  8. 8.

    Barksdale, R. D.: Laboratory evaluation of rutting in base course materials. ed. Presented at the Third International Conference on the Structural Design of Asphalt Pavements, Grosvenor House, Park Lane, London, England, Sept. 11-15, 1972., (1972)

  9. 9.

    Berthelot, C., Podborochynski, D., Marjerison, B., Gerbrandt, R.: Saskatchewan field case study of triaxial frequency sweep characterization to predict failure of a granular base across increasing fines content and traffic speed applications. J. Transp. Eng. 135(11), 907–914 (2009)

    Article  Google Scholar 

  10. 10.

    Erlingsson, S., Rahman, M.S.: Evaluation of permanent deformation characteristics of unbound granular materials by means of multistage repeated-load triaxial tests. Transp. Res. Rec. 2369, 11–19 (2013)

    Article  Google Scholar 

  11. 11.

    Gabr, A., Cameron, D.: Permanent strain modeling of recycled concrete aggregate for unbound pavement construction. J. Mater. Civ. Eng. 25(10), 1394–1402 (2012)

    Article  Google Scholar 

  12. 12.

    Gu, F., Zhang, Y., Droddy, C.V., Luo, R., Lytton, R.L.: Development of a new mechanistic empirical rutting model for unbound granular material. J. Mater. Civ. Eng. 28, 04016051 (2016)

    Article  Google Scholar 

  13. 13.

    Haider, I., Kaya, Z., Cetin, A., Hatipoglu, M., Cetin, B., Aydilek, A.H.: Drainage and mechanical behavior of highway base materials. J. Irrig. Drain. Eng. 140(6), 04014012 (2014)

    Article  Google Scholar 

  14. 14.

    Huurman, M.: Permanent deformation in concrete block pavements. Civil Engineering and Geosciences, PhD (1997)

  15. 15.

    Huvstig, A.: Model for the prediction of rutting in roads, a NordFoU result. Procedia Soc. Behav. Sci. 48, 2816–2826 (2012)

    Article  Google Scholar 

  16. 16.

    Korkiala-Tanttu, L.: A new material model for permanent deformations in pavements. ed. Proceedings of the 7th Conference on Bearing Capacity of Roads and Airfields, Trondheim, Norway (2005)

  17. 17.

    Koseki, J., Mikami, T., Sato, T.: Deformation characteristics of granular materials in cyclic one-dimensional loading tests. Transportation Infrastructure Geotechnology. 1(1), 54–67 (2014)

    Article  Google Scholar 

  18. 18.

    Leiva-Villacorta, F., Vargas-Nordcbeck, A., Aguiar-Moya, J.P.: Permanent deformation and deflection relationship from pavement condition assessment. International Journal of Pavement Research and Technology. 10(4), 352–359 (2017)

    Article  Google Scholar 

  19. 19.

    Lekarp, F., Isacsson, U., Dawson, A.: State of the art.II: permanent strain response of unbound aggregates. J. Transp. Eng. 126(1), 76–83 (2000)

    Article  Google Scholar 

  20. 20.

    Luo, X., Gu, F., Zhang, Y., Lytton, R.L., Zollinger, D.: Mechanistic-empirical models for better consideration of subgrade and unbound layers influence on pavement performance. Transportation Geotechnics. 13, 52–68 (2017)

    Article  Google Scholar 

  21. 21.

    Pratibha, R., Sivakumar Babu, G.L., Madhavi Latha, G.: Stress–strain response of unbound granular materials under static and cyclic loading. Indian Geotechnical Journal. 45(4), 449–457 (2015)

    Article  Google Scholar 

  22. 22.

    Qamhia, I.I.A., Chow, L.C., Mishra, D., Tutumluer, E.: Dense-graded aggregate base gradation influencing rutting model predictions. Transportation Geotechnics. 13, 43–51 (2017)

    Article  Google Scholar 

  23. 23.

    Qiao, Y., Dawson, A., Huvstig, A., Korkiala-Tanttu, L.: Calculating rutting of some thin flexible pavements from repeated load triaxial test data. International Journal of Pavement Engineering. 16(6), 467–476 (2015)

    Article  Google Scholar 

  24. 24.

    Rahman, M. S.: Characterising the deformation behaviour of unbound granular materials in pavement structures. TRITA-TSC-PHD (PhD) (2015)

  25. 25.

    Rahman, M.S., Erlingsson, S.: A model for predicting permanent deformation of unbound granular materials. Road Materials and Pavement Design. 16(3), 653–673 (2015a)

    Article  Google Scholar 

  26. 26.

    Rahman, M.S., Erlingsson, S.: Predicting permanent deformation behaviour of unbound granular materials. International Journal of Pavement Engineering. 16(7), 587–601 (2015b)

    Article  Google Scholar 

  27. 27.

    Rasul, J.M., Ghataora, G.S., Burrow, M.P.: The effect of wetting and drying on the performance of stabilized subgrade soils. Transportation Geotechnics. 14(1–7), 1–7 (2018)

    Article  Google Scholar 

  28. 28.

    Romanoschi, S.A.: Empirical models for permanent deformation of subgrade soils from the data collected at the pavement subgrade performance study. J. Mater. Civ. Eng. 29(3), 04016236 (2016)

    Article  Google Scholar 

  29. 29.

    Siripun, K., Jitsangiam, P., Nikraz, H.: Permanent deformation behaviour and model of crushed rock base. Aust. J. Civ. Eng. 8(1), 41–52 (2010)

    Article  Google Scholar 

  30. 30.

    Sweere, G. T. H., 1990. Unbound Granular Bases for Roads. Technische Universitiet Delft

  31. 31.

    Theyse, H., De Beer, M., Rust, F.: Overview of south African mechanistic pavement design method. Transportation Research Record: Journal of the Transportation Research Board. 1539, 6–17 (1996)

    Article  Google Scholar 

  32. 32.

    Tutumluer, E., Pan, T.: Aggregate morphology affecting strength and permanent deformation behavior of unbound aggregate materials. J. Mater. Civ. Eng. 20(9), 617–627 (2008)

    Article  Google Scholar 

  33. 33.

    VicRoads: Section 812 - Crushed Rock for Pavement Base and Subbase. Australia: Roads Corporation of Victoria (VicRoads), 13 (2011)

  34. 34.

    Werkmeister, S.: Permanent Deformation Behaviour of Unbound Granular Materials in Pavement Constructions (2003)

  35. 35.

    Werkmeister, S., Dawson, A.R., Wellner, F.: Permanent deformation behaviour of granular materials. Road Materials and Pavement Design. 6(1), 31–51 (2005)

    Article  Google Scholar 

  36. 36.

    Witczak, M. and Uzan, J.: The Universal Airport Design System, Report I of IV: Granular Material Characterization. Department of Civil Engineering, University of Maryland, College Park (1988)

  37. 37.

    Wolff, H. and Visser, A.: Incorporating elasto-plasticity in granular layer pavement design. ed. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts, 177A (1995)

  38. 38.

    Wu, Z. and Yang, X.: Evaluation of the MEPDG permanent deformation models in Louisiana conditions. GeoCongress 2012: State of the Art and Practice in Geotechnical Engineering. 1438–1447 (2012)

  39. 39.

    Xiao, Y., Tutumluer E., Qian Y., Siekmeier J. A.: Gradation effects influencing mechanical properties of aggregate base-granular subbase materials in Minnesota. Transportation Research Record: Journal of the Transportation Research Board, (2267), 14–26 (2012)

  40. 40.

    Xiao, Y., Tutumluer, E. and Siekmeier, J.: Resilient modulus behavior estimated from aggregate source properties. Geo-Frontiers 2011: Advances in Geotechnical Engineering. 4843–4852 (2011)

  41. 41.

    Yang, X., Han, J.: Analytical model for resilient modulus and permanent deformation of geosynthetic-reinforced unbound granular material. J. Geotech. Geoenviron. 139(9), 1443–1453 (2012)

    Article  Google Scholar 

Download references

Acknowledgments

The authors acknowledge the support of Ground Science South West Pty. Ltd. by providing the unbound granular materials in this study.

Author information

Affiliations

Authors

Corresponding author

Correspondence to Ali Alnedawi.

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Alnedawi, A., Nepal, K.P. & Al-Ameri, R. Permanent Deformation Prediction Model of Unbound Granular Materials for Flexible Pavement Design. Transp. Infrastruct. Geotech. 6, 39–55 (2019). https://doi.org/10.1007/s40515-018-00068-1

Download citation

Keywords

  • Flexible pavement
  • Unbound granular materials
  • Repeated load triaxial test
  • Permanent deformation
  • Constitutive models