# Design of spiral heat exchanger from economic and thermal point of view using a tuned wind-driven optimizer

- 76 Downloads
- 1 Citations

## Abstract

This paper presents an optimization of spiral heat exchangers by wind-driven optimization and a novel variant of this algorithm by the insertion of a statistic distribution to self-adapting of the evolution parameters of the algorithm. Spiral heat exchangers are the ideal type for cooling slurries and fluids that presents high viscosity and is very common in food and petrochemical industries. The variables used for the optimization were the spacing channels for hot and cold streams, the length, the width and the thickness of the heat exchanger. Two case studies were presented where the minimization of the cost and the maximization of the overall heat transfer coefficient were implemented. Reductions about 4.46 and 23% were obtained for the cost and increases about 18.8 and 16.4% were reached for the overall heat transfer coefficient for each case study in comparison to previous works. The proposed technique reached better results in all the simulations, in some cases with GA, but performed better accuracy among all the simulations.

## Keywords

Spiral heat exchanger Wind-driven optimization Minimization of total cost Maximization of overall heat transfer coefficient Optimization## Abbreviations

## List of symbols

- \(a_{1}\)
Numerical constant (€)

- \(a_{2}\)
Numerical constant (€ m

^{−2})- \(A\)
Heat exchanger surface area (m

^{2})*B*Width of spiral heat exchanger (m)

- \(C\)
Core diameter (m)

- \(C_{\text{e}}\)
Energy cost (€ W

^{−1}h^{−1})- \(C_{\text{i}}\)
Capital investment (€)

- \(C_{\text{o}}\)
Annual operating cost (€ year

^{−1})- \(C_{\text{od}}\)
Total discounted operating cost (€)

- \({\text{cp}}\)
Specific heat (J kg

^{−1}K^{−1})- \(C_{\text{tot}}\)
Total cost (€)

- \({\text{Dh}}\)
Hydraulic diameter (m)

- \(D_{\text{s}}\)
Spiral outer diameter (m)

- \(H_{\text{w}}\)
Amount of hours of work (h year

^{−1})- \(h\)
Convective coefficient (W m

^{−2}K^{−1})- \(i\)
Annual discount rate (%)

- \(k\)
Thermal conductivity (W m

^{−1}K^{−1})- \(k_{\text{p}}\)
Thermal conductivity of the wall (W m

^{−1}K^{−1})- \(L\)
Tube of spiral heat exchanger (m)

- \(\Delta T_{\text{LM}}\)
Logarithmic mean temperature difference (K)

- \(\dot{m}\)
Mass flow rate (kg s

^{−1})- \(Nu\)
Nusselt number

- \({\text{ny}}\)
Equipment life (yr)

- \(P_{r}\)
Prandtl number

- \(Q\)
Heat duty (W)

- \(R_{\text{m}}\)
Spiral mean diameter (m)

- \(R_{ \hbox{min} }\)
Spiral minimum diameter (m)

- \(R_{ \hbox{max} }\)
Spiral maximum diameter (m)

- \(Re\)
Reynolds number

- \({\text{Rf}}\)
Fouling resistance (m

^{2}K W^{−1})- \(S\)
Channel spacing (m)

- \(T\)
Temperature (K)

- \(U\)
Overall heat transfer coefficient (W m

^{−2}K^{−1})- \(v\)
Fluid velocity (m s

^{−1})- \(\Delta P\)
Pressure drop (kPa)

- \(\Delta P_{ \hbox{max} }\)
Maximum pressure drop (kPa)

## Greek letters

- \(\alpha_{1,2}\)
Numerical constants

- \(\mu\)
Viscosity (Pa s)

- \(\mu_{\text{c}}\)
Consistency viscosity (cP)

- \(\tau_{0}\)
Yield stress (Pa)

- \(\rho\)
Density (kg m

^{−3})- \(\eta\)
Pumping efficiency

## Subscripts

- \(c\)
Cold stream

- \(h\)
Hot stream

*i*Inlet

*o*Outlet

## Notes

### Acknowledgements

The authors would like to thank the National Council of Scientific and Technologic Development of Brazil-CNPq (projects: 303906/2015-4-PQ and 303908/2015-7-PQ) and Paraná Association of Culture-APC for the scholarship financial support of this work.

## References

- 1.Turgut OE, Çoban MT (2017) Thermal design of spiral heat exchangers and heat pipes through global best algorithm. Heat Mass Transfer 53:899–916CrossRefGoogle Scholar
- 2.Vahdat A, Amidpour M (2011) Economic optimization of shell-and-tube heat exchanger based on constructal theory. Energy 36:1087–1096CrossRefGoogle Scholar
- 3.Wilhelmson B (2005) Consider spiral heat exchangers for fouling application. Hydrocarb Process 84:81–83Google Scholar
- 4.Trom L (1995) Use spiral plate exchangers for various applications. Hydrocarb Process 74:73–81Google Scholar
- 5.Bes T, Roetzel W (1992) Distribution of heat flux density in spiral heat exchangers. Int J Heat Mass Transf 35:1331–1347CrossRefGoogle Scholar
- 6.Egner MW, Burmeister LC (2005) Heat transfer for laminar flow in spiral ducts of rectangular cross section. J Heat Transfer 127:352–356CrossRefGoogle Scholar
- 7.Wu SY, Yuan XF, Li YR, Xiao L (2007) Exergy transfer effectiveness on heat exchanger for finite pressure drop. Energy 32:2110–2120CrossRefGoogle Scholar
- 8.Picon-Núnez M, Canizalez-Davalos L, Martínez-Rodríguez G, Polley GT (2007) Shortcut design approach for spiral heat exchangers. Food Bioprod Process 85:322–327CrossRefGoogle Scholar
- 9.Picon-Núnez M, Canizalez-Davalos L, Medina-Flores JM (2009) Alternative sizing methodology for compact heat exchangers of spiral type. Heat Transfer Eng 30:744–750CrossRefGoogle Scholar
- 10.Naphon P, Wongwises S (2002) An experimental study on the in-tube convective heat transfer coefficient in a spiral coil heat exchanger. Int Commun Heat Mass Transfer 29:797–809CrossRefGoogle Scholar
- 11.Caputo AC, Pelagagge PM, Salini P (2008) Heat exchanger design based on economic optimization. Appl Therm Eng 28:1151–1159CrossRefGoogle Scholar
- 12.Bidabadi M, Sadaghiani AK, Vadhat Azad A (2013) Spiral heat exchanger optimization using genetic algorithm. Sci Iran B 20:1445–1454Google Scholar
- 13.Abdous MA, Saffari H, Avval HB, Khoshzat M (2015) Investigation of entropy generation in a helically coiled tube in flow boiling condition under a constant heat flux. Int J Refrig 60:217–233CrossRefGoogle Scholar
- 14.Nabil BH, Bechir C, Slimane G (2014) Global modeling of heat and mass transfers in spiral tubular absorver of a water-lithium bromide absorption chiller. Int J Refrig 38:323–332CrossRefGoogle Scholar
- 15.Eldeeb R, Aute V, Radermacher R (2016) A survey of correlations for heat transfer and pressure drop for evaporation and condensation in plate heat exchangers. Int J Refrig 65:12–26CrossRefGoogle Scholar
- 16.Selbas R, Kizilkan O, Reppich M (2006) A new design approach for shell-and-tube heat exchangers using genetic algorithms from economic point of view. Chem Eng Process 45:268–275CrossRefGoogle Scholar
- 17.Mishra M, Das PK, Sarangi S (2009) Second law based optimisation of crossflow plate-fin heat exchanger design using genetic algorithm. Appl Therm Eng 29:2983–2989CrossRefGoogle Scholar
- 18.Hajabdollahi H, Ahmadi P, Dincer I (2011) Thermoeconomic optimization of a shell-and-tube condenser using both genetic algorithm and particle swarm. Int J Refrig 34:1066–1076CrossRefGoogle Scholar
- 19.Amini M, Bazargan M (2014) Two objective optimization in shell-and-tube heat exchangers using genetic algorithm. Appl Therm Eng 69:278–285CrossRefGoogle Scholar
- 20.Babu BV, Munawar SA (2007) Differential evolution strategies for optimal design of shell-and-tube heat exchangers. Chem Eng Sci 62:3720–3739CrossRefGoogle Scholar
- 21.Vasconcelos Segundo EH, Amoroso AL, Mariani VC, Coelho LS (2017) Economic optimization design for shell-and-tube heat exchangers by a Tsallis differential evolution. Appl Therm Eng 111:143–151CrossRefGoogle Scholar
- 22.Vasconcelos Segundo EH, Amoroso AL, Mariani VC, Coelho LS (2017) Thermodynamic optimization design of plate-fin heat exchangers by Tsallis JADE. Int J Therm Sci 113:136–144CrossRefGoogle Scholar
- 23.Patel VK, Rao RV (2010) Design optimization of shell-and-tube heat exchanger using particle swarm optimization technique. Appl Therm Eng 30:1417–1425CrossRefGoogle Scholar
- 24.Rao RV, Patel VK (2010) Thermodynamic optimization of cross flow plate-fin heat exchangers using a particle swarm optimization. Int J Therm Sci 49:1712–1721CrossRefGoogle Scholar
- 25.Moretta AA (2010) Spiral plate heat exchangers: sizing units for cooling non-newtonian slurries. Chem Eng 117:44–49Google Scholar
- 26.Minton PE (1970) Designing spiral plate heat exchangers. Chem Eng 77:103–112Google Scholar
- 27.Morimoto E, Hotta K (1988) Study of the geometric structure and heat transfer characteristics of a spiral plate heat exchanger. Heat Transfer Japanese Res 17:53–71Google Scholar
- 28.Perry JH (1997) Chemical Engineers Handbook, 7th edn. McGraw-Hill, New YorkGoogle Scholar
- 29.Holland JH (1992) Adaptation in natural and artificial systems, 2nd edn. MIT Press, CambridgeGoogle Scholar
- 30.McClorke DS, Bryden KM, Carmichael CG (2003) A new methodology for evolutionary optimization of energy systems. Comput Methods Appl Mech Eng 192:5021–5036CrossRefzbMATHGoogle Scholar
- 31.Ponce-Ortega JM, Serna-González M, Jiménez-Gutiérrez A (2008) Synthesis of multipass heat exchangers networks using genetic algorithms. Comput Chem Eng 32:2320–2332CrossRefGoogle Scholar
- 32.Harris SD, Elliott L, Ingham DB, Pourkahanian M, Wilson CW (2000) The optimisation of reaction rate parameters for chemical kinetic modelling of combustion using genetic algorithms. Comput Methods Appl Mech Eng 190:1065–1090CrossRefzbMATHGoogle Scholar
- 33.Gholizadeh S, Salajegheh E (2009) Optimal design of structures subjected to time history loading by swarm intelligence and an advanced metamodel. Comput Methods Appl Mech Eng 198:2936–2949CrossRefzbMATHGoogle Scholar
- 34.Shokrian M, High KA (2014) Application of a multi objective multi-leader swarm optimization algorithm on NLP and MINLP problems. Comput Chem Eng 60:57–75CrossRefGoogle Scholar
- 35.Kennedy J, Eberhart R (1995) Particle Swarm Optimization. In: Proceedings of the IEEE International Conference on Neural Networks, Perth, Australia, 1942–1948Google Scholar
- 36.Bayraktar Z, Komurcu M, Werner DH (2010) Wind driven optimization (WDO): A novel nature-inspired optimization algorithm and its application to electromagnetic. In: Proceedings of the IEEE International Symposium on Antennas and Propagation and CNC/USNC/URSI Radio Science Meeting, Toronto, Canada, 1-4Google Scholar
- 37.Bayraktar Z, Komurcu M, Bossard JA, Werner DH (2013) The wind driven optimization technique and its application in electromagnetics. IEEE Trans Antennas Propag 61:2745–2757MathSciNetCrossRefzbMATHGoogle Scholar
- 38.Stull RB (1999) Meteorology for scientists and engineers, 2nd edn. Brooks/Cole, Belmont, USAGoogle Scholar
- 39.Tsallis C (1988) Possible generalization of Boltzmann-Gibbs statistics. J Stat Phys 52:479–487MathSciNetCrossRefzbMATHGoogle Scholar
- 40.Boulesnane A, Meshoul S (2014) A new multi-region modified wind driven optimization algorithm with collision avoidance for dynamic environments. In: Tan Y, Shi Y, Coello CAC (eds) Advances in swarm intelligence. Lecture notes in computer science, vol 8795. Springer, Cham, pp 412–421Google Scholar
- 41.Bao Z, Zhou Y, Li L, Ma M (2015) A hybrid global optimization algorithm based on wind driven optimization and differential evolution. Math Probl Eng 2015:1–20Google Scholar
- 42.Bayraktar Z, Komurcu M (2015) Adaptive Wind Driven Optimization. In: Proceedings of the 9th EAI International Conference on Bio-Inspired Information and Communications Technologies, New York, USA, pp 124–127Google Scholar