Numerical investigation of hot ultrasonic assisted turning of aviation alloys
- 246 Downloads
Aviation alloys exhibit superior properties such as high-strength-to-weight ratio and corrosion resistance but these alloys possess poor machinability. To overcome this disadvantage, new machining methods (Ultrasonic assisted machining, hot machining, etc.) are developed. Hot ultrasonic assisted turning (HUAT) is a new hybrid machining method which changes the cutting system between tool and workpiece, therefore, reduced cutting forces and better surface finish for workpiece are obtained. In this study, 2D finite element (FE) analysis is carried out to investigate the effects of these machining methods on titanium and Hastelloy-X alloys in terms of cutting forces, cutting tool temperatures and effective stresses. DEFORM-2D software is used during analyses. In addition, an experimental study is conducted to verify numerical results. During verification, cutting tool temperature is taken into consideration. It is confirmed that HUAT technique reduces cutting forces and effective stress significantly but cutting temperature increases compared to conventional and ultrasonic assisted turning.
KeywordsFinite element modeling Hot ultrasonic assisted machining Titanium alloys Ultrasonic assisted machining Hot machining Hastelloy-X
This work was financially supported by the Scientific and Technological Research Council of Turkey (TÜBİTAK Project #215M382) and the Research Fund of Eskişehir Osmangazi University (ESOGU BAP Project #2016-1086). M.A.Sofuoğlu acknowledges the support of TÜBİTAK under program 2228.
- 1.Kukkala V (2012) Experimental study and optimization of the machining parameters in ultrasonic vibration assisted turning (UVT). Master Thesis, Department of Mechanical Engineering, National Institute of Technology, RourkelaGoogle Scholar
- 2.Palacios JA, Olvera D, Urbikain G, Elías-Zúñiga A, Martínez-Romero O, López de Lacalle LN, Rodríguez C, Martínez-Alfaro H (2018) Combination of simulated annealing and pseudo spectral methods for the optimum removal rate in turning operations of nickel-based alloys. Adv Eng Softw 115:391–397CrossRefGoogle Scholar
- 8.Lacelle LN, Lamikiz LN, Celeya A (2002) Simulation of plasma assisted milling of heat resistant alloys. Int J Simul Model 1(1):5–15Google Scholar
- 12.Maurotto A, Muhammad R, Roy, Silberschmidt VV (2010) Recent developments in ultrasonically assisted machining of advanced alloys”. In: 4th CIRP conference on high performance cutting. GifuGoogle Scholar
- 17.Brehl DE, Dow TA, Garrard KP, Sohn A (2006) Microstructure fabrication using elliptical vibration-assisted machining. Proc ASPE 39:511–514Google Scholar
- 21.Tilghman BC 1889. Cutting metal by electricity. US416873 A. http://www.google.com.tr/patents/US416873. Accessed 15 Aug 2017
- 22.Armstrong ET, Cosler AS, Katz EF (1951) Machining of heated metals. ASME 35:73Google Scholar
- 29.Özel T, Sima M, Srivastava AK (2010) Finite element simulation of high speed machining Ti-6Al-4V alloy using modified material models. Trans NAMRI/SME 38:49–56Google Scholar