Abstract
This paper presents a study on the influence of pre-pulse process by spot weld bonding of asymmetric three-sheet steel stack-ups. Two types of stack-ups were examined, consisting a combination of low carbon steel (DX51—1.0226) and ultra-high-strength steel (22MnB5—1.5528). Weld bonding of asymmetric stack-ups results in particular challenges. By using standard parameters, the effective welding current range is reduced. This is primarily due to the increased contact resistance caused by the adhesive application and the associated change in process behavior. The use of adjusted parameters has made it possible to increase process stability and thus the welding current range. The selected pre-pulse allows the conditioning of the adhesive-bonded stack-ups. In addition to the evaluation of the specific welding current ranges, investigations were also carried out using static resistance measurement and on-line measurement to evaluate the electrical energy during welding.
Similar content being viewed by others
References
Kerl H(2018) Ein Beitrag zur Standmengenerhöhung der Elektrodenkappen beim Widerstandspunktschweißen, Dissertation, Clausthal University of Technology, Shaker
ISO 18278-3 (2017) Resistance welding—weldability—part 3: evaluation procedures for weldability in spot weld bonding, Norm. Beuth
Schmid G, Korte M and Walther U (2001) Punktschweißkleben im Automobilbau, Report. DVS
E SEP 1220-2, Prüf- und Dokumentationsrichtlinie für die Fügeeignung von Feinblechen aus Stahl – Teil 2: Widerstandspunktschweißen, Guideline, 2010
Marya M and Gayden XQ (2005) Development of requirements for resistance spot welding dual-phase (DP600) steels: part 1—the causes of interfacial fracture, Report, Welding Research
Weber G and Göklü S (2006) Resistance spot welding of uncoated and zinc coated advanced high strength steels (AHSS)—weldability and process reliability—influence of welding parameters, Report, Welding in the World 50
Wesling D-PV, Rekersdrees T, Keitel S, Winkler R and Schreiber S (2004) Untersuchungen zum Widerstandspunktschweißen von neu entwickelten Feinblechen aus höher und höchst festen Stählen, Report, Schweißen und Schneiden 56
DVS 2920 (2000) Widerstandspunkt-, Buckel- und Rollnahtschweißen von Stahlfeinblechen bis 3 mm mit metallischen Überzügen, Guideline. DVS
Dilthey U (2006) Schweißtechnische Fertigungsverfahren 1. Springer
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher’s note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Recommended for publication by Commission III - Resistance Welding, Solid State Welding, and Allied Joining Process
Rights and permissions
About this article
Cite this article
Brechelt, S., Wiche, H. & Wesling, V. Influence of pre-pulse in spot weld bonding of three-sheet steel stack-up. Weld World 63, 771–782 (2019). https://doi.org/10.1007/s40194-019-00706-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40194-019-00706-3