# Modified Analytical Technique for Block Toppling Failure of Rock Slopes with Counter-Tilted Failure Surface

- 65 Downloads

## Abstract

A broad mathematical technique for evaluating rock slope stability subjected to toppling of rock columns centered on limit equilibrium is presented. In the current analytical models for evaluating toppling of rock columns for the rock slopes, a single weak plane angle is assumed, running from the top surface of the slope and daylights on the toe of the slope. However, in some physical rock slopes, there exists counter-tilted failure surface within the rock masses of the rock slope and the weak plane may not daylight on the predictable point on the face of the slope following the assumed single weak plane angle. Therefore, applying the current analytical techniques in such conditions may not yield realistic results. A searching technique for estimating angles of counter-tilted failure surface is proposed and incorporated into the existing mathematical technique for evaluating toppling of rock columns centering on limit equilibrium principles. The physical slope with counter-tilted failure surface was comprehensively analyzed using the modified mathematical method and results were validated by numerical simulation using 3DEC 4.1 discrete element method. The influences of relative angles of the counter-tilted failure surfaces on the slope stability have been studied and the results show that, progressive increase of the counter-tilted failure surface angles lead to gradual increase in slope instability. The modified analytical method optimizes and combines the advantages of the traditional analytical techniques and could provide precise analytical method for evaluating stability of rock slopes with counter-tilted planar failure surfaces subjected to toppling of rock columns.

## Keywords

Toppling Counter-tilted weak plane Analytical method Discrete element method Failure mode## Notes

### Acknowledgements

This paper was supported by the National Natural Science Foundation of China, Project No. 51374163.

## References

- 1.Alejano LR, Gómez Márquez I, Pons B, Bastante FG, Alonso E (2006) Stability analysis of a potentially toppling over-tilted slope in granite. In: 4th Asian rock mechanics symposium, Singapore, 2006, pp 519–532Google Scholar
- 2.Alejano LR, Gómez Márquez I, Martinez-Algeria R (2010) Analysis of a complex toppling-circular slope failure. Eng Geol 114(1):93–104CrossRefGoogle Scholar
- 3.Amini M, Majdi A, Veshadi MA (2012) Stability analyses of rock slopes against block-flexure toppling failure. Int J Rock Mech Rock Eng 45(4):519–532CrossRefGoogle Scholar
- 4.Adhikary DP, Dyskin AV, Jewell RJ, Stewart DP (1997) A study of the mechanism of flexural-toppling failure of rock slopes. Rock Mech Rock Eng 30:75–93CrossRefGoogle Scholar
- 5.Mohtarami E, Jafari A, Amini M (2014) Stability analyses of slopes against combined toppling failure. Int J Rock Mech Min Sci 67(1):43–45Google Scholar
- 6.De Freitas MH, Watters RJ (1973) Some field examples of toppling failure. Int J Rock Mech Min Sci 43:55–56Google Scholar
- 7.Wyllie DC (1980) Toppling rock slope failure examples of analyses and stabilizations. Rock Mech 13:89–98CrossRefGoogle Scholar
- 8.Goodman RE, Bray JW (1976) Toppling of rock slopes. In: Boulder CO (ed) Proceedings of the specialty conference on rock engineering for foundation and slopes. American Society of Civil Engineers, New York, 15–18 August, 1976, pp 201–123Google Scholar
- 9.Zanbak C (1983) Design charts for rock slopes susceptible to toppling. J Geotech Eng 109(1):1039–1062CrossRefGoogle Scholar
- 10.Cruden DM (1989) Limits to common toppling. Can Geotech J 26:737–742CrossRefGoogle Scholar
- 11.Aydan O, Shimizu Y, Ichikawa Y (1989) The effective failure modes and stability of slopes in rockmass with two discontinuity sets. Rock Mech Rock Eng 22(3):163–188CrossRefGoogle Scholar
- 12.Wyllie DC (1999) Foundations on rock, 2nd edn. Taylor and Francis, London, p 401Google Scholar
- 13.Amini M, Majdi A (2011) Analysis of geo-structural defects in flexural toppling failure. Int J Rock Mech Min Sci 48:175–186CrossRefGoogle Scholar
- 14.Bobet A (1999) Analytical solutions for toppling failure. Int J Rock Mech Min Sci 36(1):971–980CrossRefGoogle Scholar
- 15.Sagaseta C, Sánchez JM, Can’izal J (2001) A general analytical solution for the required anchor force in rock slopes with toppling failure. Int J Rock Mech Min Sci 38(1):421–435CrossRefGoogle Scholar
- 16.Liu CH, Jaksa MB, Meyers AG (2008) Analytical approaches for toppling stability analyses of rock slopes. Int J Rock Mech Min Sci 45(1):1361–1372CrossRefGoogle Scholar
- 17.Liu CH, Jaksa MB, Meyers AG (2009) A transfer coefficient method for rock slope toppling. Can Geotech J 46(1):1–9CrossRefGoogle Scholar
- 18.Liu CH, Jaksa MB, Meyers AG (2010) Toppling mechanisms of rock slopes considering stabilization from the underlying rockmass. Int J Rock Mech Min Sci 71(1):1–11Google Scholar
- 19.Babiker AFA, Smith CC, Gilbert M, Ashby JP (2014) Non associative limit analysis of the toppling-sliding failure of rock slopes. Int J Rock Mech Min Sci 71:1–11Google Scholar
- 20.Tatone BSA, Grasselli G (2010) ROCKTOPPLE: a spreadsheet-based program for probabilistic block toppling analyses. Comput Geosci 36(1):98–114CrossRefGoogle Scholar
- 21.Chen C, Zheng Y, Sun C (2016) An analytical approach on Flexural toppling failure of counter-tilt slopes of layered rock. Chin J Rock Mech Eng 34(2):505–511Google Scholar
- 22.Zheng Y, Chen C, Liu T, Xia K, Liu X (2017) Stability analysis of rock slopes against sliding or flexural-toppling failure. Bull Eng Geol Environ 2017:1435–9529Google Scholar
- 23.Aydan O, Kawamoto T (1992) Stability of slopes and underground openings against flexural toppling and their stabilization. Rock Mech Rock Eng 1992:143–165CrossRefGoogle Scholar
- 24.Zuo BC, Chen CX, Lie XW, Shen Q (2005) Modeling experiment study on failure mechanism of counter-tilt rock slope. Chin J Rock Mech Eng 34:3505–3511Google Scholar
- 25.Cai JS (2013) Mechanism research of toppling deformation for homogeneous equal thickness anti-dip layered rock slopes. MSc thesis, China University of Geosciences, BeijingGoogle Scholar
- 26.Pritchard MA, Savigny KW (1990) Numerical modeling of toppling. Can Geotech J 27:823–834CrossRefGoogle Scholar
- 27.Pritchard MA, Savigny KW (1991) The heather hill landslide: an example of a large scale toppling failure in a natural slope. Can Geotech J 28:410–422CrossRefGoogle Scholar
- 28.Itasca (2008) Three dimensional distinct element codes 3DEC 4.1. Itasca Consulting Group Inc, MinneapolisGoogle Scholar